| /linux/drivers/i2c/muxes/ |
| H A D | Kconfig | 23 tristate "GPIO-based I2C multiplexer" 27 GPIO based I2C multiplexer. This driver provides access to 35 tristate "General Purpose I2C multiplexer" 40 general purpose I2C multiplexer. This driver provides access to 48 tristate "LTC LTC4306/5 I2C multiplexer" 78 tristate "pinctrl-based I2C multiplexer" 83 multiplexer that uses the pinctrl subsystem, i.e. pin multiplexing. 91 tristate "Register-based I2C multiplexer" 95 register based I2C multiplexer. This driver provides access to 112 tristate "Mellanox CPLD based I2C multiplexer" [all …]
|
| /linux/drivers/net/mdio/ |
| H A D | Kconfig | 205 tristate "Amlogic G12a based MDIO bus multiplexer" 211 This module provides a driver for the MDIO multiplexer/glue of 216 tristate "Amlogic GXL based MDIO bus multiplexer" 222 This module provides a driver for the MDIO multiplexer/glue of 223 the amlogic GXL SoC. The multiplexer connects either the external 233 BCM6368 based Broadcom SoCs. This multiplexer connects one of several 235 external and selection logic lies inside the same multiplexer. 244 iProc based Broadcom SoCs. This multiplexer connects one of several 246 external and selection logic lies inside the same multiplexer. 254 are controlled via GPIO lines. The multiplexer connects one of [all …]
|
| H A D | Makefile | 36 obj-$(CONFIG_MDIO_BUS_MUX_MULTIPLEXER) += mdio-mux-multiplexer.o
|
| /linux/drivers/mux/ |
| H A D | Kconfig | 28 ADGS1408 8:1 multiplexer and ADGS1409 double 4:1 multiplexer 40 The driver builds a single multiplexer controller using a number 41 of gpio pins. For N pins, there will be 2^N possible multiplexer 55 The driver builds multiplexer controllers for bitfields in either 57 bitfields, there will be 2^N possible multiplexer states.
|
| /linux/Documentation/devicetree/bindings/iio/adc/ |
| H A D | xilinx-xadc.txt | 38 * "none": No external multiplexer is used, this is the default 40 * "single": External multiplexer mode is used with one 41 multiplexer. 42 * "dual": External multiplexer mode is used with two 46 Valid values for single external multiplexer mode are: 52 Valid values for dual external multiplexer mode are: 59 external multiplexer mode (either single or dual). If the device is 60 not using external multiplexer mode the property is ignored.
|
| /linux/drivers/dma/stm32/ |
| H A D | Kconfig | 18 bool "STMicroelectronics STM32 DMA multiplexer support" 21 Enable support for the on-chip DMA multiplexer on STMicroelectronics 23 If you have a board based on STM32 SoC with such DMA multiplexer
|
| /linux/drivers/iio/multiplexer/ |
| H A D | Kconfig | 10 tristate "IIO multiplexer driver" 13 Say yes here to build support for the IIO multiplexer.
|
| /linux/Documentation/hwmon/ |
| H A D | da9055.rst | 18 multiplexer. The analogue input multiplexer will allow conversion of up to 5
|
| H A D | da9052.rst | 19 multiplexer. The analogue input multiplexer will allow conversion of up to 10
|
| /linux/Documentation/devicetree/bindings/i2c/ |
| H A D | i2c-mux-reg.txt | 3 This binding describes an I2C bus multiplexer that uses a single register 8 - i2c-parent: The phandle of the I2C bus that this multiplexer's master-side
|
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-adc-mcp3564 | 21 This attribute is used to enable the analog input multiplexer 22 auto-zeroing algorithm (the input multiplexer and the ADC
|
| H A D | sysfs-bus-i2c-devices-pca954x | 7 written to control the behaviour of the multiplexer on
|
| /linux/drivers/gpu/vga/ |
| H A D | Kconfig | 10 Many laptops released in 2008/9/10 have two GPUs with a multiplexer
|
| /linux/drivers/iio/ |
| H A D | Makefile | 38 obj-y += multiplexer/
|
| H A D | Kconfig | 102 source "drivers/iio/multiplexer/Kconfig"
|
| /linux/arch/arm64/boot/dts/freescale/ |
| H A D | fsl-lx2162a-qds.dts | 34 compatible = "mdio-mux-multiplexer"; 114 compatible = "mdio-mux-multiplexer";
|
| H A D | fsl-lx2160a-qds.dts | 36 compatible = "mdio-mux-multiplexer"; 114 compatible = "mdio-mux-multiplexer";
|
| /linux/drivers/usb/roles/ |
| H A D | Kconfig | 9 multiplexer/demultiplexer switch is used to route the data lines on
|
| /linux/Documentation/devicetree/bindings/clock/st/ |
| H A D | st,clkgen.txt | 4 A Clockgen node can contain pll, diviser or multiplexer nodes.
|
| /linux/arch/arm64/boot/dts/ti/ |
| H A D | k3-am642-evm-icssg1-dualemac.dtso | 20 compatible = "mdio-mux-multiplexer";
|
| H A D | k3-am642-evm-icssg1-dualemac-mii.dtso | 19 compatible = "mdio-mux-multiplexer";
|
| /linux/drivers/pinctrl/stm32/ |
| H A D | Kconfig | 71 It uses configurable multiplexer to route signals in a dedicated observation register.
|
| /linux/drivers/staging/media/atomisp/pci/hive_isp_css_common/host/ |
| H A D | input_system.c | 784 input_system_network_cfg.mux_cfg = config.multiplexer; in configuration_to_registers() 1110 status = input_system_multiplexer_cfg(&config.multiplexer, mux, in input_system_configure_channel_sensor() 1125 status = input_system_multiplexer_cfg(&config.multiplexer, mux, in input_system_configure_channel_sensor() 1140 status = input_system_multiplexer_cfg(&config.multiplexer, mux, in input_system_configure_channel_sensor()
|
| /linux/drivers/staging/media/atomisp/pci/ |
| H A D | isp2400_input_system_local.h | 59 input_system_multiplex_t multiplexer; member
|
| /linux/Documentation/iio/ |
| H A D | ad7380.rst | 138 Single-ended chips of this family (ad7386/7/8(-4)) have a 2:1 multiplexer in 141 the multiplexer inputs.
|