| /linux-6.8/drivers/pci/pcie/ |
| D | err.c | 53 pci_ers_result_t vote; in report_error_detected() local
59 vote = PCI_ERS_RESULT_DISCONNECT; in report_error_detected()
63 vote = PCI_ERS_RESULT_NONE; in report_error_detected()
73 vote = PCI_ERS_RESULT_NO_AER_DRIVER; in report_error_detected()
76 vote = PCI_ERS_RESULT_NONE; in report_error_detected()
80 vote = err_handler->error_detected(dev, state); in report_error_detected()
82 pci_uevent_ers(dev, vote); in report_error_detected()
83 *result = merge_result(*result, vote); in report_error_detected()
101 pci_ers_result_t vote, *result = data; in report_mmio_enabled() local
112 vote = err_handler->mmio_enabled(dev); in report_mmio_enabled()
[all …]
|
| /linux-6.8/drivers/gpu/drm/msm/disp/dpu1/ |
| D | dpu_core_perf.c | 334 * 1. new bandwidth vote - "ab or ib vote" is higher in dpu_core_perf_crtc_update()
335 * than current vote for update request. in dpu_core_perf_crtc_update()
336 * 2. new bandwidth vote - "ab or ib vote" is lower in dpu_core_perf_crtc_update()
337 * than current vote at end of commit or stop. in dpu_core_perf_crtc_update()
369 DPU_ERROR("crtc-%d: failed to update bus bw vote\n", in dpu_core_perf_crtc_update()
376 * Update the clock after bandwidth vote to ensure in dpu_core_perf_crtc_update()
418 /* run the driver with max clk and BW vote */ in _dpu_core_perf_mode_write()
|
| D | dpu_core_perf.h | 43 * @fix_core_ib_vote: fixed core ib vote in bps used in mode 2
44 * @fix_core_ab_vote: fixed core ab vote in bps used in mode 2
|
| D | dpu_hw_catalog.h | 732 * @min_core_ib minimum mnoc ib vote in kbps
733 * @min_llcc_ib minimum llcc ib vote in kbps
734 * @min_dram_ib minimum dram ib vote in kbps
|
| /linux-6.8/drivers/soc/tegra/ |
| D | common.c | 66 * disabled. This makes sure the OPP vote below gets cached in in tegra_core_dev_init_opp_state()
67 * GENPD for the device. Instead, the vote is done the next time in tegra_core_dev_init_opp_state()
81 /* first dummy rate-setting initializes voltage vote */ in tegra_core_dev_init_opp_state()
|
| /linux-6.8/Documentation/devicetree/bindings/clock/ |
| D | qcom,lcc.yaml | 56 - description: PLL 4 Vote clock
90 - description: PLL 4 Vote clock
|
| /linux-6.8/drivers/clk/qcom/ |
| D | gdsc.h | 21 * @collapse_ctrl: APCS collapse-vote register
22 * @collapse_mask: APCS collapse-vote mask
|
| /linux-6.8/drivers/gpu/drm/msm/adreno/ |
| D | a6xx_hfi.h | 105 u32 vote; member
110 u32 vote; member
|
| D | a6xx_gmu.c | 153 * Send an invalid index as a vote for the bus bandwidth and let the in a6xx_gmu_set_freq()
154 * firmware decide on the right vote in a6xx_gmu_set_freq()
411 u32 vote; in a6xx_gmu_gfx_rail_on() local
417 vote = gmu->gx_arc_votes[gmu->nr_gpu_freqs - 1]; in a6xx_gmu_gfx_rail_on()
419 gmu_write(gmu, REG_A6XX_GMU_GX_VOTE_IDX, vote & 0xff); in a6xx_gmu_gfx_rail_on()
420 gmu_write(gmu, REG_A6XX_GMU_MX_VOTE_IDX, (vote >> 8) & 0xff); in a6xx_gmu_gfx_rail_on()
776 /* Vote veto for FAL10 */ in a6xx_gmu_fw_start()
1202 /* Remove the bus vote */ in a6xx_gmu_stop()
1338 /* Construct a vote for each frequency */ in a6xx_gmu_rpmh_arc_votes_init()
1364 * nothing fits, use the maximum non zero vote in a6xx_gmu_rpmh_arc_votes_init()
[all …]
|
