Searched full:iom (Results 1 – 13 of 13) sorted by relevance
| /linux-5.10/scripts/coccinelle/free/ |
| D | iounmap.cocci | 19 @iom@
52 p1 << iom.p1;
53 p2 << iom.p2;
54 p3 << iom.p3;
62 p1 << iom.p1;
63 p2 << iom.p2;
64 p3 << iom.p3;
|
| /linux-5.10/Documentation/devicetree/bindings/arm/marvell/ |
| D | marvell,kirkwood.txt | 45 "iom,iconnect"
46 "iom,iconnect-1.1"
47 "iom,ix2-200"
|
| /linux-5.10/drivers/isdn/hardware/mISDN/ |
| D | hfc_pci.h | 22 /* GCI/IOM bus monitor registers */
28 /* GCI/IOM bus timeslot registers */
38 /* GCI/IOM bus data registers */
44 /* GCI/IOM bus configuration registers */
|
| D | ipac.h | 262 /* IOM: Timeslot, DPS, CDA */
280 /* IOM: Contol, Sync transfer, Monitor */
|
| D | hfcpci.c | 261 * STIO1 is used as output for data, B1+B2 from ST->IOM+HFC in reset_hfcpci()
262 * STIO2 is used as data input, B1+B2 from IOM->ST in reset_hfcpci()
264 * The IOM slots are always enabled in reset_hfcpci()
1816 hc->hw.trm |= 0x80; /* enable IOM-loop */ in channel_ctrl()
1820 hc->hw.trm &= 0x7f; /* disable IOM-loop */ in channel_ctrl()
1858 hc->hw.trm &= 0x7f; /* disable IOM-loop */ in channel_ctrl()
|
| D | mISDNipac.c | 833 if (!(isac->adf2 & 0x80)) { /* only IOM 2 Mode */ in isac_init()
1608 /* default values for IOM time slots in mISDNipac_init()
|
| D | mISDNinfineon.c | 565 hw->ipac.conf = 0x01; /* IOM off */ in reset_inf()
|
| /linux-5.10/arch/arm/boot/dts/ |
| D | kirkwood-iconnect.dts | 9 compatible = "iom,iconnect-1.1", "iom,iconnect", "marvell,kirkwood-88f6281", "marvell,kirkwood";
|
| D | kirkwood-iomega_ix2_200.dts | 9 compatible = "iom,ix2-200", "marvell,kirkwood-88f6281", "marvell,kirkwood";
|
| /linux-5.10/drivers/pinctrl/ |
| D | pinctrl-rockchip.c | 3612 struct rockchip_iomux *iom = &bank->iomux[j]; in rockchip_pinctrl_get_soc_data() local
3620 if (iom->offset >= 0) { in rockchip_pinctrl_get_soc_data()
3621 if (iom->type & IOMUX_SOURCE_PMU) in rockchip_pinctrl_get_soc_data()
3622 pmu_offs = iom->offset; in rockchip_pinctrl_get_soc_data()
3624 grf_offs = iom->offset; in rockchip_pinctrl_get_soc_data()
3626 iom->offset = (iom->type & IOMUX_SOURCE_PMU) ? in rockchip_pinctrl_get_soc_data()
3632 if (iom->type & IOMUX_SOURCE_PMU) in rockchip_pinctrl_get_soc_data()
3637 drv->offset = (iom->type & IOMUX_SOURCE_PMU) ? in rockchip_pinctrl_get_soc_data()
3642 i, j, iom->offset, drv->offset); in rockchip_pinctrl_get_soc_data()
3648 inc = (iom->type & (IOMUX_WIDTH_4BIT | in rockchip_pinctrl_get_soc_data()
[all …]
|
| /linux-5.10/drivers/usb/typec/mux/ |
| D | intel_pmc_mux.c | 84 * Input Output Manager (IOM) PORT STATUS
584 /* The IOM microcontroller has a limitation of max 4 ports. */ in pmc_usb_probe()
|
| /linux-5.10/drivers/media/pci/bt8xx/ |
| D | dvb-bt8xx.c | 865 * IOM = 0 == audio A/D in dvb_bt8xx_probe()
|
| /linux-5.10/Documentation/devicetree/bindings/ |
| D | vendor-prefixes.yaml | 512 "^iom,.*":
|