| /linux/Documentation/hwmon/ |
| H A D | drivetemp.rst | 24 drives with temperature sensors.
36 Reading the drive temperature may reset the spin down timer on some drives.
37 This has been observed with WD120EFAX drives, but may be seen with other
38 drives as well. The same behavior is observed if the 'hdtemp' or 'smartd'
44 drives experience similar behavior.
46 A known workaround for WD120EFAX drives is to read the drive temperature at
47 intervals larger than twice the spin-down time. Otherwise affected drives
|
| H A D | emc2305.rst | 17 The EMC2305 Fan Controller supports up to 5 independently controlled PWM fan drives.
|
| /linux/Documentation/admin-guide/blockdev/ |
| H A D | paride.rst | 13 CD-ROM, LS-120 and tape drives use the parallel port to connect to their
19 (The Iomega PPA-3 adapter used in the ZIP drives is an example of this
26 drives use the ISA replicator to interface a floppy disk controller,
38 drives or scanners. Many different devices are supported by the
43 - MicroSolutions backpack hard-drives
45 - SyQuest EZ-135, EZ-230 & SparQ drives
50 - Hewlett-Packard 5GB and 8GB tape drives
51 - Hewlett-Packard 7100 and 7200 CD-RW drives
191 3.3 Some drives need a printer reset
194 There appear to be a number of "noname" external drives o
[all...] |
| H A D | floppy.rst | 145 you have more than two floppy drives (only two can be
160 (Note: there are two valid types for ED drives. This is because 5 was
161 initially chosen to represent floppy *tapes*, and 6 for ED drives.
162 AMI ignored this, and used 5 for ED drives. That's why the floppy
183 problems. However, some older drives, and also some laptops
|
| /linux/fs/adfs/ |
| H A D | Kconfig | 10 here, Linux will be able to read from ADFS partitions on hard drives
15 /dev/[hs]d?1) on each of your drives. Please read the file
28 hard drives and ADFS-formatted floppy disks. This is experimental
|
| /linux/drivers/ata/pata_parport/ |
| H A D | Kconfig | 19 parallel port Series 5 IDE protocol. (Most BACKPACK drives made
20 before 1999 were Series 5) Series 5 drives will NOT always have the
31 parallel port Series 6 IDE protocol. (Most BACKPACK drives made
32 after 1999 were Series 6) Series 6 drives will have the Series noted
59 (low speed) adapter that is used in some portable hard drives.
125 used in some 2.5" portable hard drives.
|
| /linux/Documentation/devicetree/bindings/spi/ |
| H A D | sqi-pic32.txt | 7 - clocks: Should contain phandle of two clocks in sequence, one that drives
8 clock on SPI bus and other that drives SQI controller.
|
| /linux/Documentation/scsi/ |
| H A D | hpsa.rst | 11 driver (for logical drives) AND a SCSI driver (for tape drives). This
57 (e.g. hot-plugged tape drives, or newly configured or deleted logical drives,
62 tape drives, or entire storage boxes containing pre-configured logical drives.
|
| H A D | st.rst | 33 QIC-drives). The result is that any tape can be read, writing can be
123 The tape driver currently supports up to 2^17 drives if 4 modes for
172 The st driver maintains statistics for tape drives inside the sysfs filesystem.
295 this read command. Should be disabled for those drives that don't like
440 for SCSI-1 drives and SCSI-2 seek for SCSI-2 drives. The file and
458 SCSI mode page 15. Note that some drives other methods for
459 control of compression. Some drives (like the Exabytes) use
460 density codes for compression control. Some drives use another
462 driver. Some drives withou
[all...] |
| H A D | dc395x.rst | 9 The driver has been tested with CD-R and CD-R/W drives. These should
79 0 0x01 1 Support more than two drives. (Not used)
|
| /linux/drivers/md/ |
| H A D | Kconfig | 101 A RAID-1 set consists of several disk drives which are exact copies
105 kernel. In a set with N drives, the available space is the capacity
107 drives.
148 A RAID-5 set of N drives with a capacity of C MB per drive provides
150 of a single drive. For a given sector (row) number, (N - 1) drives
153 while a RAID-5 set distributes the parity across the drives in one
156 A RAID-6 set of N drives with a capacity of C MB per drive
158 against a failure of any two drives. For a given sector
159 (row) number, (N - 2) drives contain data sectors, and two
160 drives contain
[all...] |
| /linux/Documentation/admin-guide/device-mapper/ |
| H A D | dm-raid.rst | 124 2 drives 3 drives 4 drives
142 2 drives 3 drives 4 drives
158 2 drives 3 drives 4 drives
225 given for both the metadata and data drives fo
[all...] |
| H A D | unstriped.rst | 85 Intel NVMe drives contain two cores on the physical device.
127 unstriped on top of striped with 4 drives using 128K chunk size
|
| /linux/Documentation/devicetree/bindings/watchdog/ |
| H A D | moxa,moxart-watchdog.txt | 7 - clocks : Should contain phandle for the clock that drives the counter
|
| H A D | nuvoton,npcm-wdt.txt | 17 - clock-frequency : The frequency in Hz of the clock that drives the NPCM7xx
|
| /linux/fs/zonefs/ |
| H A D | Kconfig | 9 device (e.g. host-managed or host-aware SMR disk drives) as files.
|
| /linux/drivers/cdx/controller/ |
| H A D | Kconfig | 17 CDX controller drives the CDX bus. It interacts with
|
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-class-scsi_tape | 44 This value is presented in bytes because tape drives support
75 This value is presented in bytes because tape drives support
|
| /linux/Documentation/driver-api/md/ |
| H A D | raid5-ppl.rst | 28 array member drives in the metadata area, on the parity drive of a particular
30 reduced by up to 30%-40% but it scales with the number of drives in the array
|
| /linux/arch/powerpc/boot/dts/ |
| H A D | currituck.dts | 144 /* This drives busses 0 to 0xf */
181 /* This drives busses 0 to 0xf */
218 /* This drives busses 0 to 0xf */
|
| H A D | akebono.dts | 272 /* This drives busses 0 to 0xf */
312 /* This drives busses 0 to 0xf */
352 /* This drives busses 0 to 0xf */
392 /* This drives busses 0 to 0xf */
|
| /linux/Documentation/driver-api/nfc/ |
| H A D | nfc-pn544.rst | 10 communication. The driver goes under drives/nfc/ and is compiled as a
|
| /linux/Documentation/userspace-api/ioctl/ |
| H A D | hdio.rst | 89 Not particularly useful with modern disk drives, whose geometry
90 is a polite fiction anyway. Modern drives are addressed
99 ioctl will not return a meaningful value on drives with more
257 except for four drives per port chipsets. For four drives
|
| /linux/drivers/media/dvb-frontends/ |
| H A D | dib8000.h | 31 u16 drives; member
|
| /linux/drivers/usb/storage/ |
| H A D | Kconfig | 14 floppy drives, USB hard disks, USB tape drives, USB CD-ROMs,
90 - HP 8200e/8210e/8230e CD-Writer Plus drives
|