Searched full:circuitry (Results 1 – 25 of 69) sorted by relevance
123
51 silicon along with all associated circuitry including a permanently55 silicon along with all associated circuitry including a permanently59 silicon along with all associated circuitry excluding a permanently63 silicon along with all associated circuitry excluding a permanently
67 detect circuitry.131 busy. This is the task of the DCD circuitry/software. The driver may either138 as it is much faster than most hardware squelch circuitry. The145 DCD circuitry is recommended.
16 board has its own circuitry for providing this oscillator19 if the board has its own circuitry for providing this
12 Lochnagar 2 features built-in Current Monitor circuitry that allows for the15 hardware modifications or external circuitry to operate.
17 resolution and track and hold circuitry combined with an analogue input
57 contain monitoring and PWM control circuitry for two fans.
18 resolution and track and hold circuitry combined with an analogue input
130 Both have special circuitry to compensate for PWM interactions with the132 speed of a two wire fan, but the input conditioning circuitry is different
46 - "adc" clock: for the analog circuitry, common to all ADCs.57 Allow to specify desired max clock rate used by analog circuitry.78 analog circuitry on stm32mp1.
13 13 bit ADCs with 1, 2 or 8 inputs and self calibrating circuitry to
32 …O 0x8 // This cap indicates whether board supports the BACO circuitry.33 …O 0x10 // This cap indicates whether board supports the MACO circuitry.
16 - dvdd-supply : phandle to a 3.3-V supply for the digital circuitry
41 measured by the digital lock detect circuitry.
235 /* clear fifo and reset triggering circuitry */ in a2150_cancel()479 /* clear fifo and reset triggering circuitry */ in a2150_ai_cmd()585 /* clear fifo and reset triggering circuitry */ in a2150_ai_rinsn()631 /* clear fifo and reset triggering circuitry */ in a2150_ai_rinsn()741 /* reset and sync adc clock circuitry */ in a2150_attach()
8 5V lines it is 5.3V. So you may need some sort of level conversion circuitry
19 circuitry which shuts down the regulator when the
24 microchip,sensor-gain: Defines the gain of the sensor circuitry. This
19 Overvoltage or Undervoltage Input Fault. The internal circuitry
112 * because of the AT&T DSP3210 hardware circuitry and the 16-bit Singer in mac_init_asc()113 * codec circuitry in the AVs. The Audio Waveform Amplifier and in mac_init_asc()
102 * integrated circuitry via a command bus.179 * the integrated circuitry via any command bus after this call.
80 digital circuitry.
13 In this mode, the AD5758 circuitry senses the output
702 * DRESETB - Digital circuitry in pm3393_mac_reset()703 * PL4_ARESETB - PL4 analog circuitry in pm3393_mac_reset()704 * XAUI_ARESETB - XAUI bus analog circuitry in pm3393_mac_reset()768 /* Has the XAUI MABC PLL circuitry stablized? */ in pm3393_mac_reset()
83 is useful when dealing with the KBC or other slow external circuitry. */
65 bits the RNG circuitry will enter a low power state. Intel will