Searched refs:copper (Results 1 – 15 of 15) sorted by relevance
12 run over copper or fiber. If you are connected to such a network and24 and 700-C (DEFZA-CA, copper) TURBOchannel network cards which
24 both copper and fiber.
12 can run over copper (25m) or fiber (300m on multi-mode or 10km on
327 cp0_copper_eth_phy_reset: copper-eth-phy-reset {571 /* 1G copper */
52 (Supported only on adapters with copper connections)68 (Supported only on adapters with copper connections)246 (This parameter is supported only on adapters with copper connections.)344 For copper-based boards, the keywords interact as follows:
327 between copper-based adapters and fiber-based adapters.329 In the default mode, an Intel(R) Ethernet Network Adapter using copper
382 between copper-based adapters and fiber-based adapters.384 In the default mode, an Intel(R) Ethernet Network Adapter using copper
706 between copper-based adapters and fiber-based adapters.708 In the default mode, an Intel(R) Ethernet Network Adapter using copper
596 media-type = "copper";605 media-type = "copper";
1508 media-type = "copper";1518 media-type = "copper";
290 over copper media.432 Currently supports the DP83869 PHY. This PHY supports copper and
265 if (hw->copper) { in skge_supported_modes() 301 if (hw->copper) { in skge_get_link_ksettings() 1976 if (hw->copper) { in yukon_init() 2094 reg |= hw->copper ? GPC_HWCFG_GMII_COP : GPC_HWCFG_GMII_FIB; in yukon_mac_init() 3550 hw->copper = (pmd_type == 'T' || pmd_type == '1'); in skge_reset() 3577 hw->copper = 1; in skge_reset()
1941 /* mix only with master/slave settings (for copper) */1947 /* only for copper with 1000 Mbps */2413 u8 copper; member
2456 hint to the existence of a manufacturer at all is written in copper,
2752 A passthrough module (OPM or CPM, optical or copper,