Home
last modified time | relevance | path

Searched refs:MIPI (Results 1 – 25 of 122) sorted by relevance

12345

/linux/Documentation/admin-guide/media/
H A Dc3-isp.rst29 - 1 MIPI-CSI-2 module: handles the physical layer of the MIPI CSI-2 receiver and
31 - 1 MIPI-ADAPTER module: organizes MIPI data to meet ISP input requirements and
32 send MIPI data to ISP.
42 | Sensor |--->| MIPI CSI-2 |--->| MIPI ADAPTER |--->| ISP |---|----------+ +-------+
56 - 1 `c3-mipi-csi2` sub-device - the MIPI CSI-2 receiver
57 - 1 `c3-mipi-adapter` sub-device - the MIPI adapter
H A Dstarfive_camss.rst31 | MIPI |----->| |----->| ISP |----->| |
42 - MIPI: The MIPI interface, receiving data from a MIPI CSI-2 camera sensor.
72 - imx219: an image sensor, image data is sent through MIPI CSI-2.
H A Drkcif.rst17 * the interface block for the MIPI CSI-2 receiver
21 * MIPI CSI-2 receiver (not available on all variants): This unit is referred
22 to as MIPI CSI HOST in the Rockchip documentation.
35 variants), e.g., for MIPI CSI-2 Virtual Channels (VCs)
58 The RK3568 Video Capture (VICAP) unit features a digital video port and a MIPI
63 Similarly, the RK3568 VICAP MIPI CSI-2 receiver features four DMA engines to
H A Dimx7.rst16 - MIPI CSI-2 Receiver
20 MIPI Camera Input ---> MIPI CSI-2 --- > |\
39 This is the MIPI CSI-2 receiver entity. It has one sink pad to receive the pixel
40 data from MIPI CSI-2 camera sensor. It has one source pad, corresponding to the
48 sensor with a parallel interface or from MIPI CSI-2 virtual channel 0. It has
55 can interface directly with Parallel and MIPI CSI-2 buses. It has 256 x 64 FIFO
76 On this platform an OV2680 MIPI CSI-2 module is connected to the internal MIPI
H A Dplatform-cardlist.rst22 cdns-csi2rx Cadence MIPI-CSI2 RX Controller
23 cdns-csi2tx Cadence MIPI-CSI2 TX Controller
43 rcar-csi2 R-Car MIPI CSI-2 Receiver
52 s5p-csis S5P/EXYNOS MIPI-CSI2 receiver (MIPI-CSIS)
H A Dimx.rst32 camera sensors over Parallel, BT.656/1120, and MIPI CSI-2 buses.
66 - MIPI CSI-2 Receiver for camera sensors with the MIPI CSI-2 bus
84 - Supports parallel, BT.565, and MIPI CSI-2 interfaces.
115 MIPI CSI-2 OV5640 sensor, requires the i.MX6 MIPI CSI-2 receiver. But
117 therefore does not require the MIPI CSI-2 receiver, so it is missing in
140 This is the MIPI CSI-2 receiver entity. It has one sink pad to receive
141 the MIPI CSI-2 stream (usually from a MIPI CSI-2 camera sensor). It has
142 four source pads, corresponding to the four MIPI CSI-2 demuxed virtual
146 This entity actually consists of two sub-blocks. One is the MIPI CSI-2
147 core. This is a Synopsys Designware MIPI CSI-2 core. The other sub-block
[all …]
