Searched full:boots (Results 1 – 25 of 119) sorted by relevance
12345
| /linux-5.10/Documentation/admin-guide/laptops/ |
| D | lg-laptop.rst | 47 This value is reset to 100 when the kernel boots.
63 This value is reset to 0 when the kernel boots.
|
| /linux-5.10/drivers/media/test-drivers/vidtv/ |
| D | vidtv_channel.h | 9 * When vidtv boots, it will create some hardcoded channels.
34 * When vidtv boots, it will create some hardcoded channels.
|
| /linux-5.10/arch/arm/mach-omap2/ |
| D | omap_opp_data.h | 44 * by an array of omap_opp_def. As the kernel boots and more information is
46 * device the kernel boots up on. It is interesting to remember that each IP
|
| D | gpmc.h | 8 * once omap3 boots in device tree only mode.
|
| /linux-5.10/drivers/net/ipa/ |
| D | ipa_qmi.c | 47 * subsequent boots. The modem expects to receive a final INIT_COMPLETE
65 * - On subsequent modem boots, everything is ready when:
69 * optional for non-initial modem boots, and have no bearing on the
121 * When the modem boots (or reboots), the handshake sequence starts
484 * subsequent boots. The INIT_COMPLETE indication message is in ipa_qmi_setup()
|
| /linux-5.10/drivers/zorro/ |
| D | Kconfig | 12 15KB, but it gets freed after the system boots up, so it doesn't
|
| /linux-5.10/Documentation/x86/i386/ |
| D | IO-APIC.rst | 13 CPU which boots the operating system (usually CPU#0).
23 If your box boots fine with enabled IO-APIC IRQs, then your
|
| /linux-5.10/Documentation/dev-tools/kunit/ |
| D | faq.rst | 32 kernel and runs when the kernel boots, or when built as a module, when the
96 seeing. When tests are built-in, they will execute when the kernel boots, and
|
| /linux-5.10/drivers/net/wireless/ath/ath10k/ |
| D | testmode_i.h | 43 /* Boots the UTF firmware, the netdev interface must be down at the
|
| /linux-5.10/tools/testing/selftests/powerpc/nx-gzip/ |
| D | README | 8 However, chmod may not survive across boots. You may create a udev file such
|
| /linux-5.10/arch/riscv/include/asm/ |
| D | cpu_ops.h | 20 * @cpu_start: Boots a cpu into the kernel.
|
| /linux-5.10/drivers/eisa/ |
| D | Kconfig | 70 boots up, so it doesn't take up kernel memory. Anyway, if
|
| /linux-5.10/arch/arm/include/asm/ |
| D | firmware.h | 38 * Boots specified physical CPU
|
| /linux-5.10/tools/testing/ktest/examples/ |
| D | test.conf | 14 # the machine, where it does not matter which system the machine boots into.
|
| /linux-5.10/tools/testing/ktest/examples/include/ |
| D | tests.conf | 69 # This builds, installs, boots and tests the target.
|
| D | min-config.conf | 36 # machine still boots, then you can use the config-skip as your MIN_CONFIG.
|
| /linux-5.10/arch/arm64/include/asm/ |
| D | cpu_ops.h | 23 * @cpu_boot: Boots a cpu into the kernel.
|
| /linux-5.10/drivers/soc/ti/ |
| D | Kconfig | 69 resume and boots it using wkup_m3_rproc driver.
|
| /linux-5.10/sound/soc/sof/ |
| D | loader.c | 461 /* no need to re-check version/ABI for subsequent boots */ in sof_fw_ready()
797 * 2. FW boots successfully and fw_ready op succeeds. in snd_sof_run_firmware()
798 * 3. FW boots but fw_ready op fails. in snd_sof_run_firmware()
814 return -EIO; /* FW boots but fw_ready op failed */ in snd_sof_run_firmware()
|
| /linux-5.10/include/linux/ |
| D | stringhash.h | 13 * versions, architectures, or even repeated boots of the same kernel.
|
| /linux-5.10/arch/powerpc/boot/ |
| D | wii.c | 143 * 'mini' boots the Broadway processor with EXI disabled. in platform_init()
|
| D | ppcboot.h | 3 * This interface is used for compatibility with old U-boots *ONLY*.
|
| /linux-5.10/Documentation/devicetree/bindings/pci/ |
| D | pci.txt | 16 otherwise an unstable (across boots) unique number will be assigned.
|
| /linux-5.10/Documentation/devicetree/bindings/remoteproc/ |
| D | st,stm32-rproc.yaml | 11 boots firmwares on the ST32MP family chipset.
|
| /linux-5.10/Documentation/devicetree/bindings/arm/ |
| D | secure.txt | 10 virtual machine which boots Secure firmware and wants to tell the
|
12345