Home
last modified time | relevance | path

Searched full:depending (Results 1 – 25 of 2250) sorted by relevance

12345678910>>...90

/linux/Documentation/hwmon/
H A Dgsc-hwmon.rst21 The voltage inputs are scaled either internally or by the driver depending
33 either internally or by the driver depending on the GSC version and firmware.
44 PWM value will be scaled depending on 6 temperature boundaries.
H A Dadm1275.rst119 inX_label "vin1" or "vout1" depending on chip variant and
134 curr1_lcrit Critical minimum current. Depending on the chip
138 curr1_crit Critical maximum current. Depending on the chip
H A Dnct6775.rst103 PCH, and SMBUS. Depending on the chip type, 2 to 6 of the temperature sources
114 either 1 degC or 0.5 degC, depending on the temperature source and
117 value. Alarms are only supported for temp1 to temp6, depending on the chip type.
251 There are up to seven data points depending on the chip type. Subsequent data
H A Dltc2945.rst56 SENSE+ or VDD pin depending on chip configuration.
84 voltage or ADIN voltage depending on chip configuration.
/linux/drivers/mtd/spi-nor/
H A DKconfig17 Many flash memories support erasing small (4096 B) sectors. Depending
37 Depending on the flash chip this either clears the block protection
54 If the software write protection will be disabled depending on
/linux/Documentation/driver-api/thermal/
H A Dnouveau_thermal.rst41 Some of these thresholds may not be used by Nouveau depending
79 * 2; The fan is driven automatically depending on the temperature.
87 depending on your hardware.
/linux/rust/
H A Dbindgen_parameters4 # define them as `int`/`long` depending on platform bitwidth.
33 # These constants are sometimes not recognized by bindgen depending on config.
/linux/include/uapi/linux/
H A Dfalloc.h23 * smaller depending on the filesystem and/or the configuration of the
54 * boundaries, but this boundary may be larger or smaller depending on
72 * depending on the filesystem and/or the configuration of the filesystem
/linux/arch/arm64/boot/dts/qcom/
H A Dmsm8916-samsung-j3-common.dtsi44 /* GPIO pins vary depending on model variant */
48 /* GPIO pins vary depending on model variant */
/linux/Documentation/PCI/endpoint/function/binding/
H A Dpci-test.rst22 msi_interrupts Should be 1 to 32 depending on the number of MSI interrupts
24 msix_interrupts Should be 1 to 2048 depending on the number of MSI-X
/linux/Documentation/ABI/testing/
H A Dsysfs-bus-iio-adc-hi843518 Depending on in_voltageY_sensing_mode the low voltage threshold
37 Depending on in_voltageY_sensing_mode the high voltage threshold
/linux/drivers/staging/media/av7110/
H A DKconfig31 or /lib/firmware (depending on configuration of firmware hotplug).
70 or /lib/firmware (depending on configuration of firmware hotplug).
/linux/Documentation/sound/soc/
H A Dclocking.rst18 their speed can be altered by software (depending on the system use and to save
39 it is best to configure BCLK to the lowest possible speed (depending on your
H A Dpops-clicks.rst12 depending on the audio usage and this can subsequently cause a small pop or
39 playback in that components are powered in a sequence depending upon stream
H A Ddai.rst30 usually varies depending on the sample rate and the master system clock
53 receive the audio data. Bit clock usually varies depending on sample rate
/linux/Documentation/devicetree/bindings/interconnect/
H A Dinterconnect.txt15 depending on the use case. Interconnect providers can also be interconnect
42 multiple paths from different providers depending on use case and the
/linux/Documentation/misc-devices/
H A Dtps6594-pfsm.rst16 manages operational modes. Depending on the current operational mode,
65 Depending on the triggers set, some DDR/GPIO voltage domains can
H A Dapds990x.rst26 might vary quite much depending the spectrum of the light source.
68 to saturate much before that. Real max value varies depending
/linux/arch/arm/include/asm/
H A Dkasan_def.h68 * The KASAN_SHADOW_OFFSET is provided in a Kconfig option depending
71 * the shadow offset depending on this.
/linux/Documentation/netlabel/
H A Dlsm_interface.rst26 low-level packet label depending on the NetLabel build time and run time
43 Depending on the exact configuration, translation between the network packet
/linux/security/selinux/ss/
H A Dconditional.h41 * depending on the current value of the conditional expression. This
52 * two lists of rules to enable/disable depending on the value of the
/linux/Documentation/devicetree/bindings/regulator/
H A Dpalmas-pmic.txt35 For ti,palmas-pmic - smps12, smps123, smps3 depending on OTP,
36 smps45, smps457, smps7 depending on variant, smps6, smps[8-9],
/linux/Documentation/admin-guide/media/
H A Dsaa7134.rst52 Depending on the card you might have to pass ``card=<nr>`` as insmod option.
82 default might not work for you depending on which version you have.
/linux/Documentation/sound/hd-audio/
H A Drealtek-pc-beep.rst42 When zero, mix 1Ah (possibly with amplification, depending on L and R bits)
47 When one, mix 1Ah (possibly with amplification, depending on L and R bits)
97 generator and external PCBEEP pin, depending on if the beep generator is
/linux/Documentation/process/debugging/
H A Dindex.rst38 Depending on the issue, a different set of tools is available to track down the
42 Depending on the answer, your methodology and choice of tools may vary.

12345678910>>...90