| /linux/drivers/bus/ |
| H A D | ts-nbus.c | 35 struct gpio_desc *rdy; member
71 ts_nbus->rdy = devm_gpiod_get(&pdev->dev, "ts,rdy", GPIOD_IN); in ts_nbus_init_pdata()
72 if (IS_ERR(ts_nbus->rdy)) in ts_nbus_init_pdata()
73 return dev_err_probe(&pdev->dev, PTR_ERR(ts_nbus->rdy), in ts_nbus_init_pdata()
221 ret = gpiod_get_value_cansleep(ts_nbus->rdy); in ts_nbus_read()
256 while (gpiod_get_value_cansleep(ts_nbus->rdy) != 0) { in ts_nbus_write()
|
| /linux/drivers/mtd/nand/raw/ |
| H A D | gpio.c | 39 struct gpio_desc *rdy; member
124 if (!gpiomtd->rdy) in gpio_nand_exec_instr()
127 return nand_gpio_waitrdy(chip, gpiomtd->rdy, in gpio_nand_exec_instr()
342 gpiomtd->rdy = devm_gpiod_get_optional(dev, "rdy", GPIOD_IN); in gpio_nand_probe()
343 if (IS_ERR(gpiomtd->rdy)) { in gpio_nand_probe()
344 ret = PTR_ERR(gpiomtd->rdy); in gpio_nand_probe()
|
| H A D | lpc32xx_slc.c | 298 int rdy = 0; in lpc32xx_nand_device_ready() local
301 rdy = 1; in lpc32xx_nand_device_ready()
303 return rdy; in lpc32xx_nand_device_ready()
|
| /linux/Documentation/devicetree/bindings/bus/ |
| H A D | ts-nbus.txt | 16 - ts,rdy-gpios : The GPIO pin connected to the rdy line on the FPGA
43 ts,rdy-gpios = <&gpio0 21 GPIO_ACTIVE_HIGH>;
|
| H A D | nvidia,tegra20-gmi.txt | 45 - nvidia,snor-rdy-active-before-data: Assert RDY signal one cycle before data.
47 - nvidia,snor-rdy-active-high: RDY signal is active high
|
| /linux/drivers/input/touchscreen/ |
| H A D | wacom_w8001.c | 60 u8 rdy; member
111 coord->rdy = data[0] & 0x20; in parse_pen_data()
256 input_report_key(dev, w8001->type, coord->rdy); in report_pen_events()
259 if (!coord->rdy) in report_pen_events()
|
| /linux/drivers/scsi/aic7xxx/ |
| H A D | aic7xxx_93cx6.c | 95 #define CLOCK_PULSE(sd, rdy) \ argument
96 while ((SEEPROM_STATUS_INB(sd) & rdy) == 0) { \
|
| /linux/Documentation/devicetree/bindings/phy/ |
| H A D | phy-miphy28lp.txt | 34 - st,osc-rdy : to check the MIPHY0_OSC_RDY status in the glue-logic. This
65 st,osc-rdy;
|
| /linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | lantiq,pinctrl-xway.txt | 67 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd,
79 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd,
94 nand rdy, nand rd, nand_d0, nand_d1, nand_d2, nand_d3, nand_d4, nand_d5,
|
| /linux/arch/mips/boot/dts/ni/ |
| H A D | 169445.dts | 67 gpios = <&gpio2 0 0>, /* rdy */
|
| /linux/arch/arm/boot/dts/st/ |
| H A D | stih418-b2199.dts | 43 st,osc-rdy;
|
| H A D | stih418-b2264.dts | 121 st,osc-rdy;
|
| /linux/drivers/crypto/amcc/ |
| H A D | crypto4xx_reg_def.h | 231 u32 rdy:1; member
|
| H A D | crypto4xx_core.c | 857 sd->ctl.rdy = 1; in crypto4xx_build_pd()
868 sd->ctl.rdy = 1; in crypto4xx_build_pd()
|
| /linux/Documentation/devicetree/bindings/mtd/ |
| H A D | atmel-nand.txt | 173 gpios = <&pioC 13 0 /* rdy */
200 gpios = <&pioD 5 0 /* rdy */
|
| /linux/sound/pci/ |
| H A D | sis7019.c | 880 u16 rdy; in sis_ac97_rw() local
888 rdy = codec_ready[codec]; in sis_ac97_rw()
908 if ((status & rdy) && !(status & SIS_AC97_STATUS_BUSY)) in sis_ac97_rw()
|
| /linux/drivers/scsi/be2iscsi/ |
| H A D | be_cmds.c | 1617 u32 loop, post, rdy = 0; in beiscsi_check_fw_rdy() local
1625 rdy = 1; in beiscsi_check_fw_rdy()
1631 if (!rdy) { in beiscsi_check_fw_rdy()
1636 return rdy; in beiscsi_check_fw_rdy()
|
| /linux/drivers/scsi/hisi_sas/ |
| H A D | hisi_sas.h | 673 extern void hisi_sas_phy_down(struct hisi_hba *hisi_hba, int phy_no, int rdy,
|
| H A D | hisi_sas_main.c | 2102 void hisi_sas_phy_down(struct hisi_hba *hisi_hba, int phy_no, int rdy, in hisi_sas_phy_down() argument
2109 if (rdy) { in hisi_sas_phy_down()
|
| H A D | hisi_sas_v3_hw.c | 1755 int rdy = phy_state & (1 << phy_no); in int_phy_up_down_bcast_v3_hw() local
1757 if (rdy) { in int_phy_up_down_bcast_v3_hw()
|
| /linux/drivers/net/wireless/realtek/rtw89/ |
| H A D | rtw8922a.c | 1562 u32 rdy = 0; in rtw8922a_bb_preinit() local
1565 rdy = 1; in rtw8922a_bb_preinit()
1571 rtw89_write32_mask(rtwdev, R_BE_FEN_RST_ENABLE, mcu_bootrdy_mask[phy_idx], rdy); in rtw8922a_bb_preinit()
|
| /linux/arch/arm/boot/dts/rockchip/ |
| H A D | rk3036.dtsi | 792 flash_rdy: flash-rdy {
|
| H A D | rk3128.dtsi | 1141 flash_rdy: flash-rdy {
|
| /linux/drivers/hid/ |
| H A D | wacom_wac.c | 3201 bool range, prox, rdy; in wacom_bpt_pen() local
3208 rdy = (data[1] & 0x20) == 0x20; in wacom_bpt_pen()
3214 if (rdy) { in wacom_bpt_pen()
|
| /linux/arch/arm64/boot/dts/rockchip/ |
| H A D | rk3308.dtsi | 1073 flash_rdy: flash-rdy {
|