Searched full:gives (Results 1 – 25 of 1092) sorted by relevance
12345678910>>...44
| /linux-5.10/drivers/char/agp/ |
| D | Kconfig | 34 This option gives you AGP support for the GLX component of
49 This option gives you AGP support for the GLX component of
56 This option gives you AGP support for the GLX component of
63 This option gives you AGP support for the GLX component of
74 This option gives you AGP support for the GLX component of X
85 This option gives you AGP support for the GLX component of
92 This option gives you AGP support for the GLX component of
109 This option gives you AGP support for the GLX component of
116 This option gives you AGP GART support for the Intel 460GX chipset
123 This option gives you AGP GART support for the HP ZX1 chipset
[all …]
|
| /linux-5.10/Documentation/trace/ |
| D | events-power.rst | 58 The first parameter gives the clock name (e.g. "gpio1_iclk").
69 The first parameter gives the power domain name (e.g. "mpu_pwrdm").
81 The first parameter gives the QoS action name (e.g. "ADD_REQ").
92 The first parameter gives the device name which tries to add/update/remove
94 The second parameter gives the request type (e.g. "DEV_PM_QOS_RESUME_LATENCY").
|
| /linux-5.10/drivers/net/phy/ |
| D | linkmode.c | 70 * 1 1 0 1 Only this gives RX only
81 * rx=1 tx=0 gives Pause+AsymDir advertisement, but we may end up
84 * rx=0 tx=1 gives AsymDir only, which will only give tx pause if
86 * rx=1 tx=1 gives Pause only, which will only allow tx+rx pause
|
| /linux-5.10/Documentation/sound/hd-audio/ |
| D | controls.rst | 14 It gives the number of channels to be used, "2ch", "4ch", "6ch",
23 When there are only either headphones or line-out jacks, it gives
27 When both headphone and line-out jacks are present, it gives
95 This control is provided only for VT1708 codec which gives no proper
114 It gives the number of channels to be used, "2ch", "4ch" and "6ch".
|
| /linux-5.10/fs/squashfs/ |
| D | Kconfig | 77 By default Squashfs uses a single decompressor but it gives
91 By default Squashfs uses a single decompressor but it gives
160 compressed with XZ compression. XZ gives better compression than
175 compressed with ZSTD compression. ZSTD gives better compression than
192 This, however, gives poor performance on MTD NAND devices where
|
| /linux-5.10/Documentation/devicetree/bindings/misc/ |
| D | nvidia,tegra20-apbmisc.txt | 11 - reg: Should contain 2 entries: the first entry gives the physical address
13 The second entry gives the physical address and length of the
|
| /linux-5.10/Documentation/ABI/testing/ |
| D | sysfs-class-watchdog | 20 It is a read/write file. While reading, it gives '1'
22 it gives '0'. Writing a '1' to the file enables the
32 It is a read only file. It gives active/inactive status of
|
| D | sysfs-devices-system-cpu | 436 - turbo_stat : This file gives the total number of times the max
440 - sub_turbo_stat : This file gives the total number of times the
444 - unthrottle : This file gives the total number of times the max
447 - powercap : This file gives the total number of times the max
450 - overtemp : This file gives the total number of times the max
453 - supply_fault : This file gives the total number of times the
456 - overcurrent : This file gives the total number of times the
459 - occ_reset : This file gives the total number of times the max
|
| D | sysfs-platform-hidma-mgmt | 64 Choosing a higher number gives better performance but
85 Choosing a higher number gives better performance but
|
| /linux-5.10/lib/ |
| D | bucket_locks.c | 9 * gives the maximum number of elements to allocate. cpu_mult gives
|
| /linux-5.10/Documentation/userspace-api/media/v4l/ |
| D | vidioc-queryctrl.rst | 124 - Minimum value, inclusive. This field gives a lower bound for the
130 - Maximum value, inclusive. This field gives an upper bound for the
