Searched full:functioning (Results 1 – 25 of 105) sorted by relevance
12345
| /linux-6.8/drivers/ntb/test/ |
| D | Kconfig | 7 your ntb hardware and drivers are functioning at a basic level.
18 functioning at a basic level.
|
| /linux-6.8/drivers/acpi/acpica/ |
| D | nsinit.c | 548 * Run _STA to determine if this device is present and functioning. We in acpi_ns_init_one_device()
577 * other words, the device is present, ..., and functioning)" in acpi_ns_init_one_device()
584 * Examine the PRESENT and FUNCTIONING status bits in acpi_ns_init_one_device()
587 * not functioning case, so we assume functioning if present. in acpi_ns_init_one_device()
591 /* Device is not present, we must examine the Functioning bit */ in acpi_ns_init_one_device()
595 * Device is not present but is "functioning". In this case, in acpi_ns_init_one_device()
612 * Device is not present and is not functioning. We must abort the in acpi_ns_init_one_device()
|
| /linux-6.8/Documentation/ABI/testing/ |
| D | sysfs-bus-acpi | 66 functioning or present, if the method _STA is present.
76 Bit [3] Set if the device is functioning properly (cleared
|
| D | sysfs-pps | 45 The /sys/class/pps/ppsX/mode file reports the functioning
|
| /linux-6.8/arch/arm64/boot/dts/rockchip/ |
| D | rk3588-turing-rk1.dts | 4 * "compute node" system, where the carrier board is functioning more like a
|
| /linux-6.8/Documentation/devicetree/bindings/pci/ |
| D | snps,dw-pcie-ep.yaml | 33 normal controller functioning. iATU memory IO region is also required
114 There is no mandatory IRQ signals for the normal controller functioning,
|
| /linux-6.8/drivers/ras/ |
| D | Kconfig | 28 be functioning correctly. For example, a server may run forever and
|
| /linux-6.8/Documentation/devicetree/bindings/soc/fsl/ |
| D | guts.txt | 22 contains a functioning "reset control register" (i.e. the board
|
| /linux-6.8/Documentation/arch/arm/sunxi/ |
| D | clocks.rst | 12 carelessly the system would stop functioning, but with the right
|
| /linux-6.8/Documentation/filesystems/ |
| D | bfs.rst | 33 that modprobe is functioning. Beware that umount will not deallocate
|
| /linux-6.8/Documentation/devicetree/bindings/power/ |
| D | power_domain.txt | 59 functioning of the current device at the current OPP (where this property is
|
| /linux-6.8/Documentation/virt/kvm/x86/ |
| D | msr.rst | 151 data and functioning:
163 data and functioning:
|
| /linux-6.8/drivers/clk/ |
| D | clk-bm1880.c | 203 * for the functioning of the SoC
217 * Clocks marked as CRITICAL are needed for the proper functioning
368 * Clocks marked as CRITICAL are needed for the proper functioning
395 * Clocks marked as CRITICAL are all needed for the proper functioning
|
| /linux-6.8/Documentation/driver-api/memory-devices/ |
| D | ti-gpmc.rst | 24 functioning of the peripheral, while peripheral has another set of
|
| /linux-6.8/drivers/cpuidle/ |
| D | cpuidle-cps.c | 31 * system to have any hope of functioning. in cps_nc_enter()
|
| /linux-6.8/tools/testing/selftests/timers/ |
| D | alarmtimer-suspend.c | 7 * functioning.
|
| /linux-6.8/arch/x86/kvm/ |
| D | Kconfig | 151 These interfaces are required for the correct and performant functioning
|
| /linux-6.8/Documentation/devicetree/bindings/pinctrl/ |
| D | fsl,mxs-pinctrl.txt | 34 particular function, like SSP0 functioning as mmc0-8bit. That said, the
|
| /linux-6.8/drivers/scsi/aic7xxx/ |
| D | aiclib.h | 13 * functioning of this software in any circumstances.
|
| /linux-6.8/drivers/scsi/ |
| D | imm.h | 43 * Due to work commitments and inability to get a "true" ECP mode functioning
|
| /linux-6.8/Documentation/leds/ |
| D | ledtrig-transient.rst | 38 start functioning again.
|
| /linux-6.8/tools/testing/selftests/powerpc/eeh/ |
| D | eeh-functions.sh | 32 # A functioning PE should have the EEH_STATE_MMIO_ACTIVE and
|
| /linux-6.8/security/ |
| D | Kconfig | 96 helps to ensure that kernel security mechanisms are functioning
|
| /linux-6.8/drivers/power/supply/ |
| D | surface_charger.c | 203 /* Make sure the device is there and functioning properly. */ in spwr_ac_register()
|
| /linux-6.8/Documentation/devicetree/bindings/opp/ |
| D | opp-v2-base.yaml | 202 for the functioning of the current device at the current OPP (where
|
12345