| D | a6xx_hfi.c | 226 msg.gx_votes[i].vote = gmu->gx_arc_votes[i]; in a6xx_hfi_send_perf_table_v1()
231 msg.cx_votes[i].vote = gmu->cx_arc_votes[i]; in a6xx_hfi_send_perf_table_v1()
248 msg.gx_votes[i].vote = gmu->gx_arc_votes[i]; in a6xx_hfi_send_perf_table()
254 msg.cx_votes[i].vote = gmu->cx_arc_votes[i]; in a6xx_hfi_send_perf_table()
|
| /linux-6.8/drivers/slimbus/ |
| D | messaging.c | 49 /* Remove runtime-pm vote now that response was received for TID txn */ in slim_msg_response()
117 * do not vote for runtime-PM if the transactions are part of clock in slim_do_transfer()
169 * remove runtime-pm vote if this was TX only, or in slim_do_transfer()
|
| /linux-6.8/Documentation/devicetree/bindings/interconnect/ |
| D | qcom,bcm-voter.yaml | 15 Coordinators (RSC). Interconnect providers are able to vote for aggregated
|
| /linux-6.8/drivers/net/wwan/ |
| D | qcom_bam_dmux.c | 730 /* Vote for power state */ in bam_dmux_runtime_resume()
815 /* Runtime PM manages our own power vote. in bam_dmux_probe()
866 /* Drop our own power vote */ in bam_dmux_remove()
872 /* Try to wait for remote side to drop power vote */ in bam_dmux_remove()
|
| /linux-6.8/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,rpm.yaml | 12 to vote for state of the system resources, such as clocks, regulators and bus
|
| D | qcom,smd-rpm.yaml | 12 to vote for state of the system resources, such as clocks, regulators and bus
|
| /linux-6.8/arch/arm/common/ |
| D | vlock.S | 63 strb r1, [r0, #VLOCK_OWNER_OFFSET] @ submit my vote
|
| /linux-6.8/drivers/bluetooth/ |
| D | hci_qca.c | 104 /* HCI_IBS transmit and receive side clock state vote */
282 static void serial_clock_vote(unsigned long vote, struct hci_uart *hu) in serial_clock_vote() argument
290 switch (vote) { in serial_clock_vote()
333 BT_DBG("Vote serial clock %s(%s)", new_vote ? "true" : "false", in serial_clock_vote()
334 vote ? "true" : "false"); in serial_clock_vote()
384 /* Vote for serial clock */ in qca_wq_awake_device()
439 BT_DBG("hu %p rx clock vote off", hu); in qca_wq_serial_rx_clock_vote_off()
450 BT_DBG("hu %p tx clock vote off", hu); in qca_wq_serial_tx_clock_vote_off()
455 /* Now that message queued to tty driver, vote for tty clocks off. in qca_wq_serial_tx_clock_vote_off()
803 /* Vote off rx clock under workqueue */ in device_want_to_sleep()
|
| /linux-6.8/drivers/interconnect/qcom/ |
| D | icc-rpmh.h | 84 * @enable_mask: optional mask to send as vote instead of vote_x/vote_y
|
| D | icc-rpm.h | 53 * @keep_alive: whether to always keep a minimum vote on the bus clocks
|
| /linux-6.8/arch/arm64/boot/dts/qcom/ |
| D | msm8916-pm8916.dtsi | 87 * them to ensure the vote from the application processor can be
|
| D | msm8939-pm8916.dtsi | 65 * them to ensure the vote from the application processor can be
|
| /linux-6.8/fs/ocfs2/cluster/ |
| D | masklog.c | 113 define_mask(VOTE),
|
| /linux-6.8/drivers/soc/qcom/ |
| D | rpmh.c | 47 * @sleep_val: the sleep vote
48 * @wake_val: the wake vote
|
| /linux-6.8/drivers/interconnect/ |
| D | icc-clk.c | 71 * wrapper around COMMON_CLK framework, allowing other devices to vote on the
|
| /linux-6.8/fs/ocfs2/ |
| D | inode.h | 85 * We *only* set this on unlink vote from another node. If the inode
|