| /linux/Documentation/admin-guide/device-mapper/ |
| H A D | delay.rst | 6 and/or flushes and optionally maps them to different devices.
18 to write and flush operations on optionally different write_device with
19 optionally different sector offset
22 on/with optionally different flush_device/flush_offset.
|
| /linux/Documentation/devicetree/bindings/mailbox/ |
| H A D | arm,mhuv3.yaml | 17 The controller can optionally support a varying number of extensions that, in
29 - Optionally receive acknowledgment of a Transfer from the Receiver
34 - Optionally acknowledge Transfers sent by the Sender
58 Optionally, data may be transmitted through an out-of-band shared memory
78 Optionally, data may be transmitted through an out-of-band shared memory
97 Optionally, additional data may be transmitted through an out-of-band shared
|
| /linux/Documentation/networking/devlink/ |
| H A D | devlink-region.rst | 15 Regions may optionally support triggering snapshots on demand.
27 Regions may optionally support capturing a snapshot on demand via the
34 Regions may optionally allow directly reading from their contents without a
|
| /linux/include/acpi/ |
| H A D | acpixf.h | 123 * Optionally use default values for the ACPI register widths. Set this to
139 * Optionally enable output from the AML Debug Object.
144 * Optionally copy the entire DSDT to local memory (instead of simply
152 * Optionally ignore an XSDT if present and use the RSDT instead.
160 * Optionally use 32-bit FADT addresses if and when there is a conflict
170 * Optionally use 32-bit FACS table addresses.
179 * Optionally truncate I/O addresses to 16 bits. Provides compatibility
193 * Optionally do not install any SSDTs from the RSDT/XSDT during initialization.
199 * Optionally enable runtime namespace override.
230 * Optionally ignore AE_NOT_FOUND errors from named reference package elements
[all …]
|
| /linux/include/linux/irqchip/ |
| H A D | arm-vgic-info.h | 16 /* Full GICv3, optionally with v2 compat */
18 /* Full GICv5, optionally with v3 compat */
|
| /linux/arch/arm/mach-omap2/ |
| H A D | clkt2xxx_dpll.c | 26 * REVISIT: DPLL can optionally enter low-power bypass by writing 0x1
27 * instead. Add some mechanism to optionally enter this mode.
|
| /linux/drivers/pinctrl/ |
| H A D | core.h | 36 * @pin_group_tree: optionally each pin group can be stored in this radix tree
37 * @num_groups: optionally number of groups can be kept here
38 * @pin_function_tree: optionally each function can be stored in this radix tree
39 * @num_functions: optionally number of functions can be kept here
|
| /linux/Documentation/w1/slaves/ |
| H A D | w1_ds28e04.rst | 21 during memory accesses can optionally be enabled/disabled via the device
22 attribute "crccheck". The strong pull-up can optionally be enabled/disabled
|
| /linux/Documentation/devicetree/bindings/serial/ |
| H A D | brcm,bcm7271-uart.yaml | 32 description: The UART register block and optionally the DMA register blocks.
54 description: The UART interrupt and optionally the DMA interrupt.
|
| /linux/Documentation/firmware-guide/acpi/ |
| H A D | extcon-intel-int3496.rst | 10 USB-otg port, as well as how it optionally can enable Vbus output on the
11 otg port and how it can optionally control the muxing of the data pins
|
| /linux/drivers/firmware/arm_scmi/transports/ |
| H A D | Kconfig | 61 transport to optionally ask for atomic SCMI transactions and operate
119 transport to optionally ask for atomic SCMI transactions and operate
|
| /linux/include/sound/sof/ |
| H A D | dai-intel.h | 138 uint16_t polarity_mic_a; /**< Optionally invert mic A signal (0 or 1) */
139 uint16_t polarity_mic_b; /**< Optionally invert mic B signal (0 or 1) */
141 uint16_t clk_edge; /**< Optionally swap data clock edge (0 or 1) */
|
| /linux/Documentation/devicetree/bindings/arm/keystone/ |
| H A D | ti,sci.yaml | 26 This parent node may optionally have additional children nodes which describe
46 Specifies the debug messages memory mapped region that is optionally
|
| /linux/Documentation/scsi/ |
| H A D | scsi_mid_low_api.rst | 644 * Optionally defined in: LLD
671 * Optionally defined in: LLD
688 * Optionally defined in: LLD
706 * Optionally defined in: LLD
724 * Optionally defined in: LLD
746 * Optionally defined in: LLD
772 * Optionally defined in: LLD
801 * Optionally defined in: LLD
831 * Optionally defined in: LLD
929 * Optionally defined in: LLD
[all …]
|
| /linux/arch/arm/lib/ |
| H A D | backtrace.S | 47 * optionally saved caller registers (r4 - r10)
52 * optionally saved arguments (r0 - r3)
|
| /linux/Documentation/devicetree/bindings/clock/ti/ |
| H A D | ti,divider-clock.yaml | 53 unless the divider array is provided, min and max dividers. Optionally
57 This binding can also optionally provide support to the hardware autoidle
|
| /linux/include/linux/usb/ |
| H A D | rndis_host.h | 158 struct rndis_keepalive { /* OUT (optionally IN) */
165 struct rndis_keepalive_c { /* IN (optionally OUT) */
|
| /linux/net/netlabel/ |
| H A D | netlabel_mgmt.h | 48 * however the following attribute may optionally be sent:
102 * however the following attribute may optionally be sent:
|
| /linux/include/sound/ |
| H A D | rt5660.h | 19 /* IN1 & IN3 can optionally be differential */
|
| H A D | wm9090.h | 12 /* Line inputs 1 & 2 can optionally be differential */
|
| /linux/Documentation/sound/designs/ |
| H A D | channel-mapping-api.rst | 11 and the current channel map, also optionally to modify the channel map
53 read operation. Optionally, the write operation can be provided to
|
| /linux/Documentation/mm/ |
| H A D | page_table_check.rst | 19 it is disabled by default, but can be optionally enabled on systems where the
60 Optionally, build kernel with PAGE_TABLE_CHECK_ENFORCED in order to have page
|
| /linux/drivers/net/usb/ |
| H A D | cx82310_eth.c | 50 * - optionally send some data (command parameters)
51 * - optionally wait for the reply
52 * - optionally read some data from the reply
|
| /linux/drivers/usb/phy/ |
| H A D | phy-gpio-vbus-usb.c | 121 /* optionally enable D+ pullup */ in gpio_vbus_work()
129 /* optionally disable D+ pullup */ in gpio_vbus_work()
179 /* optionally disable D+ pullup */ in gpio_vbus_set_peripheral()
|
| /linux/drivers/gpu/drm/nouveau/include/dispnv04/i2c/ |
| H A D | encoder_i2c.h | 39 * &drm_encoder_helper_funcs and they can optionally be used to
183 * and to initialize the @encoder_i2c_funcs and (optionally) @encoder_i2c_priv
|