Searched full:electrical (Results 1 – 25 of 81) sorted by relevance
1234
27 If some electrical strap or alternate resolution is desired,31 certain electrical driving levels.
16 The MIPI Alliance Standard for Display Bus Interface defines the electrical
21 * Table 4-1: Electrical Characteristics22 * ->DC Electrical Timing
23 slots) or electrical issues during the transmit/receive transition cannot35 Slave or to a non-implemented register) or electrical issue, no response
36 under each USB4 port. Used for electrical quality and robustness
28 control power supplied to electrical devices.
30 systems are also I2C conformant. The electrical constraints are tighter
7 Due to electrical and mechanical constraints in certain platform designs
397 is a way for chip vendors producing some kind of electrical packages to use702 that your datasheet calls "GPIO mode", but actually is just an electrical757 software-control a few electrical properties of the pin that you would777 Here some electrical properties of the pin can be configured no matter823 - Registers (or fields within registers) that control electrical844 Electrical properties of the pin such as biasing and drive strength926 GPIO subsystem. It is just an electrical configuration used by that device
58 /* electrical parameter block */
101 /* electrical parameter block */
64 /* 1=Enable SERDES Electrical Idle */
13 This binding describes an electrical setup where setting an GPIO output
15 electrical signals for DSI.
16 * Faculty of Electrical Engineering (http://www.fel.cvut.cz)
29 meet both SMBus and I2C electrical constraints; and others which can't
62 - method to set electrical configuration for a given GPIO line91 GPIO electrical configuration94 GPIO lines can be configured for several electrical modes of operation by using250 supports more versatile control over electrical properties and can handle
119 There may be electrical problems on this board.
18 /* Pad Electrical Controls. */
69 (RG)MII/electrical interface considerations73 electrical signal interface using a synchronous 125Mhz clock signal and several288 also defines the electrical characteristics of the signals with a host
15 is to help reduce electrical emission (EMI)
9 electrical characteristics of drivers and receivers for use in balanced
38 electrical connections. The vast majority of EEH errors seen in50 address line parity errors (for example, due to poor electrical