Searched full:vybrid (Results 1 – 25 of 30) sorted by relevance
12
/linux-6.8/Documentation/devicetree/bindings/pinctrl/ |
D | fsl,vf610-pinctrl.txt | 1 Freescale Vybrid VF610 IOMUX Controller 11 such as pull-up, speed, ode for this pin. Please refer to Vybrid VF610 41 for all available PIN_FUNC_ID for Vybrid VF610.
|
/linux-6.8/drivers/irqchip/ |
D | irq-vf610-mscm-ir.c | 6 * IRQ chip driver for MSCM interrupt router available on Vybrid SoC's. 9 * one of the two available CPU's on Vybrid VF6xx SoC's (Cortex-A5 or 13 * o All peripheral interrupts of the Vybrid SoC can be routed to 15 * variants of Vybrid SoC such as VF6xx. This driver routes the 19 * variants of Vybrid.
|
/linux-6.8/Documentation/devicetree/bindings/nvmem/ |
D | vf610-ocotp.txt | 1 On-Chip OTP Memory for Freescale Vybrid 11 Example for Vybrid VF5xx/VF6xx:
|
/linux-6.8/Documentation/devicetree/bindings/arm/freescale/ |
D | fsl,vf610-mscm-ir.txt | 1 Freescale Vybrid Miscellaneous System Control - Interrupt Router 7 Vybrid SoC's but is only really useful in dual core configurations (VF6xx
|
D | fsl,vf610-mscm-cpucfg.txt | 1 Freescale Vybrid Miscellaneous System Control - CPU Configuration
|
/linux-6.8/Documentation/devicetree/bindings/mtd/ |
D | vf610-nfc.txt | 4 Vybrid (vf610), MPC5125, MCF54418 and Kinetis K70. 12 - assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>;
|
/linux-6.8/drivers/iio/dac/ |
D | vf610_dac.c | 3 * Freescale Vybrid vf610 DAC driver 131 * reference voltage as per Vybrid datasheet is 3.3V in vf610_read_raw() 132 * from section 9.1.2.1 of Vybrid datasheet in vf610_read_raw()
|
D | Kconfig | 478 tristate "Vybrid vf610 DAC driver" 481 Say yes here to support Vybrid board digital-to-analog converter.
|
/linux-6.8/drivers/pinctrl/freescale/ |
D | Kconfig | 195 bool "Freescale Vybrid VF610 pinctrl driver" 199 Say Y here to enable the Freescale Vybrid VF610 pinctrl driver
|
/linux-6.8/arch/arm/mach-imx/ |
D | Kconfig | 238 bool "Vybrid Family VF610 support" 243 This enables support for Freescale Vybrid VF610 processor.
|
D | mach-vf610.c | 66 DT_MACHINE_START(VYBRID_VF610, "Freescale Vybrid VF5xx/VF6xx (Device Tree)")
|
/linux-6.8/drivers/mtd/nand/raw/ |
D | vf610_nfc.c | 218 * Freescale Vybrid SoC it's known that the driver can treat 223 * endianness. On little endian platforms such as Vybrid this leads 253 * Freescale Vybrid SoC it's known that the driver can treat 258 * endianness. On little endian platforms such as Vybrid this leads 478 * This function supports Vybrid only (MPC5125 would have full RB and four CS) 485 /* Vybrid only (MPC5125 would have full RB and four CS) */ in vf610_nfc_select_target()
|
/linux-6.8/Documentation/devicetree/bindings/clock/ |
D | vf610-clock.txt | 1 * Clock bindings for Freescale Vybrid VF610 SOC
|
/linux-6.8/Documentation/devicetree/bindings/pwm/ |
D | pwm-fsl-ftm.txt | 10 Vybrid | LE
|
/linux-6.8/drivers/nvmem/ |
D | vf610-ocotp.c | 253 MODULE_DESCRIPTION("Vybrid OCOTP driver");
|
D | Kconfig | 393 This is a driver for the 'OCOTP' peripheral available on Vybrid
|
/linux-6.8/drivers/iio/adc/ |
D | vf610_adc.c | 3 * Freescale Vybrid vf610 ADC driver 33 /* Vybrid/IMX ADC registers */
|
D | Kconfig | 1446 Say yes here to support for Vybrid board analog-to-digital converter.
|
/linux-6.8/drivers/i2c/busses/ |
D | i2c-imx.c | 108 * - but write one to clear(w1c) INT flag on Vybrid. 111 * - but clear I2CR_IEN bit enable the module on Vybrid. 149 /* Vybrid VF610 clock divider, register value pairs */ 334 * toggled. This is required because i.MX needs W0C and Vybrid uses W1C. in i2c_imx_clear_irq()
|
/linux-6.8/arch/arm/ |
D | Kconfig.debug | 1320 bool "Vybrid UART" 1324 on Vybrid based platforms. 1452 int "Vybrid Debug UART Port Selection" if DEBUG_VF_UART
|
/linux-6.8/drivers/clocksource/ |
D | Kconfig | 462 Support for Periodic Interrupt Timer on Freescale Vybrid Family SoCs.
|
/linux-6.8/drivers/dma/ |
D | Kconfig | 220 This module can be found on Freescale Vybrid and LS-1 SoCs.
|
D | fsl-edma-main.c | 9 * Vybrid and Layerscape SoCs.
|
D | fsl-edma-common.c | 846 * On the 32 channels Vybrid/mpc577x edma version, register offsets are
|
/linux-6.8/Documentation/devicetree/bindings/arm/ |
D | fsl.yaml | 1279 Freescale Vybrid Platform Device Tree Bindings 1281 For the Vybrid SoC family all variants with DDR controller are supported,
|
12