/linux/drivers/bus/ |
H A D | ts-nbus.c | 35 struct gpio_desc *rdy; member 71 ts_nbus->rdy = devm_gpiod_get(&pdev->dev, "ts,rdy", GPIOD_IN); in ts_nbus_init_pdata() 72 if (IS_ERR(ts_nbus->rdy)) in ts_nbus_init_pdata() 73 return dev_err_probe(&pdev->dev, PTR_ERR(ts_nbus->rdy), in ts_nbus_init_pdata() 74 "failed to retrieve ts,rdy-gpio from dts\n"); in ts_nbus_init_pdata() 221 ret = gpiod_get_value_cansleep(ts_nbus->rdy); in ts_nbus_read() 256 while (gpiod_get_value_cansleep(ts_nbus->rdy) != 0) { in ts_nbus_write()
|
/linux/drivers/mtd/nand/raw/ |
H A D | gpio.c | 39 struct gpio_desc *rdy; member 124 if (!gpiomtd->rdy) in gpio_nand_exec_instr() 127 return nand_gpio_waitrdy(chip, gpiomtd->rdy, in gpio_nand_exec_instr() 342 gpiomtd->rdy = devm_gpiod_get_optional(dev, "rdy", GPIOD_IN); in gpio_nand_probe() 343 if (IS_ERR(gpiomtd->rdy)) { in gpio_nand_probe() 344 ret = PTR_ERR(gpiomtd->rdy); in gpio_nand_probe()
|
H A D | lpc32xx_slc.c | 298 int rdy = 0; in lpc32xx_nand_device_ready() local 301 rdy = 1; in lpc32xx_nand_device_ready() 303 return rdy; in lpc32xx_nand_device_ready()
|
/linux/Documentation/devicetree/bindings/bus/ |
H A D | ts-nbus.txt | 16 - ts,rdy-gpios : The GPIO pin connected to the rdy line on the FPGA 43 ts,rdy-gpios = <&gpio0 21 GPIO_ACTIVE_HIGH>;
|
H A D | nvidia,tegra20-gmi.txt | 45 - nvidia,snor-rdy-active-before-data: Assert RDY signal one cycle before data. 47 - nvidia,snor-rdy-active-high: RDY signal is active high
|
/linux/drivers/scsi/aic7xxx/ |
H A D | aic7xxx_93cx6.c | 95 #define CLOCK_PULSE(sd, rdy) \ argument 96 while ((SEEPROM_STATUS_INB(sd) & rdy) == 0) { \
|
/linux/drivers/input/touchscreen/ |
H A D | wacom_w8001.c | 60 u8 rdy; member 111 coord->rdy = data[0] & 0x20; in parse_pen_data() 219 * We have 1 bit for proximity (rdy) and 3 bits for tip, side, in report_pen_events() 220 * side2/eraser. If rdy && f2 are set, this can be either pen + side2, in report_pen_events() 256 input_report_key(dev, w8001->type, coord->rdy); in report_pen_events() 259 if (!coord->rdy) in report_pen_events()
|
/linux/Documentation/devicetree/bindings/phy/ |
H A D | phy-miphy28lp.txt | 34 - st,osc-rdy : to check the MIPHY0_OSC_RDY status in the glue-logic. This 65 st,osc-rdy;
|
/linux/Documentation/devicetree/bindings/pinctrl/ |
H A D | lantiq,pinctrl-xway.txt | 67 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd, 79 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd, 94 nand rdy, nand rd, nand_d0, nand_d1, nand_d2, nand_d3, nand_d4, nand_d5,
|
/linux/arch/mips/boot/dts/ni/ |
H A D | 169445.dts | 67 gpios = <&gpio2 0 0>, /* rdy */
|
/linux/arch/arm/boot/dts/st/ |
H A D | stih418-b2199.dts | 43 st,osc-rdy;
|
H A D | stihxxx-b2120.dtsi | 77 st,osc-rdy;
|
/linux/drivers/crypto/amcc/ |
H A D | crypto4xx_reg_def.h | 231 u32 rdy:1; member
|
H A D | crypto4xx_core.c | 858 sd->ctl.rdy = 1; in crypto4xx_build_pd() 869 sd->ctl.rdy = 1; in crypto4xx_build_pd()
|
/linux/Documentation/devicetree/bindings/mtd/ |
H A D | atmel-nand.txt | 173 gpios = <&pioC 13 0 /* rdy */ 200 gpios = <&pioD 5 0 /* rdy */
|
/linux/drivers/scsi/be2iscsi/ |
H A D | be_cmds.c | 1617 u32 loop, post, rdy = 0; in beiscsi_check_fw_rdy() local 1625 rdy = 1; in beiscsi_check_fw_rdy() 1631 if (!rdy) { in beiscsi_check_fw_rdy() 1636 return rdy; in beiscsi_check_fw_rdy() 1709 /* clear all error states after checking FW rdy */ in beiscsi_init_sliport()
|
/linux/drivers/scsi/hisi_sas/ |
H A D | hisi_sas.h | 673 extern void hisi_sas_phy_down(struct hisi_hba *hisi_hba, int phy_no, int rdy,
|
H A D | hisi_sas_v3_hw.c | 1757 int rdy = phy_state & (1 << phy_no); in int_phy_up_down_bcast_v3_hw() local 1759 if (rdy) { in int_phy_up_down_bcast_v3_hw()
|
/linux/drivers/net/wireless/realtek/rtw89/ |
H A D | rtw8922a.c | 1550 u32 rdy = 0; in rtw8922a_bb_preinit() local 1553 rdy = 1; in rtw8922a_bb_preinit() 1559 rtw89_write32_mask(rtwdev, R_BE_FEN_RST_ENABLE, mcu_bootrdy_mask[phy_idx], rdy); in rtw8922a_bb_preinit()
|
/linux/arch/arm/boot/dts/rockchip/ |
H A D | rk3036.dtsi | 795 flash_rdy: flash-rdy {
|
H A D | rk3128.dtsi | 1141 flash_rdy: flash-rdy {
|
/linux/arch/arm64/boot/dts/rockchip/ |
H A D | rk3308.dtsi | 1073 flash_rdy: flash-rdy {
|