| /linux/drivers/net/wireless/broadcom/brcm80211/brcmfmac/ |
| H A D | pcie.c | 705 brcmf_dbg(PCIE, "config offset 0x%04x, value 0x%04x\n", in brcmf_pcie_reset_device()
776 brcmf_dbg(PCIE, "MB transaction is already pending 0x%04x\n", in brcmf_pcie_send_mb_data()
815 brcmf_dbg(PCIE, "D2H_MB_DATA: 0x%04x\n", dtoh_mb_data); in brcmf_pcie_handle_mb_data()
817 brcmf_dbg(PCIE, "D2H_MB_DATA: DEEP SLEEP REQ\n"); in brcmf_pcie_handle_mb_data()
819 brcmf_dbg(PCIE, "D2H_MB_DATA: sent DEEP SLEEP ACK\n"); in brcmf_pcie_handle_mb_data()
822 brcmf_dbg(PCIE, "D2H_MB_DATA: DEEP SLEEP EXIT\n"); in brcmf_pcie_handle_mb_data()
824 brcmf_dbg(PCIE, "D2H_MB_DATA: D3 ACK\n"); in brcmf_pcie_handle_mb_data()
829 brcmf_dbg(PCIE, "D2H_MB_DATA: FW HALT\n"); in brcmf_pcie_handle_mb_data()
934 brcmf_dbg(PCIE, "Enter\n"); in brcmf_pcie_quick_check_isr()
948 brcmf_dbg(PCIE, "Enter %x\n", status); in brcmf_pcie_isr_thread()
[all …]
|
| H A D | Kconfig | 41 bool "PCIE bus interface support for FullMAC driver"
47 This option enables the PCIE bus interface support for Broadcom
49 use the driver for an PCIE wireless card.
|
| /linux/Documentation/admin-guide/perf/ |
| H A D | nvidia-pmu.rst | 12 * PCIE
32 strongly-ordered (SO) PCIE write traffic to local/remote memory. Please see
63 PCIE device of the remote SoC.
154 The CNVLink PMU monitors traffic from GPU and PCIE device on remote sockets
155 to local memory. For PCIE traffic, this PMU captures read and relaxed ordered
172 traffic from remote GPU and PCIE devices.
193 PCIE PMU
196 The PCIE PMU monitors all read/write traffic from PCIE root ports to
235 * : PCIE : * * : PCIE : *
267 | Local | PCIE |NVLink-C2C0|NVLink-C2C1| SCF | SCF PMU | CNVLink |
[all …]
|
| /linux/drivers/phy/amlogic/ |
| H A D | Kconfig | 64 tristate "Meson G12A USB3+PCIE Combo PHY driver"
70 Enable this to support the Meson USB3 + PCIE Combo PHY found
75 tristate "Meson AXG PCIE PHY driver"
81 Enable this to support the Meson MIPI + PCIE PHY found
86 tristate "Meson AXG MIPI + PCIE analog PHY driver"
93 Enable this to support the Meson MIPI + PCIE analog PHY
|
| /linux/drivers/infiniband/hw/hfi1/ |
| H A D | chip_registers.h | 20 #define PCIE 0 macro
584 #define PCI_CFG_MSIX0 (PCIE + 0x0000000000B0)
585 #define PCI_CFG_REG1 (PCIE + 0x000000000004)
586 #define PCI_CFG_REG11 (PCIE + 0x00000000002C)
587 #define PCIE_CFG_SPCIE1 (PCIE + 0x00000000014C)
588 #define PCIE_CFG_SPCIE2 (PCIE + 0x000000000150)
589 #define PCIE_CFG_TPH2 (PCIE + 0x000000000180)
1269 #define PCIE_CFG_REG_PL2 (PCIE + 0x000000000708)
1270 #define PCIE_CFG_REG_PL3 (PCIE + 0x00000000070C)
1273 #define PCIE_CFG_REG_PL102 (PCIE + 0x000000000898)
[all …]
|
| /linux/drivers/phy/st/ |
| H A D | phy-spear1340-miphy.c | 77 PCIE, enumerator
164 else if (priv->mode == PCIE) in spear1340_miphy_init()
177 else if (priv->mode == PCIE) in spear1340_miphy_exit()
234 if (priv->mode != SATA && priv->mode != PCIE) { in spear1340_miphy_xlate()
|
| H A D | phy-spear1310-miphy.c | 98 PCIE, enumerator
156 if (priv->mode == PCIE) in spear1310_miphy_init()
167 if (priv->mode == PCIE) in spear1310_miphy_exit()
197 if (priv->mode != SATA && priv->mode != PCIE) { in spear1310_miphy_xlate()
|
| /linux/drivers/net/ethernet/huawei/hinic/ |
| H A D | Kconfig | 7 tristate "Huawei Intelligent PCIE Network Interface Card"
