Searched full:numbered (Results 1 – 25 of 331) sorted by relevance
12345678910>>...14
| /linux-5.10/Documentation/hid/ |
| D | hidraw.rst | 50 On a device which uses numbered reports, the first byte of the returned data
52 byte. For devices which do not use numbered reports, the report data
63 number. If the device does not use numbered reports, the first byte should
116 which do not use numbered reports, set the first byte to 0. The report data
125 number of the requested report. For devices which do not use numbered
|
| /linux-5.10/Documentation/devicetree/bindings/display/bridge/ |
| D | renesas,dw-hdmi.txt | 33 - ports: See dw_hdmi.txt. The DWC HDMI shall have one port numbered 0
34 corresponding to the video input of the controller and one port numbered 1
35 corresponding to its HDMI output, and one port numbered 2 corresponding to
|
| D | thine,thc63lvd1024.yaml | 35 contain any endpoint. In dual-link mode, even-numbered pixels are
36 received on port@0 and odd-numbered pixels on port@1, and both port@0 and
|
| /linux-5.10/Documentation/devicetree/bindings/pinctrl/ |
| D | st,stm32-pinctrl.yaml | 36 pins-are-numbered: true
190 - pins-are-numbered
204 pins-are-numbered;
222 pins-are-numbered;
|
| D | pinctrl-mt65xx.txt | 16 - pins-are-numbered: Specify the subnodes are using numbered pinmux to
95 pins-are-numbered;
|
| /linux-5.10/arch/s390/lib/ |
| D | find.c | 3 * MSB0 numbered special bitops handling.
5 * The bits are numbered:
|
| /linux-5.10/Documentation/devicetree/bindings/media/ |
| D | cdns,csi2tx.txt | 26 port nodes are numbered as follows.
39 the endpoints are not numbered.
|
| D | cdns,csi2rx.txt | 26 port nodes are numbered as follows:
39 the endpoints are not numbered.
|
| /linux-5.10/Documentation/devicetree/bindings/display/rockchip/ |
| D | dw_hdmi-rockchip.txt | 24 - ports: See dw_hdmi.txt. The DWC HDMI shall have a single port numbered 0
26 endpoints, numbered 0 and 1, connected respectively to the vopb and vopl.
|
| /linux-5.10/arch/s390/include/asm/ |
| D | bitops.h | 9 * Within a word, bits are numbered LSB first. Lot's of places make
16 * end up numbered:
20 * The bits are numbered:
250 * The bits are numbered:
|
| /linux-5.10/Documentation/devicetree/bindings/soundwire/ |
| D | qcom,sdw.txt | 108 Definition: should be number identifying lowerst numbered coloum in
117 Definition: should be number identifying highest numbered coloum in
|
| /linux-5.10/Documentation/input/devices/ |
| D | index.rst | 9 :numbered:
|
| /linux-5.10/Documentation/filesystems/ext4/ |
| D | index.rst | 9 :numbered:
|
| /linux-5.10/Documentation/devicetree/bindings/iio/adc/ |
| D | st,stm32-adc.yaml | 254 - 16 channels, numbered from 0 to 15 (for in0..in15) on stm32f4
255 - 20 channels, numbered from 0 to 19 (for in0..in19) on stm32h7 and
264 <vinp vinn>, <vinp vinn>,... vinp and vinn are numbered from 0 to 19.
|
| /linux-5.10/Documentation/input/ |
| D | input_kapi.rst | 13 :numbered:
|
| D | input_uapi.rst | 13 :numbered:
|
| /linux-5.10/Documentation/mips/ |
| D | index.rst | 9 :numbered:
|
| /linux-5.10/Documentation/PCI/ |
| D | index.rst | 9 :numbered:
|
| /linux-5.10/Documentation/devicetree/bindings/net/ |
| D | mdio-gpio.txt | 11 Note: Each gpio-mdio bus should have an alias correctly numbered in "aliases"
|
| /linux-5.10/include/uapi/linux/ |
| D | kcmp.h | 25 __u32 toff; /* target offset within same numbered sequence */
|
| /linux-5.10/Documentation/translations/zh_CN/process/ |
| D | development-process.rst | 14 :numbered:
|
| /linux-5.10/tools/include/uapi/linux/ |
| D | kcmp.h | 25 __u32 toff; /* target offset within same numbered sequence */
|
| /linux-5.10/Documentation/x86/ |
| D | index.rst | 9 :numbered:
|
| /linux-5.10/Documentation/devicetree/bindings/serial/ |
| D | arc-uart.txt | 20 Note: Each port should have an alias correctly numbered in "aliases" node.
|
| /linux-5.10/arch/arm/mach-footbridge/include/mach/ |
| D | isa-dma.h | 16 * numbered 0..7.
|
12345678910>>...14