| /linux/Documentation/ABI/stable/ |
| H A D | sysfs-firmware-opal-elog | 24 entries, read them out and acknowledge them.
27 entries than firmware can, so after you acknowledge
55 acknowledge: Writing 'ack' to this file will acknowledge
61 operations (currently just acknowledge).
|
| H A D | sysfs-firmware-opal-dump | 39 acknowledge: When 'ack' is written to this, we will
40 acknowledge that we've retrieved the
|
| /linux/Documentation/images/ |
| H A D | COPYING-logo | 4 and is freely usable as long as you acknowledge Larry as the original
16 as long as you acknowledge Larry, Garrett and IFo as above.
|
| /linux/Documentation/devicetree/bindings/mailbox/ |
| H A D | hisilicon,hi6220-mailbox.txt | 27 mailbox driver uses it to acknowledge interrupt
36 flag" mode or IRQ generated mode to acknowledge a TX
|
| /linux/Documentation/driver-api/ |
| H A D | connector.rst | 73 acknowledge number. The sequence number may be copied into
80 acknowledge number MUST be the same + 1.
85 acknowledge is not equal to the sequence number in the original
|
| /linux/net/nfc/nci/ |
| H A D | spi.c | 146 static int send_acknowledge(struct nci_spi *nspi, u8 acknowledge) in send_acknowledge() argument
161 hdr[2] = acknowledge << NCI_SPI_ACK_SHIFT; in send_acknowledge()
|
| /linux/tools/testing/selftests/net/packetdrill/ |
| H A D | tcp_basic_server.pkt | 23 // Peer sends data: acknowledge and receive
|
| /linux/drivers/net/arcnet/ |
| H A D | Kconfig | 59 acknowledge back to userspace. After the initial protocol byte every
64 0=no hardware acknowledge
|
| /linux/arch/powerpc/kernel/ |
| H A D | prom_init.c | 2136 unsigned long *acknowledge in prom_hold_cpus() local
2156 (unsigned long)acknowledge); in prom_hold_cpus()
2157 prom_debug(" 1) *acknowledge = 0x%lx\n", *acknowledge); in prom_hold_cpus()
2192 *acknowledge = (unsigned long)-1; in prom_hold_cpus()
2201 (*acknowledge == ((unsigned long)-1)); i++ ) in prom_hold_cpus()
2204 if (*acknowledge == cpu_no) in prom_hold_cpus()
2207 prom_printf("failed: %lx\n", *acknowledge); in prom_hold_cpus()
|
| /linux/Documentation/arch/arm/ |
| H A D | interrupts.rst | 154 acknowledge the SA1110 IRQ each time you re-read the SA1111 IRQ status.
157 (eg, SMC9196), the handler must mask or acknowledge the parent IRQ
|
| /linux/arch/powerpc/boot/dts/ |
| H A D | amigaone.dts | 51 8259-interrupt-acknowledge = <0xfef00000>;
|
| H A D | mvme5100.dts | 93 8259-interrupt-acknowledge = <0xfeff0030>;
|
| /linux/Documentation/w1/ |
| H A D | w1-netlink.rst | 187 Each message also includes sequence and acknowledge numbers.
192 acknowledge number is set to seq+1.
|
| /linux/arch/powerpc/platforms/powernv/ |
| H A D | opal-elog.c | 91 __ATTR(acknowledge, 0660, elog_ack_show, elog_ack_store);
|
| H A D | opal-dump.c | 111 __ATTR(acknowledge, 0660, dump_ack_show, dump_ack_store);
|
| /linux/Documentation/networking/device_drivers/cellular/qualcomm/ |
| H A D | rmnet.rst | 185 1 is to acknowledge the receipt of a command
|
| /linux/Documentation/driver-api/surface_aggregator/ |
| H A D | ssh.rst | 121 - Sent to acknowledge receival of |DATA| frame.
143 |DATA_SEQ|-type frame, the receiving party has to acknowledge receival of
|
| /linux/Documentation/arch/arm/stm32/ |
| H A D | stm32-dma-mdma-chaining.rst | 200 4. The 32bit value specifying the register to be used to acknowledge the
205 5. The 32bit mask specifying the value to be written to acknowledge the
|
| /linux/Documentation/usb/ |
| H A D | CREDITS | 98 way to acknowledge the importance of Linux and to allow
|
| /linux/drivers/infiniband/sw/rxe/ |
| H A D | rxe_resp.c | 1233 static enum resp_states acknowledge(struct rxe_qp *qp, in acknowledge() function
1573 state = acknowledge(qp, pkt); in rxe_receiver()
|
| /linux/drivers/net/wireless/marvell/mwifiex/ |
| H A D | README | 239 acknowledge required) when GPIO is used to wakeup host.
|
| /linux/Documentation/networking/ |
| H A D | msg_zerocopy.rst | 162 For protocols that acknowledge data in-order, like TCP, each
|
| H A D | j1939.rst | 102 acknowledge the transfer.
112 process the incoming data and acknowledge each step of the transfer.
141 transfer. The receiver must acknowledge the transfer for the session to
|
| /linux/drivers/base/firmware_loader/ |
| H A D | Kconfig | 116 acknowledge failure to find firmware as the timeout for the fallback
|
| /linux/drivers/crypto/inside-secure/ |
| H A D | safexcel.c | 1037 goto acknowledge; in safexcel_handle_result_descriptor()
1050 acknowledge: in safexcel_handle_result_descriptor()
|