11 This driver supports HiNIC PCIE Ethernet cards.
|
| /linux/drivers/soc/loongson/ |
| H A D | Kconfig | 11 The global utilities block controls PCIE device enabling, alternate
13 and PCIE, configuration of memory controller, rtc controller, lio
|
| /linux/Documentation/translations/zh_CN/mm/ |
| H A D | hmm.rst | 67 如果我们只考虑 PCIE 总线，那么设备可以访问主内存（通常通过 IOMMU）并与 CPU 缓存一
72 另一个严重的因素是带宽有限（约 32GBytes/s，PCIE 4.0 和 16 通道）。这比最快的 GPU
76 一些平台正在开发新的 I/O 总线或对 PCIE 的添加/修改以解决其中一些限制
|
| /linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6qdl-mba6.dtsi | 94 /* PCIE.PWR_EN */
508 MX6QDL_PAD_SD4_DAT3__GPIO2_IO11 0x001b0f0 /* #PCIE.WAKE */
509 MX6QDL_PAD_NANDF_CLE__GPIO6_IO07 0x001b0f0 /* #PCIE.RST */
510 MX6QDL_PAD_NANDF_CS0__GPIO6_IO11 0x001b0f0 /* #PCIE.DIS */
538 MX6QDL_PAD_NANDF_D0__GPIO2_IO00 0x00130f0 /* PCIE.PWR_EN */
|
| H A D | imx6q-gw5400-a.dts | 452 MX6QDL_PAD_ENET_TX_EN__GPIO1_IO28 0x1b0b0 /* PCIE IRQ */
453 MX6QDL_PAD_ENET_TXD1__GPIO1_IO29 0x1b0b0 /* PCIE RST */
|
| /linux/drivers/phy/freescale/ |
| H A D | Kconfig | 32 tristate "Freescale i.MX8M PCIE PHY"
36 Enable this to add support for the PCIE PHY as found on
|
| /linux/arch/arm64/boot/dts/realtek/ |
| H A D | kent.dtsi | 132 <0xa0000000 0x0 0xa0000000 0x10000000>, /* PCIE */
140 <0xa0000000 0xa0000000 0x10000000>; /* PCIE */
|
| /linux/arch/arm/boot/dts/aspeed/ |
| H A D | aspeed-bmc-tyan-s7106.dts | 360 * - 0,0: PCIE slot 1, SMB #1
361 * - 0,1: PCIE slot 1, SMB #2
362 * - 1,0: PCIE slot 2, SMB #1
363 * - 1,1: PCIE slot 2, SMB #2
|
| /linux/drivers/accel/qaic/ |
| H A D | qaic_ras.c | 48 PCIE, enumerator
58 [PCIE] = "PCIE",
221 case PCIE: in ras_msg_to_cpu()
340 case PCIE: in decode_ras_msg()
|
| /linux/arch/arm64/boot/dts/xilinx/ |
| H A D | zynqmp-zcu102-revA.dts | 262 output-low; /* PCIE = 0, DP = 1 */
268 output-high; /* PCIE = 0, DP = 1 */
274 output-high; /* PCIE = 0, USB0 = 1 */
280 output-high; /* PCIE = 0, SATA = 1 */
568 /* refclk4 for PS-GT, used for PCIE slot */
573 /* refclk5 for PS-GT, used for PCIE */
|
| /linux/drivers/perf/hisilicon/ |
| H A D | Kconfig | 10 tristate "HiSilicon PCIE PERF PMU"
|
| /linux/drivers/net/can/sja1000/ |
| H A D | Kconfig | 25 tristate "Fintek F81601 PCIE to 2 CAN Controller"
28 This driver adds support for Fintek F81601 PCIE to 2 CAN
|
| /linux/drivers/pinctrl/tegra/ |
| H A D | pinctrl-tegra30.c | 2401 …PINGROUP(pex_l2_rst_n_pcc6, PCIE, HDA, RSVD3, RSVD4, 0x33d8, N, …
2402 …PINGROUP(pex_l2_clkreq_n_pcc7, PCIE, HDA, RSVD3, RSVD4, 0x33dc, N, …
2403 …PINGROUP(pex_l0_prsnt_n_pdd0, PCIE, HDA, RSVD3, RSVD4, 0x33b8, N, …
2404 …PINGROUP(pex_l0_rst_n_pdd1, PCIE, HDA, RSVD3, RSVD4, 0x33bc, N, …
2405 …PINGROUP(pex_l0_clkreq_n_pdd2, PCIE, HDA, RSVD3, RSVD4, 0x33c0, N, …
2406 …PINGROUP(pex_wake_n_pdd3, PCIE, HDA, RSVD3, RSVD4, 0x33c4, N, …
2407 …PINGROUP(pex_l1_prsnt_n_pdd4, PCIE, HDA, RSVD3, RSVD4, 0x33c8, N, …
2408 …PINGROUP(pex_l1_rst_n_pdd5, PCIE, HDA, RSVD3, RSVD4, 0x33cc, N, …
2409 …PINGROUP(pex_l1_clkreq_n_pdd6, PCIE, HDA, RSVD3, RSVD4, 0x33d0, N, …
2410 …PINGROUP(pex_l2_prsnt_n_pdd7, PCIE, HDA, RSVD3, RSVD4, 0x33d4, N, …
|
| /linux/drivers/phy/starfive/ |
| H A D | Kconfig | 29 tristate "Starfive JH7110 PCIE 2.0/USB 3.0 PHY support"
|
| /linux/drivers/net/wireless/marvell/mwifiex/ |
| H A D | Kconfig | 26 tristate "Marvell WiFi-Ex Driver for PCIE 8766/8897/8997"
|
| /linux/arch/arm64/boot/dts/renesas/ |
| H A D | salvator-xs.dtsi | 39 line-name = "PCIE/SATA switch";
|
| /linux/arch/arm64/boot/dts/freescale/ |
| H A D | imx8mp-edm-g.dtsi | 558 MX8MP_IOMUXC_GPIO1_IO13__GPIO1_IO13 0x41 /* PCIE CLKREQ */
559 MX8MP_IOMUXC_SAI2_RXFS__GPIO4_IO21 0x41 /* PCIE WAKE */
560 MX8MP_IOMUXC_GPIO1_IO01__GPIO1_IO01 0x41 /* PCIE RST */
|
| /linux/drivers/net/wireless/ath/ath11k/ |
| H A D | Kconfig | 29 This module adds support for PCIE bus
|