Searched full:ddr50 (Results 1 – 25 of 51) sorted by relevance
123
| /linux-5.10/Documentation/devicetree/bindings/mmc/ |
| D | sdhci-st.txt | 57 - sd-uhs-ddr50: To enable the DDR50 in the mmcss.
109 sd-uhs-ddr50;
|
| D | sdhci-omap.txt | 15 "ddr50-rev11", "sdr104-rev11", "ddr50", "sdr104",
|
| D | cdns,sdhci.yaml | 67 cdns,phy-input-delay-sd-uhs-ddr50:
68 description: Value of the delay in the input path for SD UHS DDR50 timing
|
| D | mmc-controller.yaml | 151 sd-uhs-ddr50:
154 SD UHS DDR50 speed is supported.
339 "^clk-phase-(legacy|sd-hs|mmc-(hs|hs[24]00|ddr52)|uhs-(sdr(12|25|50|104)|ddr50))$":
|
| D | sdhci-am654.yaml | 93 ti,otap-del-sel-ddr50:
94 description: Output tap delay for SD UHS DDR50 timing
|
| D | brcm,sdhci-brcmstb.txt | 22 sd-uhs-ddr50;
|
| /linux-5.10/arch/arm/boot/dts/ |
| D | stih410-b2120.dts | 34 sd-uhs-ddr50;
|
| D | stih418-b2199.dts | 84 sd-uhs-ddr50;
|
| D | dra72-evm.dts | 94 pinctrl-names = "default", "hs", "sdr12", "sdr25", "sdr50", "ddr50", "sdr104";
|
| D | dra72-evm-revc.dts | 124 pinctrl-names = "default", "hs", "sdr12", "sdr25", "sdr50", "ddr50", "sdr104";
|
| D | dra7-evm.dts | 389 …pinctrl-names = "default", "hs", "sdr12", "sdr25", "sdr50", "ddr50-rev11", "sdr104-rev11", "ddr50"…
|
| D | dra71-evm.dts | 201 pinctrl-names = "default", "hs", "sdr12", "sdr25", "sdr50", "ddr50", "sdr104";
|
| D | stm32mp157c-ed1.dts | 340 sd-uhs-ddr50;
|
| D | rk3288-firefly-reload.dts | 265 sd-uhs-ddr50;
|
| /linux-5.10/drivers/mmc/host/ |
| D | dw_mmc-k3.c | 84 {0}, /* 7: DDR50 */
96 {0}, /* 7: DDR50 */
|
| D | sdhci-pxav3.c | 140 * According to erratum 'FE-2946959' both SDR50 and DDR50 in armada_38x_quirks()
147 …dev_warn(&pdev->dev, "conf-sdio3 register not found: disabling SDR50 and DDR50 modes.\nConsider up… in armada_38x_quirks()
|
| D | sdhci-of-sparx5.c | 154 SDHCI_QUIRK2_NO_1_8_V, /* No sdr104, ddr50, etc */
|
| /linux-5.10/drivers/mmc/core/ |
| D | debugfs.c | 141 str = "sd uhs DDR50"; in mmc_ios_show()
|
| D | bus.c | 320 [UHS_DDR50_BUS_SPEED] = "DDR50 ", in mmc_add_card()
|
| D | sd.c | 538 * Current limit switch is only defined for SDR50, SDR104, and DDR50 in sd_set_current_limit()
653 * tuning is also available for DDR50 mode. in mmc_sd_init_uhs_card()
656 pr_warn("%s: ddr50 tuning failed\n", in mmc_sd_init_uhs_card()
|
| /linux-5.10/arch/arm64/boot/dts/amlogic/ |
| D | meson-gxl-s905x-libretech-cc-v2.dts | 255 sd-uhs-ddr50;
|
| D | meson-gxbb-nanopi-k2.dts | 309 sd-uhs-ddr50;
|
| D | meson-gxbb-odroidc2.dts | 326 sd-uhs-ddr50;
|
| D | meson-gx-libretech-pc.dtsi | 382 sd-uhs-ddr50;
|
| /linux-5.10/arch/arm64/boot/dts/marvell/ |
| D | armada-8040-mcbin.dtsi | 114 * the "slow-mode" and disable SDR104, SDR50 and DDR50 modes.
|
123