Home
last modified time | relevance | path

Searched +full:clock +full:- +full:noncontinuous (Results 1 – 6 of 6) sorted by relevance

/linux-5.10/Documentation/devicetree/bindings/media/i2c/
Dtc358743.txt1 * Toshiba TC358743 HDMI-RX to MIPI CSI2-TX Bridge
3 The Toshiba TC358743 HDMI-RX to MIPI CSI2-TX (H2C) is a bridge that converts
4 a HDMI stream to MIPI CSI-2 TX. It is programmable through I2C.
8 - compatible: value should be "toshiba,tc358743"
9 - clocks, clock-names: should contain a phandle link to the reference clock
10 source, the clock input is named "refclk".
14 - reset-gpios: gpio phandle GPIO connected to the reset pin
15 - interrupts: GPIO connected to the interrupt pin
16 - data-lanes: should be <1 2 3 4> for four-lane operation,
17 or <1 2> for two-lane operation
[all …]
Dimx219.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Sony 1/4.0-Inch 8Mpixel CMOS Digital Image Sensor
10 - Dave Stevenson <dave.stevenson@raspberrypi.com>
12 description: |-
13 The Sony imx219 is a 1/4.0-inch CMOS active pixel digital image sensor
16 Image data is sent through MIPI CSI-2, which is configured as either 2 or
30 VDIG-supply:
34 VANA-supply:
[all …]
Dov5647.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Dave Stevenson <dave.stevenson@raspberrypi.com>
11 - Jacopo Mondi <jacopo@jmondi.org>
13 description: |-
14 The OV5647 is a raw image sensor with MIPI CSI-2 and CCP2 image data
26 description: Reference to the xclk clock.
29 pwdn-gpios:
35 description: |-
[all …]
/linux-5.10/arch/arm/boot/dts/
Dimx6q-h100.dts4 * This file is dual-licensed: you can use it either under the terms
42 /dts-v1/;
45 #include "imx6qdl-sr-som.dtsi"
46 #include "imx6qdl-sr-som-brcm.dtsi"
64 stdout-path = &uart2;
67 hdmi_osc: hdmi-osc {
68 compatible = "fixed-clock";
69 clock-output-names = "hdmi-osc";
70 clock-frequency = <27000000>;
71 #clock-cells = <0>;
[all …]
/linux-5.10/Documentation/devicetree/bindings/media/
Dvideo-interfaces.txt4 ---------------
21 #address-cells = <1>;
22 #size-cells = <0>;
37 a common scheme using '#address-cells', '#size-cells' and 'reg' properties is
41 specify #address-cells, #size-cells properties independently for the 'port'
44 Two 'endpoint' nodes are linked with each other through their 'remote-endpoint'
53 a device is partitioned into multiple data busses, e.g. 16-bit input port
54 divided into two separate ITU-R BT.656 8-bit busses. In such case bus-width
55 and data-shift properties can be used to assign physical data lines to each
59 --------------------------------
[all …]
/linux-5.10/drivers/media/v4l2-core/
Dv4l2-fwnode.c1 // SPDX-License-Identifier: GPL-2.0-only
6 * formerly was located in v4l2-of.c.
11 * Copyright (C) 2012 - 2013 Samsung Electronics Co., Ltd.
27 #include <media/v4l2-async.h>
28 #include <media/v4l2-fwnode.h>
29 #include <media/v4l2-subdev.h>
54 "MIPI CSI-2 C-PHY",
58 "MIPI CSI-1",
66 "MIPI CSI-2 D-PHY",
96 return conv ? conv->mbus_type : V4L2_MBUS_UNKNOWN; in v4l2_fwnode_bus_type_to_mbus()
[all …]