136 - This field gives a step size for the control. See enum
148 This field gives the smallest change of an integer control
205 - Minimum value, inclusive. This field gives a lower bound for the
211 - Maximum value, inclusive. This field gives an upper bound for the
217 - This field gives a step size for the control. See enum
229 This field gives the smallest change of an integer control
|
| /linux-5.10/drivers/hid/ |
| D | hid-appleir.c | 72 * 25 87 ee 91 05 gives you >"
75 * 25 87 ee 91 05 gives you the middle button
81 * 25 87 ee a3 04 gives you >"
84 * 25 87 ee a3 04 gives you the middle button
|
| /linux-5.10/drivers/power/supply/ |
| D | axp20x_ac_power.c | 114 /* IIO framework gives mV but Power Supply framework gives uV */ in axp20x_ac_power_get_property()
124 /* IIO framework gives mA but Power Supply framework gives uA */ in axp20x_ac_power_get_property()
|
| /linux-5.10/Documentation/sound/cards/ |
| D | bt87x.rst | 59 The first device (hw:X,0) gives you 16 bit stereo sound. The sample
67 The second device (hw:X,1) gives you 8 or 16 bit mono sound. Supported
|
| /linux-5.10/Documentation/hwmon/ |
| D | pcf8591.rst | 86 The in0_input, in1_input, in2_input and in3_input files are RO. Reading gives
92 The out0_enable file is RW. Reading gives "1" for analog output enabled and
|
| /linux-5.10/Documentation/devicetree/bindings/mfd/ |
| D | st,stm32-timers.yaml | 78 "level" gives the active level (0=low or 1=high) of the
82 "filter" gives the filtering value (up to 15) to be applied.
|
| /linux-5.10/fs/ocfs2/cluster/ |
| D | masklog.h | 12 * For now this is a trivial wrapper around printk() that gives the critical
24 * caller gives a constant bitmask that fills one of the longs with all 0s. So
38 * /sys/fs/o2cb/logmask/. Reading the files gives a straightforward
|
| /linux-5.10/arch/x86/math-emu/ |
| D | README | 310 The following table gives the measured results for the emulator. The
312 million. The group of three columns gives the frequency of the given
339 following table gives the results which were obtained with an AMD
352 two columns of results are given: * The second column for f2xm1 gives
354 positive argument, this shows that this instruction gives better
356 cases of fcos and fptan, the first column gives the results when all
|
| /linux-5.10/arch/sparc/kernel/ |
| D | pci_msi.c | 54 printk(KERN_EMERG "MSI: Get head on msiqid[%lu] gives error %d\n", in sparc64_msiq_interrupt()
60 "gives error %d\n", in sparc64_msiq_interrupt()
66 "gives error %d\n", in sparc64_msiq_interrupt()
205 "irq %u, gives error %d\n", pbm->name, msi_num, irq, in sparc64_teardown_msi_irq()
|
| /linux-5.10/drivers/ide/ |
| D | ide-floppy_ioctl.c | 23 * Userland gives us the following structure:
158 * Userland gives us the following structure: in ide_floppy_format_unit()
192 * Userland gives a pointer to an int. The int is set to a progress
|
| /linux-5.10/arch/sparc/include/asm/ |
| D | pgtsrmmu.h | 58 * We use 5 bits for the type and 19 for the offset. This gives us
73 * user pages because the SRMMU gives us the capabilities to
|
| /linux-5.10/drivers/media/dvb-frontends/ |
| D | dibx000_common.h | 250 * used to do the PWM. Direction gives the PWModulator to be used.
251 * Value gives the PWM value in device-dependent scale.
|
| /linux-5.10/drivers/mtd/parsers/ |
| D | Kconfig | 119 blocks on the device, similar to a partition table, which gives
143 partition table. A zero or positive value gives an absolute
|
| /linux-5.10/Documentation/cpu-freq/ |
| D | cpufreq-stats.rst | 65 This gives the amount of time spent in each of the frequencies supported by
83 This gives the total number of frequency transitions on this CPU. The cat
|
| /linux-5.10/arch/m68k/math-emu/ |
| D | fp_log.c | 69 * With a=1 this gives: in fp_fsqrt()
81 * It gives: in fp_fsqrt()
|
12345678910>>...44