Searched +full:0 +full:xff900000 (Results 1 – 11 of 11) sorted by relevance
/linux-5.10/Documentation/devicetree/bindings/mtd/ |
D | denali,nand.yaml | 138 reg = <0xff900000 0x20>, <0xffb80000 0x1000>; 139 interrupts = <0 144 4>; 145 #size-cells = <0>; 147 nand@0 { 148 reg = <0>;
|
/linux-5.10/arch/arm/boot/dts/ |
D | highbank.dts | 9 /memreserve/ 0x00000000 0x0001000; 19 #size-cells = <0>; 24 reg = <0x900>; 43 reg = <0x901>; 62 reg = <0x902>; 81 reg = <0x903>; 98 memory@0 { 101 reg = <0x00000000 0xff900000>; 105 ranges = <0x00000000 0x00000000 0xffffffff>; 109 reg = <0xfff00000 0x1000>; [all …]
|
D | socfpga.dtsi | 23 #size-cells = <0>; 26 cpu0: cpu@0 { 29 reg = <0>; 43 interrupts = <0 176 4>, <0 177 4>; 45 reg = <0xff111000 0x1000>, 46 <0xff113000 0x1000>; 53 reg = <0xfffed000 0x1000>, 54 <0xfffec100 0x100>; 73 reg = <0xffe01000 0x1000>; 74 interrupts = <0 104 4>, [all …]
|
/linux-5.10/arch/m68k/include/asm/ |
D | bvme6000hw.h | 11 #define BVME_PIT_BASE 0xffa00000 47 #define BVME_RTC_BASE 0xff900000 86 #define BVME_I596_BASE 0xff100000 88 #define BVME_ETHIRQ_REG 0xff20000b 90 #define BVME_LOCAL_IRQ_STAT 0xff20000f 92 #define BVME_ETHERR 0x02 93 #define BVME_ABORT_STATUS 0x08 95 #define BVME_NCR53C710_BASE 0xff000000 97 #define BVME_SCC_A_ADDR 0xffb0000b 98 #define BVME_SCC_B_ADDR 0xffb00003 [all …]
|
/linux-5.10/drivers/staging/rtl8192e/rtl8192e/ |
D | rtl_core.h | 66 #define HAL_HW_PCI_REVISION_ID_8192PCIE 0x01 67 #define HAL_HW_PCI_REVISION_ID_8192SE 0x10 86 #define DEFAULT_BEACONINTERVAL 0x64U 112 NIC_UNKNOWN = 0, 128 TXCMD_TXRA_HISTORY_CTRL = 0xFF900000, 129 TXCMD_RESET_TX_PKT_BUFF = 0xFF900001, 130 TXCMD_RESET_RX_PKT_BUFF = 0xFF900002, 131 TXCMD_SET_TX_DURATION = 0xFF900003, 132 TXCMD_SET_RX_RSSI = 0xFF900004, 133 TXCMD_SET_TX_PWR_TRACKING = 0xFF900005, [all …]
|
/linux-5.10/arch/arm64/boot/dts/intel/ |
D | socfpga_agilex.dtsi | 21 service_reserved: svcbuffer@0 { 23 reg = <0x0 0x0 0x0 0x2000000>; 24 alignment = <0x1000>; 31 #size-cells = <0>; 33 cpu0: cpu@0 { 37 reg = <0x0>; 44 reg = <0x1>; 51 reg = <0x2>; 58 reg = <0x3>; 64 interrupts = <0 170 4>, [all …]
|
/linux-5.10/arch/arm64/boot/dts/altera/ |
D | socfpga_stratix10.dtsi | 21 service_reserved: svcbuffer@0 { 23 reg = <0x0 0x0 0x0 0x1000000>; 24 alignment = <0x1000>; 31 #size-cells = <0>; 33 cpu0: cpu@0 { 37 reg = <0x0>; 44 reg = <0x1>; 51 reg = <0x2>; 58 reg = <0x3>; 64 interrupts = <0 170 4>, [all …]
|
/linux-5.10/arch/arm/mach-orion5x/ |
D | ts78xx-setup.c | 36 #define TS78XX_FPGA_REGS_PHYS_BASE 0xe8000000 37 #define TS78XX_FPGA_REGS_VIRT_BASE IOMEM(0xff900000) 41 .id = 0, 68 .phy_addr = MV643XX_ETH_PHY_ADDR(0), 81 #define TS_RTC_CTRL (TS78XX_FPGA_REGS_PHYS_BASE + 0x808) 82 #define TS_RTC_DATA (TS78XX_FPGA_REGS_PHYS_BASE + 0x80c) 85 DEFINE_RES_MEM(TS_RTC_CTRL, 0x01), 86 DEFINE_RES_MEM(TS_RTC_DATA, 0x01), 100 if (ts78xx_fpga.supports.ts_rtc.init == 0) { in ts78xx_ts_rtc_load() 122 #define TS_NAND_CTRL (TS78XX_FPGA_REGS_VIRT_BASE + 0x800) /* VIRT */ [all …]
|
/linux-5.10/drivers/staging/rtl8192u/ |
D | r8192U.h | 57 } while (0) 59 #define COMP_TRACE BIT(0) /* Function call tracing. */ 105 } while (0) 117 for (i = 0; i < (int)(datalen); i++) { \ 119 if ((i+1)%16 == 0) \ 124 } while (0) 126 #define RTL8192U_ASSERT(expr) do {} while (0) 127 #define RT_DEBUG_DATA(level, data, datalen) do {} while (0) 131 #define QSLT_BK 0x1 132 #define QSLT_BE 0x0 [all …]
|
/linux-5.10/arch/arm64/boot/dts/amlogic/ |
D | meson-g12-common.dtsi | 100 reg = <0x0 0x05000000 0x0 0x300000>; 107 size = <0x0 0x10000000>; 108 alignment = <0x0 0x400000>; 125 reg = <0x0 0xfc000000 0x0 0x400000 126 0x0 0xff648000 0x0 0x2000 127 0x0 0xfc400000 0x0 0x200000>; 131 interrupt-map-mask = <0 0 0 0>; 132 interrupt-map = <0 0 0 0 &gic GIC_SPI 223 IRQ_TYPE_LEVEL_HIGH>; 133 bus-range = <0x0 0xff>; 137 ranges = <0x81000000 0 0 0x0 0xfc600000 0 0x00100000 [all …]
|
/linux-5.10/arch/arm64/boot/dts/rockchip/ |
D | rk3399.dtsi | 44 #size-cells = <0>; 72 cpu_l0: cpu@0 { 75 reg = <0x0 0x0>; 87 reg = <0x0 0x1>; 99 reg = <0x0 0x2>; 111 reg = <0x0 0x3>; 123 reg = <0x0 0x100>; 135 reg = <0x0 0x101>; 150 arm,psci-suspend-param = <0x0010000>; 159 arm,psci-suspend-param = <0x1010000>; [all …]
|