Searched refs:PSI (Results 1 – 19 of 19) sorted by relevance
| /linux/Documentation/networking/devlink/ |
| H A D | iosm.rst | 49 * - ``PSI RAM``
56 PSI RAM and EBL are the RAM images which are injected to the device when the
70 1) When modem is in Boot ROM stage, user can use below command to inject PSI RAM
80 3) Inject EBL after the modem is in PSI stage.
|
| /linux/Documentation/driver-api/media/drivers/ |
| H A D | vidtv.rst | 144 This is the PSI generator. PSI packets contain general information
145 about a MPEG Transport Stream. A PSI generator is needed so
152 Currently vidtv supports working with 5 PSI tables: PAT, PMT,
161 debugging PSI tables. Vidtv currently tries to replicate the PSI
222 #. Inserting PSI and/or PCR packets, if needed.
349 In order to tune into a channel and read the PSI tables, we can use dvb-scan.
|
| /linux/Documentation/translations/zh_CN/accounting/ |
| H A D | psi.rst | 10 PSI——压力阻塞信息
|
| /linux/Documentation/accounting/ |
| H A D | delay-accounting.rst | 136 which includes system-wide PSI information and Top-N high-latency tasks.
137 Note: PSI support requires `CONFIG_PSI=y` and `psi=1` for full functionality.
|
| H A D | psi.rst | 4 PSI - Pressure Stall Information
|
| /linux/Documentation/process/debugging/ |
| H A D | driver_development_debugging_guide.rst | 199 PSI (Pressure stall information tracking)
204 PSI is a measurement tool to identify excessive overcommits on hardware
|
| /linux/Documentation/networking/device_drivers/ethernet/ti/ |
| H A D | icssg_prueth.rst | 53 - ``FW_HOST_RX_PKT_CNT``: Number of valid packets sent by Rx PRU to Host on PSI
|
| /linux/include/linux/ |
| H A D | scmi_protocol.h | 413 PSI = 0x10, enumerator
|
| /linux/arch/powerpc/boot/dts/ |
| H A D | fsp2.dts | 86 /* PSI and DMA */
|
| /linux/Documentation/admin-guide/mm/damon/ |
| H A D | reclaim.rst | 127 memory pressure is incurred. System-wide ``some`` memory PSI in microseconds
|
| /linux/drivers/gpu/drm/amd/pm/swsmu/smu13/ |
| H A D | smu_v13_0_4_ppt.c | 131 FEA_MAP(PSI),
|
| H A D | yellow_carp_ppt.c | 127 FEA_MAP(PSI),
|
| /linux/drivers/gpu/drm/amd/pm/swsmu/smu15/ |
| H A D | smu_v15_0_0_ppt.c | 143 FEA_MAP(PSI),
|
| /linux/Documentation/admin-guide/ |
| H A D | cgroup-v2.rst | 1070 Writing "0" to the file will disable the cgroup PSI accounting.
1071 Writing "1" to the file will re-enable the cgroup PSI accounting.
1073 This control attribute is not hierarchical, so disable or enable PSI
1074 accounting in a cgroup does not affect PSI accounting in descendants
1077 The reason this control attribute exists is that PSI accounts stalls for
1081 be used to disable PSI accounting in the non-leaf cgroups.
|
| /linux/drivers/gpu/drm/amd/pm/swsmu/smu14/ |
| H A D | smu_v14_0_0_ppt.c | 167 FEA_MAP(PSI),
|
| /linux/drivers/gpu/drm/amd/pm/swsmu/smu11/ |
| H A D | vangogh_ppt.c | 170 FEA_MAP(PSI),
|
| /linux/init/ |
| H A D | Kconfig | 711 config PSI config
734 depends on PSI
|
| /linux/Documentation/mm/damon/ |
| H A D | design.rst | 575 time (PSI) could be examples. Note that users should explicitly set
|
| /linux/ |
| H A D | MAINTAINERS | 21110 PRESSURE STALL INFORMATION (PSI)
|