Home
last modified time | relevance | path

Searched full:mx8ulp (Results 1 – 12 of 12) sorted by relevance

/linux-6.8/Documentation/devicetree/bindings/clock/
Dimx8ulp-cgc-clock.yaml7 title: NXP i.MX8ULP Clock Generation & Control(CGC) Module
13 On i.MX8ULP, The clock sources generation, distribution and management is
Dimx8ulp-pcc-clock.yaml7 title: NXP i.MX8ULP Peripheral Clock Controller(PCC) Module
13 On i.MX8ULP, The clock sources generation, distribution and management is
/linux-6.8/sound/soc/sof/imx/
DKconfig45 tristate "SOF support for i.MX8ULP"
49 This adds support for Sound Open Firmware for NXP i.MX8ULP platforms.
Dimx8ulp.c7 // Hardware interface for audio DSP on i.MX8ULP
/linux-6.8/drivers/clk/imx/
DKconfig108 Build the driver for i.MX8ULP CCM Clock Driver
Dclk-imx8ulp.c569 MODULE_DESCRIPTION("NXP i.MX8ULP clock driver");
/linux-6.8/Documentation/devicetree/bindings/pinctrl/
Dfsl,imx8ulp-pinctrl.yaml39 refer to i.MX8ULP Reference Manual for detailed CONFIG settings.
/linux-6.8/drivers/pinctrl/freescale/
Dpinctrl-imx8ulp.c277 MODULE_DESCRIPTION("NXP i.MX8ULP pinctrl driver");
/linux-6.8/arch/arm64/boot/dts/freescale/
Dimx8ulp-evk.dts11 model = "NXP i.MX8ULP EVK";
/linux-6.8/drivers/remoteproc/
Dimx_dsp_rproc.c63 /* Definitions for i.MX8ULP */
212 /* Reset function for DSP on i.MX8ULP */
252 /* Specific configuration for i.MX8ULP */
1037 * For i.MX8MP and i.MX8ULP, DSP should be started and stopped by system
/linux-6.8/drivers/gpio/
Dgpio-vf610.c293 * for the i.MX8ULP and i.MX93. in vf610_gpio_probe()
/linux-6.8/Documentation/devicetree/bindings/arm/
Dfsl.yaml1235 - description: i.MX8ULP based Boards
1238 - fsl,imx8ulp-evk # i.MX8ULP EVK Board