Searched full:asserting (Results 1 – 25 of 124) sorted by relevance
12345
42 Delay in ms after powering the card and de-asserting the48 Delay in us after asserting the reset-gpios (if any)
27 * Enabling/disabling an interrupt line involves asserting/clearing29 * asserting the corresponding bit in ICR.
10 - resets: phandle to the reset controller asserting this device in
9 - resets: phandle to the reset controller asserting this device in
8 - resets: phandle to the reset controller asserting this device in
13 - resets: Should contain a reference to the reset controller asserting
31 * @hardware_clear_to_midscale: Whether asserting the hardware CLR pin sets the
32 - timeout-ms: Time to wait before asserting a WARN_ON(1). If nothing is
47 * de-asserting the reset. Delay 10us just to be safe. in clk_pll_enable()281 * de-asserting the reset. Delay 10us just to be safe. in clk_pll_sr2_enable()
19 * Suspend Modulation works by asserting and de-asserting the SUSP# pin20 * to CPU(GX1/GXLV) for configurable durations. When asserting SUSP#
58 /* Maximum reset delay after de-asserting a line and seeing block in brcmstb_reset_deassert()
91 Delay after asserting reset to the PCIe device.
38 * The hardware is asserting attn and the state machine is
360 * "This register decides the asserting duration of wdt_ext and in aspeed_wdt_probe()362 * default asserting duration of wdt_ext and wdt_rstarm is in aspeed_wdt_probe()
16 response mechanism where masters have to claim the bus by asserting
266 /* Wait for a short time before de-asserting in hdmi_pll_enable()282 * Wait for a short time before de-asserting to allow the hardware to in hdmi_pll_enable()
64 * pcie_pme_walk_bus - Scan a PCI bus for devices asserting PME#.67 * Scan given PCI bus and all buses under it for devices asserting PME#.
90 /* Enable the MDIO bus by asserting the enable bit and writing in temac_mdio_setup()
22 - resets: Reference to a reset controller asserting the SAI
76 * case of suspend for instance. Theoretically, asserting individual in stih407_usb2_exit_port()
150 /* wait after asserting subsystem restart from AOSS */ in qcom_adsp_shutdown()160 /* wait after de-asserting subsystem restart from AOSS */ in qcom_adsp_shutdown()
76 * @start_conv_msg: SPI message to start a conversion by briefly asserting CS422 /* conversions are started by asserting CS pin for 8 usec */ in mcp320x_probe()
159 /* Check the current status to avoid de-asserting the line twice */ in omap4_prminst_deassert_hardreset()
12 HCLGE_MBX_ASSERTING_RESET, /* (PF -> VF) PF is asserting reset*/
46 PCI bus instead of asserting a device IRQ pin.