/linux/Documentation/driver-api/media/drivers/ccs/
H A Dccs.rst7 MIPI CCS camera sensor driver
10 The MIPI CCS camera sensor driver is a generic driver for `MIPI CCS
19 The MIPI CCS driver supports CCS static data for all compliant devices,
35 vvvv or vv denotes MIPI and SMIA manufacturer IDs respectively, mmmm model ID
41 `CCS tools <https://github.com/MIPI-Alliance/ccs-tools/>`_ is a set of
49 The ccs-regs.asc file contains MIPI CCS register definitions that are used
78 The PLL model implemented by the PLL calculator corresponds to MIPI CCS 1.1.
/linux/drivers/media/platform/amlogic/c3/mipi-adapter/
H A DKconfig4 tristate "Amlogic C3 MIPI adapter"
12 Video4Linux2 driver for Amlogic C3 MIPI adapter.
13 C3 MIPI adapter mainly responsible for organizing
14 MIPI data and sending raw data to ISP pipeline.
/linux/drivers/media/platform/amlogic/c3/mipi-csi2/
H A DKconfig4 tristate "Amlogic C3 MIPI CSI-2 receiver"
12 Video4Linux2 driver for Amlogic C3 MIPI CSI-2 receiver.
13 C3 MIPI CSI-2 receiver is used to receive MIPI data from
/linux/drivers/phy/amlogic/
H A DKconfig41 tristate "Meson G12A MIPI Analog DPHY driver"
48 Enable this to support the Meson MIPI Analog DPHY found in Meson G12A
81 Enable this to support the Meson MIPI + PCIE PHY found
86 tristate "Meson AXG MIPI + PCIE analog PHY driver"
93 Enable this to support the Meson MIPI + PCIE analog PHY
98 tristate "Meson AXG MIPI DPHY driver"
105 Enable this to support the Meson MIPI DPHY found in Meson AXG
/linux/drivers/media/platform/cadence/
H A DKconfig6 tristate "Cadence MIPI-CSI2 RX Controller"
14 Support for the Cadence MIPI CSI2 Receiver controller.
20 tristate "Cadence MIPI-CSI2 TX Controller"
26 Support for the Cadence MIPI CSI2 Transceiver controller.
/linux/Documentation/devicetree/bindings/media/i2c/
H A Dtoshiba,tc358743.txt1 * Toshiba TC358743 HDMI-RX to MIPI CSI2-TX Bridge
3 The Toshiba TC358743 HDMI-RX to MIPI CSI2-TX (H2C) is a bridge that converts
4 a HDMI stream to MIPI CSI-2 TX. It is programmable through I2C.
20 MIPI CSI-2 clock is continuous or non-continuous.
25 For further information on the MIPI CSI-2 endpoint node properties, see
/linux/drivers/phy/rockchip/
H A DKconfig13 tristate "Rockchip MIPI Synopsys DPHY RX0 driver"
18 Enable this to support the Rockchip MIPI Synopsys DPHY RX0
52 tristate "Rockchip Innosilicon MIPI CSI PHY driver"
57 Enable this to support the Rockchip MIPI CSI PHY with
61 tristate "Rockchip Innosilicon MIPI/LVDS/TTL PHY driver"
66 Enable this to support the Rockchip MIPI/LVDS/TTL PHY with
87 tristate "Rockchip Samsung MIPI DCPHY driver"
92 Enable this to support the Rockchip MIPI DCPHY with
/linux/Documentation/driver-api/soundwire/
H A Dsummary.rst5 SoundWire is a new interface ratified in 2015 by the MIPI Alliance.
58 The MIPI SoundWire specification uses the term 'device' to refer to a Master
69 Programs all the MIPI-defined Slave registers. Represents a SoundWire
77 Driver controlling the Slave device. MIPI-specified registers are controlled
91 Bus implements API to read standard Master MIPI properties and also provides
133 MIPI specification, so Bus calls the "sdw_master_port_ops" callback
141 The MIPI specification requires each Slave interface to expose a unique
154 board-file, ACPI or DT. The MIPI Software specification defines additional
181 For capabilities, Bus implements API to read standard Slave MIPI properties
190 SoundWire MIPI specification 1.1 is available at:
[all …]
/linux/drivers/hwtracing/stm/
H A DKconfig7 Trace Protocol (STP) format as defined by MIPI STP standards.
20 exclusively until the MIPI SyS-T support was added. Use this
23 The receiving side only needs to be able to decode the MIPI
30 tristate "MIPI SyS-T STM framing protocol driver"
33 This is an implementation of MIPI SyS-T protocol to be used
39 addition to the MIPI STP, in order to extract the data.
