Home
last modified time | relevance | path

Searched +full:five +full:- +full:cell (Results 1 – 11 of 11) sorted by relevance

/linux-5.10/Documentation/devicetree/bindings/dma/
Dst,stm32-mdma.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/dma/st,stm32-mdma.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 The STM32 MDMA is a general-purpose direct memory access controller capable of
13 described in the dma.txt file, using a five-cell specifier for each channel:
14 a phandle to the MDMA controller plus the following five integer cells:
22 -bit 0-1: Source increment mode
26 -bit 2-3: Destination increment mode
30 -bit 8-9: Source increment offset size
[all …]
/linux-5.10/Documentation/devicetree/bindings/mfd/
Dwlf,arizona.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - patches@opensource.cirrus.com
17 - $ref: /schemas/sound/wlf,arizona.yaml#
18 - $ref: /schemas/regulator/wlf,arizona.yaml#
19 - $ref: /schemas/extcon/wlf,arizona.yaml#
20 - if:
25 - cirrus,cs47l24
26 - wlf,wm1831
[all …]
/linux-5.10/Documentation/devicetree/bindings/pwm/
Dpwm-mediatek.txt4 - compatible: should be "mediatek,<name>-pwm":
5 - "mediatek,mt2712-pwm": found on mt2712 SoC.
6 - "mediatek,mt7622-pwm": found on mt7622 SoC.
7 - "mediatek,mt7623-pwm": found on mt7623 SoC.
8 - "mediatek,mt7628-pwm": found on mt7628 SoC.
9 - "mediatek,mt7629-pwm": found on mt7629 SoC.
10 - "mediatek,mt8516-pwm": found on mt8516 SoC.
11 - reg: physical base address and length of the controller's registers.
12 - #pwm-cells: must be 2. See pwm.yaml in this directory for a description of
13 the cell format.
[all …]
/linux-5.10/Documentation/devicetree/bindings/virtio/
Diommu.txt3 When virtio-iommu uses the PCI transport, its programming interface is
6 masters. Therefore, the PCI root complex that hosts the virtio-iommu
11 - compatible: Should be "virtio,pci-iommu"
12 - reg: PCI address of the IOMMU. As defined in the PCI Bus
13 Binding reference [1], the reg property is a five-cell
18 - #iommu-cells: Each platform DMA master managed by the IOMMU is assigned
20 For virtio-iommu, #iommu-cells must be 1.
24 - DMA from the IOMMU device isn't managed by another IOMMU. Therefore the
25 virtio-iommu node doesn't have an "iommus" property, and is omitted from
26 the iommu-map property of the root complex.
[all …]
/linux-5.10/Documentation/devicetree/bindings/pci/
Dpci.txt3 PCI Bus Binding to: IEEE Std 1275-1994
4 https://www.devicetree.org/open-firmware/bindings/pci/pci2_1.pdf
9 https://www.devicetree.org/open-firmware/practice/imap/imap0_9d.pdf
14 - linux,pci-domain:
21 - max-link-speed:
27 - reset-gpios:
30 - supports-clkreq:
34 not to advertise ASPM L1 Sub-States support if there is no CLKREQ signal.
36 PCI-PCI Bridge properties
37 -------------------------
[all …]
/linux-5.10/Documentation/devicetree/bindings/powerpc/fsl/
Dpamu.txt5 The PAMU is an I/O MMU that provides device-to-memory access control and
10 - compatible : <string>
11 First entry is a version-specific string, such as
12 "fsl,pamu-v1.0". The second is "fsl,pamu".
13 - ranges : <prop-encoded-array>
18 PAMU v1.0, on an SOC that has five PAMU devices, the size
20 - interrupts : <prop-encoded-array>
25 - #address-cells: <u32>
27 - #size-cells : <u32>
31 - reg : <prop-encoded-array>
[all …]
/linux-5.10/arch/powerpc/platforms/
DKconfig.cputype1 # SPDX-License-Identifier: GPL-2.0
8 bool "64-bit kernel"
11 This option selects whether a 32-bit or a 64-bit kernel
22 There are five families of 32 bit PowerPC chips supported.
127 bool "Cell Broadband Engine"
187 default "cell" if CELL_CPU
277 This option enables kernel support for larger than 32-bit physical
282 is platform-dependent.
297 any affect on a non-altivec cpu (it does, however add code to the
313 VSX (P7 and above), but does not have any affect on a non-VSX
[all …]
/linux-5.10/Documentation/admin-guide/
Dunicode.rst4 Last update: 2005-01-17, version 1.4
10 http://www.lanana.org/docs/unicode/admin-guide/unicode.rst
13 ------------
16 characters to fonts. By downloading a single Unicode-to-font table,
17 both the eight-bit character sets and UTF-8 mode are changed to use
20 This changes the semantics of the eight-bit character tables subtly.
26 LAT1_MAP Latin-1 (ISO 8859-1) ESC ( B
34 permits for example the use of block graphics even with a Latin-1 font
38 codes nor their uses match ISO 2022; Linux has two 8-bit codes (G0 and
39 G1), whereas ISO 2022 has four 7-bit codes (G0-G3).
[all …]
/linux-5.10/drivers/mfd/
DKconfig1 # SPDX-License-Identifier: GPL-2.0-only
44 tristate "Active-semi ACT8945A"
49 Support for the ACT8945A PMIC from Active-semi. This device
50 features three step-down DC/DC converters and four low-dropout
66 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
69 called sun4i-gpadc.
88 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
119 over at91-usart-serial driver and usart-spi-driver. Only one function
135 tristate "Atmel HLCDC (High-end LCD Controller)"
172 tristate "X-Powers AC100"
[all …]
/linux-5.10/tools/include/uapi/linux/
Dbpf.h1 /* SPDX-License-Identifier: GPL-2.0 WITH Linux-syscall-note */
2 /* Copyright (c) 2011-2014 PLUMgrid, http://plumgrid.com
21 #define BPF_DW 0x18 /* double word (64-bit) */
30 #define BPF_TO_LE 0x00 /* convert to little-endian */
31 #define BPF_TO_BE 0x08 /* convert to big-endian */
62 /* BPF has 10 general purpose 64-bit registers and stack frame. */
90 /* BPF syscall commands, see bpf(2) man-page for details. */
260 /* cgroup-bpf attach flags used in BPF_PROG_ATTACH command
264 * BPF_F_ALLOW_OVERRIDE: If a sub-cgroup installs some bpf program,
265 * the program in this cgroup yields to sub-cgroup program.
[all …]
/linux-5.10/include/uapi/linux/
Dbpf.h1 /* SPDX-License-Identifier: GPL-2.0 WITH Linux-syscall-note */
2 /* Copyright (c) 2011-2014 PLUMgrid, http://plumgrid.com
21 #define BPF_DW 0x18 /* double word (64-bit) */
30 #define BPF_TO_LE 0x00 /* convert to little-endian */
31 #define BPF_TO_BE 0x08 /* convert to big-endian */
62 /* BPF has 10 general purpose 64-bit registers and stack frame. */
90 /* BPF syscall commands, see bpf(2) man-page for details. */
260 /* cgroup-bpf attach flags used in BPF_PROG_ATTACH command
264 * BPF_F_ALLOW_OVERRIDE: If a sub-cgroup installs some bpf program,
265 * the program in this cgroup yields to sub-cgroup program.
[all …]