Searched full:hooked (Results 1 – 25 of 145) sorted by relevance
123456
| /linux-5.10/drivers/staging/iio/meter/ |
| D | Kconfig | 22 Say Y here if you have ADE7854/58/68/78 hooked to an I2C bus.
32 Say Y here if you have ADE7854/58/68/78 hooked to a SPI bus.
|
| /linux-5.10/Documentation/devicetree/bindings/media/ |
| D | cec-gpio.txt | 4 is hooked up to a pull-up GPIO line and - optionally - the HPD line is
5 hooked up to another GPIO line.
|
| /linux-5.10/Documentation/devicetree/bindings/power/ |
| D | rockchip-io-domain.txt | 9 - If the regulator hooked up to a pin like SDMMC0_VDD is 3.3V then
10 bit 7 of GRF_IO_VSEL needs to be 0. If the regulator hooked up to
15 hooked up to the pins.
|
| /linux-5.10/Documentation/userspace-api/media/cec/ |
| D | cec-ioc-adap-g-phys-addr.rst | 66 has address 0.0.0.0. Every device that is hooked up to an input of the
67 TV has address a.0.0.0 (where 'a' is ≥ 1), devices hooked up to those in
|
| /linux-5.10/drivers/input/misc/ |
| D | stpmic1_onkey.c | 17 * @irq_falling: irq that we are hooked on to
18 * @irq_rising: irq that we are hooked on to
|
| D | Kconfig | 61 Say Y here if you have AD7142/AD7147 hooked to an I2C bus.
71 Say Y here if you have AD7142/AD7147 hooked to a SPI bus.
105 acceleration sensor hooked to an I2C bus.
696 Say Y here if you have ADXL345/6 hooked to an I2C bus.
706 Say Y here if you have ADXL345/6 hooked to a SPI bus.
|
| /linux-5.10/Documentation/devicetree/bindings/interrupt-controller/ |
| D | fsl,ls-scfg-msi.txt | 17 is hooked to a parent interrupt controller: e.g: ARM GIC for ARM-based
|
| D | brcm,bcm7120-l2-intc.txt | 4 is hooked to a parent interrupt controller: e.g: ARM GIC for ARM-based
|
| /linux-5.10/Documentation/admin-guide/LSM/ |
| D | index.rst | 6 various security checks to be hooked by new kernel extensions. The name
|
| /linux-5.10/arch/arm/boot/dts/ |
| D | rk3288-veyron-sdmmc.dtsi | 34 * Builtin CD line is hooked to ground to prevent JTAG at boot
|
| D | rk3288-evb.dtsi | 166 * NOTE: vcc_sd isn't hooked up on v1.0 boards where power comes from
229 disable-wp; /* wp not hooked up */
|
| D | sun6i-a31-colombus.dts | 64 /* The lcd panel i2c interface is hooked up via gpios */
|
| D | sun5i-a13-utoo-p66.dts | 62 /* The lcd panel i2c interface is hooked up via gpios */
|
| /linux-5.10/drivers/gpu/drm/msm/edp/ |
| D | edp.h | 33 /* the encoder we are hooked to (outside of eDP block) */
|
| /linux-5.10/arch/arm64/boot/dts/qcom/ |
| D | sc7180-trogdor-r1.dts | 38 /* Not hooked up */
|
| /linux-5.10/sound/pci/hda/ |
| D | Makefile | 47 # otherwise the codec patches won't be hooked before the PCI probe
|
| /linux-5.10/drivers/staging/media/zoran/ |
| D | videocodec.c | 208 dprintk(4, "videocodec: hooked in as first element\n"); in videocodec_register()
213 dprintk(4, "videocodec: hooked in after '%s'\n", in videocodec_register()
|
| /linux-5.10/net/ipv4/netfilter/ |
| D | iptable_raw.c | 3 * 'raw' table, which is the very first hooked in at PRE_ROUTING and LOCAL_OUT .
|
| /linux-5.10/Documentation/sound/soc/ |
| D | jack.rst | 69 These are all hooked together by the machine driver depending on the
|
| /linux-5.10/arch/arc/mm/ |
| D | highmem.c | 35 * - Both fixmap/pkmap use a dedicated page table each, hooked up to swapper PGD
|
| /linux-5.10/arch/powerpc/include/asm/ |
| D | xics.h | 85 /* ICS instance, hooked up to chip_data of an irq */
|
| /linux-5.10/arch/arc/include/asm/ |
| D | smp.h | 37 * Takes @cpu and @hwirq to which the arch-common ISR is hooked up
|
| /linux-5.10/drivers/misc/ |
| D | Kconfig | 37 Say Y here if you have a digital potentiometers hooked to an I2C bus.
46 Say Y here if you have a digital potentiometers hooked to an SPI bus.
|
| /linux-5.10/drivers/iio/light/ |
| D | Kconfig | 193 hooked to an I2C bus.
207 hooked to an I2C bus.
|
| /linux-5.10/arch/arc/kernel/ |
| D | intc-compact.c | 59 * To reduce platform code, we assume all IRQs directly hooked-up into intc.
|
123456