Home
last modified time | relevance | path

Searched refs:DSL (Results 1 – 24 of 24) sorted by relevance

/linux/drivers/usb/atm/
H A DKconfig3 # USB/ATM DSL configuration
7 tristate "USB DSL modem support"
11 Say Y here if you want to connect a USB Digital Subscriber Line (DSL)
45 tristate "ADI 930 and eagle USB DSL modem"
57 tristate "Other USB DSL modem support"
59 Say Y here if you have a DSL USB modem not explicitly supported by
60 another USB DSL drivers. In order to use your modem you will need to
/linux/drivers/clk/bcm/
H A DKconfig29 Enable common clock framework support for Broadcom BCM63xx DSL SoCs
37 Enable common clock framework support for Broadcom BCM63xx DSL SoCs
46 Enable timer clock and reset support for Broadcom BCM63268 DSL SoCs
/linux/Documentation/devicetree/bindings/arm/bcm/
H A Dbrcm,bcm63138.txt1 Broadcom BCM63138 DSL System-on-a-Chip device tree bindings
4 Boards compatible with the BCM63138 DSL System-on-a-Chip should have the
/linux/arch/arm/mach-bcm/
H A DKconfig213 including the DSL, PON and Wireless family of chips.
226 including various DSL, PON and Wireless family of chips.
242 only DSL chip BCM63138.
252 only DSL chip BCM63148.
/linux/drivers/isdn/
H A DKconfig15 (though still much slower than with DSL) or to make and accept
/linux/Documentation/devicetree/bindings/sound/
H A Dbrcm,bcm63xx-audio.txt1 Broadcom DSL/PON BCM63xx Audio I2S controller
/linux/sound/soc/bcm/
H A DKconfig28 DSL/PON chips (bcm63158, bcm63178)
/linux/drivers/mtd/nand/raw/brcmnand/
H A DKconfig17 on Broadcom BCM63xx MIPS-based DSL platforms.
/linux/net/atm/
H A DKconfig66 This is sometimes used over DSL lines. If in doubt, say N.
/linux/include/sound/
H A Demu10k1.h451 #define DSL 0x07 /* Send D amount and loop end address register */ macro
452 SUB_REG(DSL, FXSENDAMOUNT_D, 0xff000000) /* Linear level of channel output sent to FX send bus D */
453 SUB_REG(DSL, LOOPENDADDR, 0x00ffffff) /* Loop end address of the specified channel */
/linux/Documentation/devicetree/bindings/mips/brcm/
H A Dsoc.txt1 * Broadcom cable/DSL/settop platforms
/linux/drivers/net/ethernet/dec/tulip/
H A Dde2104x.c83 #define DSL 0 macro
85 #define DSL CONFIG_DE2104X_DSL macro
159 DescSkipLen = (DSL << 2),
274 #if DSL
275 __le32 skip[DSL];
/linux/arch/arm/boot/dts/marvell/
H A Dkirkwood-l-50.dts76 * 1: DSL module reset (active low)
/linux/arch/arm/boot/dts/broadcom/
H A Dbcm63138.dtsi3 * Broadcom BCM63138 DSL SoCs Device Tree
/linux/sound/pci/emu10k1/
H A Demu10k1_callback.c422 DSL, dsl, in start_voice()
H A Demu10k1_main.c61 DSL, 0x10, in snd_emu10k1_voice_init()
1701 CPF, PTRX, CVCF, VTFT, Z1, Z2, PSST, DSL, CCCA, CCR, CLP,
H A Demupcm.c281 DSL, end_addr | (send_amount[3] << 24), in snd_emu10k1_pcm_init_voice()
/linux/arch/arm64/
H A DKconfig.platforms84 including the DSL, PON and Wireless family of chips.
/linux/drivers/atm/
H A DKconfig38 have the code to drive the on-board Alcatel DSL chipset (yet).
/linux/arch/mips/
H A DKconfig288 BCM33xx cable modem chips, BCM63xx DSL chips, and BCM7xxx set-top
413 in XPON (fiber) and DSL applications. They have SPI, PCI, USB,
414 GPIO, and Ethernet, with optional XPON, DSL, and VoIP DSP cores.
/linux/drivers/i2c/busses/
H A DKconfig503 tristate "BRCM Settop/DSL I2C controller"
509 I2C interface on the Broadcom Settop/DSL SoCs.
/linux/drivers/tty/serial/
H A DKconfig1081 BCM63xx/BCM63xxx (DSL)
/linux/drivers/gpio/
H A DKconfig717 Some of the GPIOs/LEDs can be auto updated by the SoC with DSL and
/linux/drivers/watchdog/
H A DKconfig1944 watchdog block, including some cable modem chips and DSL (63xx)