Home
last modified time | relevance | path

Searched full:minimise (Results 1 – 25 of 56) sorted by relevance

123

/linux-5.10/arch/arm/mach-s3c/
Dpm-common.c61 * This is similar to s3c_pm_do_restore() except we try and minimise the
Dpm-gpio.c136 * we minimise the work between the two settings. in samsung_gpio_pm_2bit_resume()
/linux-5.10/kernel/irq/
Dipi.c228 * Minimise the overhead by omitting the checks for Linux SMP IPIs. in __ipi_send_single()
271 * Minimise the overhead by omitting the checks for Linux SMP IPIs. in __ipi_send_mask()
/linux-5.10/arch/m68k/include/asm/
Dhash.h20 * chosen to minimise the shift distances.
/linux-5.10/arch/arm64/kernel/
Dsys_compat.c38 * We pick the reserved-ASID to minimise the impact. in __do_compat_cache_op()
/linux-5.10/drivers/gpu/drm/i915/gem/
Di915_gem_busy.c46 * to eventually flush us, but to minimise latency just ask the in __busy_set_if_active()
/linux-5.10/Documentation/devicetree/bindings/spi/
Dspi-pl022.yaml54 priority to minimise the transfer latency on the bus (boolean)
/linux-5.10/Documentation/driver-api/
Dregulator.rst73 not in use in order to minimise the need to use ifdefs.
/linux-5.10/Documentation/sound/soc/
Dcodec.rst171 minimise any system noise. The mute stops any digital data from
/linux-5.10/net/core/
Dlink_watch.c125 /* Minimise down-time: drop delay for up event. */ in linkwatch_schedule_work()
/linux-5.10/fs/squashfs/
DKconfig10 are very small and all blocks are packed to minimise data overhead.
/linux-5.10/scripts/dtc/libfdt/
Dlibfdt_internal.h84 * the latest supported version and wish to minimise code size.
/linux-5.10/include/linux/amba/
Dpl022.h237 * priority to minimise the transfer latency on the bus.
/linux-5.10/sound/soc/codecs/
Dwm8350.c73 * Ramp OUT1 PGA volume to minimise pops at stream startup and shutdown.
138 * Ramp OUT2 PGA volume to minimise pops at stream startup and shutdown.
203 * minimise pop associated with DAPM power switching.
204 * It's best to enable Zero Cross when ramping occurs to minimise any
/linux-5.10/drivers/ata/
Dpata_cs5530.c69 * master to slave. We track the last DMA setup in order to minimise
/linux-5.10/drivers/input/touchscreen/
Dwm9705.c86 * order to minimise this, a signal may be applied to the MASK pin to delay or
Dwm9713.c94 * order to minimise this, a signal may be applied to the MASK pin to delay or
Dwm9712.c94 * order to minimise this, a signal may be applied to the MASK pin to delay or
/linux-5.10/include/linux/
Dwm97xx.h263 /* pre and post sample - can be used to minimise any analog noise */
Drefcount.h19 * equidistant from 0 and INT_MAX we minimise the scope for error:
/linux-5.10/drivers/mfd/
Dwm8350-irq.c374 * minimise I/O.
/linux-5.10/Documentation/filesystems/
Dsquashfs.rst11 minimise data overhead. Block sizes greater than 4K are supported up to a
/linux-5.10/include/sound/
Dsoc-dai.h248 * Called by soc-core to minimise any pops.
/linux-5.10/Documentation/trace/
Dtracepoint-analysis.rst236 period is quite high to minimise overhead but the information collected can be
/linux-5.10/drivers/gpu/drm/nouveau/dispnv04/
Ddac.c284 /* if there's a spare crtc, using it will minimise flicker */ in nv17_dac_sample_load()

123