Searched full:wiring (Results 1 – 25 of 82) sorted by relevance
1234
| /linux-6.8/Documentation/devicetree/bindings/display/tilcdc/ |
| D | tilcdc.txt | 20 - blue-and-red-wiring: Recognized values "straight" or "crossed".
23 - "straight" indicates normal wiring that supports RGB565,
25 - "crossed" indicates wiring that has blue and red wires
30 RGB888 and XRGB8888 formats. However, depending on wiring, the red
43 [1] There is an errata about AM335x color wiring. For 16-bit color mode
45 but for 24 bit color modes the wiring of blue and red components is
60 blue-and-red-wiring = "crossed";
|
| /linux-6.8/Documentation/admin-guide/auxdisplay/ |
| D | ks0108.rst | 15 3. WIRING
42 3. Wiring
45 The driver supports data parallel port wiring.
48 your LCD specific wiring information in the same folder.
|
| D | cfag12864b.rst | 15 3. WIRING
44 3. Wiring
47 The cfag12864b LCD Series don't have official wiring.
49 The common wiring is done to the parallel port as shown::
|
| /linux-6.8/Documentation/devicetree/bindings/display/ |
| D | atmel,lcdc.txt | 61 - atmel,lcd-wiring-mode: lcd wiring mode "RGB" or "BRG"
71 atmel,lcd-wiring-mode = <1>;
|
| /linux-6.8/drivers/auxdisplay/ |
| D | Kconfig | 276 1 : custom configuration and wiring (see further)
277 2 : 2x16 & 2x40 parallel LCD (old wiring)
279 4 : 2x16 parallel LCD (Hantronix wiring)
280 5 : 2x16 parallel LCD (Nexcom wiring)
283 more precise aspects (wiring, dimensions, protocol, ...). Please note
|
| /linux-6.8/arch/arm/boot/dts/ti/omap/ |
| D | am335x-boneblack-hdmi.dtsi | 61 blue-and-red-wiring = "straight";
81 /* Convert 24bit BGR to RGB, e.g. cross red and blue wiring */
|
| D | am335x-osd3358-sm-red.dts | 43 * AM335x errata for wiring:
47 blue-and-red-wiring = "straight";
65 /* Convert 24bit BGR to RGB, e.g. cross red and blue wiring */
|
| /linux-6.8/Documentation/devicetree/bindings/serial/ |
| D | digicolor-usart.txt | 5 the binding that matches the wiring of your system.
|
| D | serial.yaml | 70 UART hardware and the board wiring.
|
| /linux-6.8/drivers/staging/fbtft/ |
| D | fb_hx8357d.h | 6 * Check out the links above for our tutorials and wiring diagrams
|
| /linux-6.8/drivers/net/plip/ |
| D | Kconfig | 23 time (mode 1); you can find the wiring of these cables in
|
| /linux-6.8/include/linux/platform_data/ |
| D | hsmmc-omap.h | 38 /* set if your board has components or wiring that limits the
|
| D | mmc-omap.h | 19 /* set if your board has components or wiring that limits the
|
| /linux-6.8/arch/hexagon/kernel/ |
| D | irq_cpu.c | 59 * interrupts handled here. The precise wiring of these other
|
| /linux-6.8/Documentation/devicetree/bindings/arm/omap/ |
| D | crossbar.txt | 24 SOC-specific hard-wiring of those irqs which unexpectedly bypasses the
|
| /linux-6.8/arch/sh/mm/ |
| D | tlb-urb.c | 4 * TLB entry wiring helpers for URB-equipped parts.
|
| /linux-6.8/arch/mips/include/asm/dec/ |
| D | ioasic_ints.h | 26 * unused) and has a different SCC wiring.
|
| /linux-6.8/arch/arc/include/asm/ |
| D | cache.h | 21 * Ideal for wiring memory mapped peripherals as we don't need to do
|
| /linux-6.8/Documentation/hwmon/ |
| D | sht3x.rst | 40 addresses 0x44 or 0x45 (0x4a or 0x4b for sts3x), depending on the wiring. See
|
| /linux-6.8/Documentation/networking/caif/ |
| D | caif.rst | 134 E.g. host and modem wiring is not correct you will typically see
|
| /linux-6.8/Documentation/devicetree/bindings/spi/ |
| D | spi-peripheral-props.yaml | 109 the throughput while greatly complexifying the wiring because as
|
| /linux-6.8/Documentation/devicetree/bindings/gpio/ |
| D | gpio.txt | 62 - Bit 1: 0 mean push-pull wiring, see:
64 1 means single-ended wiring, see:
|
| /linux-6.8/drivers/staging/media/atomisp/pci/runtime/isys/src/ |
| D | rx.c | 594 /* MW: A bit of a hack, straight wiring of the capture in ia_css_isys_rx_configure()
609 * AM: A bit of a hack, wiring the input system. in ia_css_isys_rx_configure()
|
| /linux-6.8/arch/arm/boot/dts/microchip/ |
| D | at91sam9rlek.dts | 45 atmel,lcd-wiring-mode = "RGB";
|
| /linux-6.8/arch/riscv/boot/dts/canaan/ |
| D | sipeed_maix_dock.dts | 29 * Note: the board wiring drawing documents green on
|
1234