| /linux/drivers/nvmem/ |
| H A D | Kconfig | 67 tristate "Broadcom On-Chip OTP Controller support"
72 Say y here to enable read/write access to the Broadcom OTP
99 tristate "i.MX 6/7/8 On-Chip OTP Controller support"
103 This is a driver for the On-Chip OTP Controller (OCOTP) available on
111 tristate "i.MX On-Chip OTP Controller support"
116 This is a driver for the On-Chip OTP Controller (OCOTP)
120 tristate "i.MX8 SCU On-Chip OTP Controller support"
124 This is a driver for the SCU On-Chip OTP Controller (OCOTP)
140 tristate "Microchip LAN9662 OTP controller support"
144 This driver enables the OTP controller available on Microchip LAN9662
[all …]
|
| /linux/drivers/mtd/nand/onenand/ |
| H A D | Kconfig | 45 bool "OneNAND OTP Support"
49 Also, 1st Block of NAND Flash Array can be used as OTP.
51 The OTP block can be read, programmed and locked using the same
53 OTP block cannot be erased.
55 OTP block is fully-guaranteed to be a valid block.
|
| /linux/Documentation/devicetree/bindings/regulator/ |
| H A D | palmas-pmic.txt | 3 The tps659038 for the AM57x class have OTP spins that
5 is not a need to add the OTP spins to the palmas driver. The
35 For ti,palmas-pmic - smps12, smps123, smps3 depending on OTP,
50 ti,smps-range - OTP has the wrong range set for the hardware so override
|
| /linux/Documentation/devicetree/bindings/nvmem/ |
| H A D | lpc1850-otp.txt | 1 * NXP LPC18xx OTP memory
3 Internal OTP (One Time Programmable) memory for NXP LPC18xx/43xx devices.
|
| /linux/drivers/misc/mchp_pci1xxxx/ |
| H A D | Kconfig | 2 tristate "Microchip PCI1XXXX PCIe to GPIO Expander + OTP/EEPROM manager"
11 which also has registers to interface with the OTP and EEPROM.
|
| /linux/Documentation/devicetree/bindings/net/ |
| H A D | microchip,lan78xx.txt | 3 The LAN78XX devices are usually configured by programming their OTP or with
5 The Device Tree properties, if present, override the OTP and EEPROM.
|
| /linux/Documentation/hwmon/ |
| H A D | sht15.rst | 48 The humidity calibration coefficients are programmed into an OTP memory on the
67 flag to indicate not to reload from OTP (default to false).
|
| H A D | mpq8785.rst | 52 over-temperature protection (OTP).
|
| /linux/drivers/mtd/chips/ |
| H A D | Kconfig | 156 bool "Protection Registers aka one-time programmable (OTP) bits"
166 programmable (OTP) bits; when programmed, register bits cannot be
173 because the Lock Register bits themselves are OTP, when programmed,
178 in the programming of OTP bits will waste them.
|
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-platform-silicom | 27 OTP status:
|
| /linux/Documentation/devicetree/bindings/mfd/ |
| H A D | palmas.txt | 31 hardware, if not set will use muxing in OTP.
|
| /linux/Documentation/w1/slaves/ |
| H A D | w1_ds2406.rst | 15 These chips also provide 128 bytes of OTP EPROM, but reading/writing it is
|
| /linux/Documentation/devicetree/bindings/input/ |
| H A D | ti,palmas-pwrbutton.txt | 18 NOTE: This depends on OTP support and POWERHOLD signal configuration
|
| /linux/arch/arm/boot/dts/synaptics/ |
| H A D | berlin2cd-valve-steamlink.dts | 42 * less depending on leakage value in OTP), and buck2 likely used for
|
| /linux/Documentation/ABI/stable/ |
| H A D | sysfs-bus-nvmem | 48 "OTP", "Battery backed", "FRAM".
|
| /linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6q-gk802.dts | 54 /* SDMC DM2016 1024 bit EEPROM + 128 bit OTP */
|
| /linux/Documentation/networking/device_drivers/ethernet/meta/ |
| H A D | fbnic.rst | 87 OTP memory ("fuses") are used for secure boot and anti-rollback
88 protection. The OTP memory is ECC protected, ECC errors indicate
|
| /linux/drivers/platform/cznic/ |
| H A D | Kconfig | 48 able to program SOC's OTP on board revisions 32+,
|
| /linux/drivers/mtd/devices/ |
| H A D | Kconfig | 73 bool "DataFlash OTP support (Security Register)"
77 one-time-programmable (OTP) data. The first half may be written
|
| /linux/arch/powerpc/boot/dts/ |
| H A D | wii.dts | 227 * requires refactoring the PIC1, GPIO and OTP nodes
|
| /linux/include/linux/mfd/ |
| H A D | idt8a340_reg.h | 458 #define OTP 0xcf70 macro
|
| /linux/Documentation/security/keys/ |
| H A D | trusted-encrypted.rst | 78 Rooted to a one-time programmable key (OTP) that is generally burnt
80 DCP provides two keys that can be used as root of trust: the OTP key
82 the OTP key can be done via a module parameter (dcp_use_otp_key).
|
| /linux/drivers/pmdomain/amlogic/ |
| H A D | meson-secure-pwrc.c | 128 SEC_PD(OTP, 0),
|
| /linux/arch/arm64/boot/dts/allwinner/ |
| H A D | sun50i-h700-anbernic-rg35xx-2024.dts | 350 * default value from regulator OTP mem.
|
| /linux/drivers/gpio/ |
| H A D | Kconfig | 1315 OTP. Enable this only if you want to use these pins as outputs.
1327 on OTP at manufacturing.
|