/linux/Documentation/trace/
H A Dsys-t.rst4 MIPI SyS-T over STP
7 The MIPI SyS-T protocol driver can be used with STM class devices to
11 In order to use the MIPI SyS-T protocol driver with your STM device,
33 Now, with the MIPI SyS-T protocol driver, each policy node in the
52 MIPI SyS-T message header. It is off by default as the STP already
/linux/Documentation/userspace-api/media/v4l/
H A Dmetafmt-generic.rst62 The packing of the data follows the MIPI CSI-2 specification and the padding of
63 the data is defined in the MIPI CCS specification.
106 The packing of the data follows the MIPI CSI-2 specification and the padding of
107 the data is defined in the MIPI CCS specification.
152 The packing of the data follows the MIPI CSI-2 specification and the padding of
153 the data is defined in the MIPI CCS specification.
195 The packing of the data follows the MIPI CSI-2 specification and the padding of
196 the data is defined in the MIPI CCS specification.
244 The packing of the data follows the MIPI CSI-2 specification and the padding of
245 the data is defined in the MIPI CCS specification.
[all …]
/linux/drivers/i3c/master/
H A DKconfig26 Support for Synopsys DesignWare MIPI I3C Controller.
56 tristate "MIPI I3C Host Controller Interface driver (EXPERIMENTAL)"
59 Support for hardware following the MIPI Aliance's I3C Host Controller
69 tristate "MIPI I3C Host Controller Interface PCI support"
74 Support for MIPI I3C Host Controller Interface compatible hardware
/linux/drivers/media/platform/synopsys/
H A DKconfig6 tristate "Synopsys DesignWare MIPI CSI-2 Receiver"
15 The Synopsys DesignWare MIPI CSI-2 Receiver is a CSI-2 bridge with
17 help of an external MIPI PHY (C-PHY or D-PHY) and passes it to e.g.,
/linux/drivers/media/platform/nxp/
H A DKconfig21 tristate "NXP i.MX8MQ MIPI CSI-2 receiver"
28 Video4Linux2 driver for the MIPI CSI-2 receiver found on the i.MX8MQ
32 tristate "NXP MIPI CSI-2 CSIS receiver found on i.MX7 and i.MX8 models"
39 Video4Linux2 sub-device driver for the MIPI CSI-2 CSIS receiver
/linux/drivers/gpu/drm/panel/
H A DKconfig56 uses 24 bit RGB per pixel. It provides a MIPI DSI interface to
67 24 bit RGB per pixel. It provides a MIPI DSI interface to
87 resolution and uses 24 bit RGB per pixel. It provides a MIPI DSI
116 The panel has a resolution of 1080x2246. It provides a MIPI DSI
126 KD35T133 controller for 320x480 LCD panels with MIPI-DSI
136 4-lane 800x1280 MIPI DSI panel.
139 tristate "Feiyang FY07024DI26A30-D MIPI-DSI LCD panel"
145 Feiyang FY07024DI26A30-D MIPI-DSI interface.
174 7.0" 1200x1920 IPS LCD panel that uses a MIPI-DSI interface
207 tristate "HIMAX HX8394 MIPI-DSI LCD panels"
[all …]
/linux/drivers/media/platform/samsung/exynos4-is/
H A DKconfig36 tristate "S5P/EXYNOS MIPI-CSI2 receiver (MIPI-CSIS) driver"
41 This is a V4L2 driver for Samsung S5P and EXYNOS4 SoC MIPI-CSI2
42 receiver (MIPI-CSIS) devices.
/linux/drivers/media/i2c/ccs/
H A DKconfig3 tristate "MIPI CCS/SMIA++/SMIA sensor support"
8 This is a generic driver for MIPI CCS, SMIA++ and SMIA compliant
/linux/Documentation/userspace-api/media/drivers/
H A Dccs.rst7 MIPI CCS camera sensor driver
10 The MIPI CCS camera sensor driver is a generic driver for `MIPI CCS
66 The MIPI CCS driver implements a number of private controls under
67 ``V4L2_CID_USER_BASE_CCS`` to control the MIPI CCS compliant camera sensors.
/linux/drivers/media/platform/sunxi/sun8i-a83t-mipi-csi2/
H A DKconfig3 tristate "Allwinner A83T MIPI CSI-2 Controller and D-PHY Driver"
14 Support for the Allwinner A83T MIPI CSI-2 controller and D-PHY.

12345