| /linux/Documentation/networking/ |
| H A D | can_ucan_protocol.rst | 22 The driver sends device management commands on this endpoint
25 The device sends CAN data frames and CAN error frames
28 The driver sends CAN data frames on the out endpoint
303 error frames (see ``uapi/linux/can/error.h``) and sends it using the
318 - Once Bus OFF recover is completed the device sends an error frame
328 #) Host sends command ``UCAN_COMMAND_RESET``, subcmd 0
329 #) Host sends command ``UCAN_COMMAND_GET``, subcmd ``UCAN_COMMAND_GET_INFO``
330 #) Device sends ``UCAN_IN_DEVICE_INFO``
331 #) Host sends command ``UCAN_OUT_SET_BITTIMING``
332 #) Host sends command ``UCAN_COMMAND_START``, subcmd 0, mode ``UCAN_MODE_BERR_REPORT``
|
| /linux/tools/testing/selftests/net/packetdrill/ |
| H A D | tcp_fastopen_server_client-ack-dropped-then-recovery-ms-timestamps.pkt | 6 // - Fast Open server receives TFO SYN with data, sends SYNACK
7 // - (client receives SYNACK and sends ACK, but ACK is lost)
8 // - server app sends some data packets
|
| H A D | tcp_zerocopy_epoll_edge.pkt | 7 // fire two sends with MSG_ZEROCOPY and receive the acks. confirm that EPOLLERR
40 // receive only one EPOLLERR for the two sends above.
|
| H A D | tcp_zerocopy_epoll_oneshot.pkt | 7 // fire two sends with MSG_ZEROCOPY and receive the acks. confirm that EPOLLERR
41 // receive only one EPOLLERR for the two sends above.
|
| H A D | tcp_zerocopy_epoll_exclusive.pkt | 8 // fire two sends with MSG_ZEROCOPY and receive the acks. confirm that EPOLLERR
42 // receive only one EPOLLERR for the two sends above.
|
| H A D | tcp_accecn_3rd_ack_after_synack_rxmt.pkt | 16 // Our code currently sends a challenge ACK
|
| H A D | tcp_basic_server.pkt | 23 // Peer sends data: acknowledge and receive
|
| H A D | tcp_slow_start_slow-start-ack-per-4pkt.pkt | 4 // In this variant, the receiver sends one ACK per 4 packets.
|
| H A D | tcp_close_close-remote-fin-then-close.pkt | 2 // Verify behavior for the sequence: remote side sends FIN, then we close().
|
| H A D | tcp_zerocopy_fastopen-server.pkt | 20 // Client sends a SYN with data.
|
| /linux/Documentation/sound/cards/ |
| H A D | serial-u16550.rst | 18 sends the nonstandard MIDI command sequence F5 NN, where NN is the substream
37 module parameter is automatically set to 1. The driver sends the same data to
49 the outs module parameter is automatically set to 1. The driver sends
62 Out 3, and midiCnD8 to Out 4. Thus midiCnD15 sends the data to all 4 ports.
63 As a special case, midiCnD0 also sends to all ports, since it is not useful
|
| /linux/sound/soc/xilinx/ |
| H A D | Kconfig | 9 mode, IP receives audio in AES format, extracts PCM and sends
11 encapsulates PCM in AES format and sends AES data.
|
| /linux/Documentation/admin-guide/ |
| H A D | edid.rst | 18 - The monitor sends no or bogus EDID data.
19 - A KVM sends its own EDID data instead of querying the connected monitor.
|
| /linux/Documentation/userspace-api/ |
| H A D | tee.rst | 38 supplicants the communication goes in the other direction, the TEE sends
39 requests to the supplicant which then sends back the result.
|
| /linux/Documentation/misc-devices/ |
| H A D | ibmvmc.rst | 152 RDMA of the HMC ID to the hypervisor, and then sends an Interface Open
154 hypervisor receives this information, it sends Add Buffer messages to the
156 connection. Finally, the hypervisor sends an Interface Open Response
181 and then sends a Signal Message. If a write() is attempted before VMC
185 state. When the hypervisor sends a message to the management, the data is
|
| /linux/Documentation/driver-api/mei/ |
| H A D | iamt.rst | 45 When a local application sends a message addressed to the local Intel AMT host
89 and sends an event when the heartbeats stop.
91 configures the watchdog and sends the heartbeats.
|
| H A D | hdcp.rst | 11 according the HDCP 2.2 spec. The Intel graphics sends the created blob
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | vidioc-encoder-cmd.rst | 39 ``VIDIOC_ENCODER_CMD`` sends a command to the encoder,
57 call sends an implicit START command to the encoder if it has not been
61 call of a streaming file descriptor sends an implicit immediate STOP to
|
| /linux/Documentation/arch/sparc/ |
| H A D | adi.rst | 105 first. Hypervisor creates a sun4v error report and sends a
106 resumable error (TT=0x7e) trap to the kernel. The kernel sends
125 exception is sent to the kernel with TT=0x1a. The kernel sends
143 on a memory address, processor sends an MCD disabled trap. This
147 sends the task SIGSEGV signal with following info::
|
| /linux/Documentation/ABI/testing/ |
| H A D | debugfs-cxl | 7 attribute, the memdev driver sends an inject poison command to
43 attribute, the memdev driver sends a clear poison command to
74 memdev. It then sends an inject poison command to that memdev
103 memdev. It then sends a clear poison command to that memdev
|
| /linux/drivers/hwtracing/stm/ |
| H A D | Kconfig | 54 This is a kernel space trace source that sends kernel log
63 This is a kernel space trace source that sends periodic
|
| /linux/Documentation/driver-api/md/ |
| H A D | md-cluster.rst | 240 performing resync finishes, it sends RESYNCING with an empty range to
263 2. Node 1 sends a NEWDISK message with uuid and slot number
275 8. If node 1 gets the lock, it sends METADATA_UPDATED after
277 9. If not (get "no-new-dev" lock), it fails the operation and sends
319 resync_finish() also sends a BITMAP_NEEDS_SYNC message which
367 This sends a RE_ADD message to all other nodes and then
|
| /linux/Documentation/virt/hyperv/ |
| H A D | vmbus.rst | 114 * Unidirectional: Either side sends a message and does not
116 * Request/response: One side (usually the guest) sends a message
122 sending a request. Hyper-V sends back the same transactionID in the
204 ring buffer transitions from empty to non-empty. If the guest sends
206 unnecessary. If a guest sends an excessive number of unnecessary
211 it sends a new message on the VMBus control path, or when a VMBus
289 The guest then tells Hyper-V to "send offers". Hyper-V sends an
337 sends a rescind message when the primary channel is closed,
|
| /linux/Documentation/staging/ |
| H A D | rpmsg.rst | 73 sends a message across to the remote processor from the given endpoint.
93 sends a message across to the remote processor from a given endpoint,
117 sends a message across to the remote processor from a given endpoint.
135 sends a message across to the remote processor from a given endpoint,
221 The following is a simple rpmsg driver, that sends an "hello!" message
|
| /linux/Documentation/driver-api/ |
| H A D | ipmb.rst | 19 sends IPMI requests to a device (usually a Satellite Management
21 sends a response back to the BMC.
|