Searched full:starting (Results 1 – 25 of 26) sorted by relevance
12
10 printf("starting test\n\n"); in main()19 printf("starting 5-level paging test.\n\n"); in main()
32 printf("Starting IDT test\n"); in main()
41 printf("starting sieve\n"); in main()
425 printf("Starting Hyper-V SynIC timers tests: message mode\n"); in stimer_test_all()434 printf("Starting Hyper-V SynIC timers tests: direct mode\n"); in stimer_test_all()
215 * before starting the final walk of the guest page. in __svm_npt_rsvd_bits_test()
545 printf("starting broadcast (%s)\n", enable_x2apic() ? "x2apic" : "xapic"); in test_physical_broadcast()598 printf("starting apic change mode\n"); in test_apic_change_mode()
53 * @start starting address whose protection bits are to be changed62 * @start starting address whose protection bits are to be changed
48 * but keeping the starting address the same means less code.
263 * starting at 0x4000, using the same split. in is_event_supported()
191 * SCCBs all over the two pages starting at absolute address 0, thus in test_sccb_prefix()
93 report_fail("Starting CCW chain"); in test_sense()
32 * addr: starting virtual address of the region
36 * addr: starting virtual address of the region
29 * Create a contiguous bitmask starting at bit position @l and ending at
50 * register starting from the PCI_BASE_ADDRESS_0 offset.
86 * Splits the free block starting at addr into 2 blocks of half the size.149 /* we need the bigger of the two as starting point */ in page_memalign_order()
53 # starting address
536 * @nodeoffset: structure block offset of the starting node1236 * starting from the given index, and using only the first characters
3331 # Check for lines starting with a #3334 "Commit log lines starting with '#' are dropped by git as comments\n" . $herecurr) &&4034 $prevrawline =~ /^\+.*?\/\*/ && #starting /*4128 # not starting a section or a macro "\" extended line4404 # starting at the end of the conditional, so remove:6017 …"Macros starting with if should be enclosed by a do - while loop to avoid possible if/else logic d…
1597 # (but ignore ones starting with # as these are not parameters