| /src/sys/arm/nvidia/ |
| H A D | as3722_regulators.c | 405 rv = RM1(sc->base_sc, sc->def->volt_reg, in as3722_write_sel()
431 rv = RM1(sc->base_sc, sc->def->ext_enable_reg, in as3722_reg_extreg_setup()
441 rv = RM1(sc->base_sc, sc->def->enable_reg, in as3722_reg_enable()
451 rv = RM1(sc->base_sc, sc->def->enable_reg, in as3722_reg_disable()
473 rv = RM1(sc->base_sc, sc->def->volt_reg, in as3722_regnode_init()
|
| H A D | as3722_rtc.c | 102 rv = RM1(sc, AS3722_RTC_CONTROL, in as3722_rtc_attach()
|
| H A D | as3722_gpio.c | 467 rv = RM1(sc, AS3722_GPIO_SIGNAL_OUT, (1 << pin), (tmp << pin)); in as3722_gpio_pin_set()
519 rv = RM1(sc, AS3722_GPIO_SIGNAL_OUT, (1 << pin), tmp); in as3722_gpio_pin_toggle()
|
| H A D | as3722.h | 285 #define RM1(sc, reg, clr, set) as3722_modify(sc, reg, clr, set) macro
|
| H A D | as3722.c | 227 rv = RM1(sc, AS3722_IO_VOLTAGE, in as3722_init()
|
| /src/sys/arm64/nvidia/tegra210/ |
| H A D | max77620_regulators.c | 384 rv = RM1(sc->base_sc, sc->def->volt_reg, in max77620_set_sel()
413 rv = RM1(sc->base_sc, sc->def->fps_reg, MAX77620_FPS_SRC_MASK, in max77620_set_fps_src()
448 rv = RM1(sc->base_sc, sc->def->fps_reg, mask, val); in max77620_set_fps_slots()
473 rv = RM1(sc->base_sc, sc->def->pwr_mode_reg, sc->def->pwr_mode_shift, in max77620_set_pwr_mode()
538 rv = RM1(sc->base_sc, sc->def->cfg_reg, mask, val); in max77620_set_pwr_ramp_delay()
|
| H A D | max77620.c | 317 rv = RM1(sc, MAX77620_REG_FPS_CFG0 + i, mask, val); in max77620_init()
325 rv = RM1(sc, MAX77620_REG_INTENLBT, 0x81, 0x81); in max77620_init()
326 rv = RM1(sc, MAX77620_REG_IRQTOPM, 0x81, 0x81); in max77620_init()
|
| H A D | max77620.h | 226 #define RM1(sc, reg, clr, set) max77620_modify(sc, reg, clr, set) macro
|
| H A D | max77620_gpio.c | 600 rv = RM1(sc, sc->gpio_pins[pin]->reg, MAX77620_REG_GPIO_OUTPUT_VAL(~0), in max77620_gpio_pin_set()
649 rv = RM1(sc, sc->gpio_pins[pin]->reg, MAX77620_REG_GPIO_OUTPUT_VAL(~0), in max77620_gpio_pin_toggle()
|
| /src/sys/dev/iicbus/pmic/ |
| H A D | act8846.h | 49 #define RM1(sc, reg, clr, set) act8846_modify(sc, reg, clr, set) macro
|
| H A D | act8846_regulator.c | 261 rv = RM1(sc->base_sc, sc->def->voltage_reg, in act8846_write_sel()
285 rv = RM1(sc->base_sc, sc->def->enable_reg, in act8846_regnode_enable()
|