Searched refs:ODR (Results 1 – 5 of 5) sorted by relevance
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-inv_icm42600 | 6 requested power mode to use if the ODR support it. If ODR
11 be different for ODR supporting only 1 mode.
|
| /linux/drivers/scsi/aacraid/ |
| H A D | rx.c | 51 rx_writel(dev, MUnit.ODR,DoorBellPrintfReady); in aac_rx_intr_producer()
55 rx_writel(dev, MUnit.ODR, DoorBellAdapterNormCmdReady); in aac_rx_intr_producer()
59 rx_writel(dev, MUnit.ODR,DoorBellAdapterNormRespReady); in aac_rx_intr_producer()
63 rx_writel(dev, MUnit.ODR, DoorBellAdapterNormCmdNotFull); in aac_rx_intr_producer()
66 rx_writel(dev, MUnit.ODR, DoorBellAdapterNormCmdNotFull); in aac_rx_intr_producer()
67 rx_writel(dev, MUnit.ODR, DoorBellAdapterNormRespNotFull); in aac_rx_intr_producer()
102 MUnit.ODR, in aac_rx_intr_message()
641 rx_writel(dev, MUnit.ODR, 0xffffffff); in _aac_rx_init()
|
| H A D | aacraid.h | 1099 __le32 ODR; /* 132Ch | 2Ch | Outbound Doorbell Register */ member
1131 #define OutboundDoorbellReg MUnit.ODR
|
| /linux/Documentation/iio/ |
| H A D | ad7191.rst | 24 The driver supports both pin-strapped and GPIO-controlled configurations for ODR
29 ODR Configuration
32 The ODR can be configured either through GPIO control or pin-strapping:
38 Available ODR settings:
|
| H A D | adxl345.rst | 133 Manually setting the **ODR** will cause the driver to estimate default values
134 for inactivity detection timing, where higher ODR values correspond to longer
135 default wait times, and lower ODR values to shorter ones. If these defaults do
173 Note: According to the datasheet, the optimal ODR for detecting activity,
281 Set output data rate (ODR):
|