Home
last modified time | relevance | path

Searched +full:vana +full:- +full:supply (Results 1 – 14 of 14) sorted by relevance

/linux-5.10/Documentation/devicetree/bindings/display/
Dste,mcde.txt1 ST-Ericsson Multi Channel Display Engine MCDE
3 The ST-Ericsson MCDE is a display controller with support for compositing
5 LCD displays or bridges. It is used in the ST-Ericsson U8500 platform.
9 - compatible: must be:
11 - reg: register base for the main MCDE control registers, should be
13 - interrupts: the interrupt line for the MCDE
14 - epod-supply: a phandle to the EPOD regulator
15 - vana-supply: a phandle to the analog voltage regulator
16 - clocks: an array of the MCDE clocks in this strict order:
21 - clock-names: must be the following array:
[all …]
/linux-5.10/Documentation/devicetree/bindings/media/i2c/
Dad5820.txt5 - compatible: Must contain one of:
6 - "adi,ad5820"
7 - "adi,ad5821"
8 - "adi,ad5823"
10 - reg: I2C slave address
12 - VANA-supply: supply of voltage for VANA pin
16 - enable-gpios : GPIO spec for the XSHUTDOWN pin. The XSHUTDOWN signal is
25 VANA-supply = <&vaux4>;
26 enable-gpios = <&msmgpio 26 GPIO_ACTIVE_HIGH>;
Dimx219.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Sony 1/4.0-Inch 8Mpixel CMOS Digital Image Sensor
10 - Dave Stevenson <dave.stevenson@raspberrypi.com>
12 description: |-
13 The Sony imx219 is a 1/4.0-inch CMOS active pixel digital image sensor
16 Image data is sent through MIPI CSI-2, which is configured as either 2 or
30 VDIG-supply:
32 Digital I/O voltage supply, 1.8 volts
[all …]
Dtoshiba,et8ek8.txt6 Documentation/devicetree/bindings/media/video-interfaces.txt .
10 --------------------
12 - compatible: "toshiba,et8ek8"
13 - reg: I2C address (0x3e, or an alternative address)
14 - vana-supply: Analogue voltage supply (VANA), 2.8 volts
15 - clocks: External clock to the sensor
16 - clock-frequency: Frequency of the external clock to the sensor. Camera
18 a pre-determined frequency known to be suitable to the board.
19 - reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor
24 -------------------
[all …]
Dnokia,smia.txt8 Documentation/devicetree/bindings/media/video-interfaces.txt .
12 Documentation/devicetree/bindings/media/video-interfaces.txt .
15 --------------------
17 - compatible: "nokia,smia"
18 - reg: I2C address (0x10, or an alternative address)
19 - vana-supply: Analogue voltage supply (VANA), typically 2,8 volts (sensor
21 - clocks: External clock to the sensor
22 - clock-frequency: Frequency of the external clock to the sensor
23 - link-frequencies: List of allowed data link frequencies. An array of
24 64-bit elements.
[all …]
Dsony,imx274.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Sony 1/2.5-Inch 8.51MP CMOS Digital Image Sensor
10 - Leon Luo <leonl@leopardimaging.com>
13 The Sony IMX274 is a 1/2.5-inch CMOS active pixel digital image sensor with an
15 Image data is sent through MIPI CSI-2, which is configured as 4 lanes at 1440
25 reset-gpios:
31 clock-names:
34 vana-supply:
[all …]
/linux-5.10/arch/arm/boot/dts/
Dste-ab8505.dtsi1 // SPDX-License-Identifier: GPL-2.0-or-later
6 #include <dt-bindings/clock/ste-ab8500.h>
10 iio-hwmon {
11 compatible = "iio-hwmon";
12 io-channels = <&gpadc 0x02>, /* Battery temperature */
23 interrupt-parent = <&intc>;
25 interrupt-controller;
26 #interrupt-cells = <2>;
28 ab8500_clock: clock-controller {
29 compatible = "stericsson,ab8500-clk";
[all …]
Dste-ab8500.dtsi1 // SPDX-License-Identifier: GPL-2.0-or-later
6 #include <dt-bindings/clock/ste-ab8500.h>
10 iio-hwmon {
11 compatible = "iio-hwmon";
12 io-channels = <&gpadc 0x02>, /* Battery temperature */
27 interrupt-parent = <&intc>;
29 interrupt-controller;
30 #interrupt-cells = <2>;
32 ab8500_clock: clock-controller {
33 compatible = "stericsson,ab8500-clk";
[all …]
Domap3-n9.dts1 // SPDX-License-Identifier: GPL-2.0-only
3 * omap3-n9.dts - Device Tree file for Nokia N9
8 /dts-v1/;
10 #include "omap3-n950-n9.dtsi"
11 #include <dt-bindings/input/input.h>
15 compatible = "nokia,omap3-n9", "ti,omap3630", "ti,omap36xx", "ti,omap3";
23 vana-supply = <&vaux3>;
25 clock-frequency = <9600000>;
26 flash-leds = <&as3645a_flash &as3645a_indicator>;
29 link-frequencies = /bits/ 64 <199200000 210000000 499200000>;
[all …]
Domap3-n950.dts1 // SPDX-License-Identifier: GPL-2.0-only
3 * omap3-n950.dts - Device Tree file for Nokia N950
8 /dts-v1/;
10 #include "omap3-n950-n9.dtsi"
11 #include <dt-bindings/input/input.h>
15 compatible = "nokia,omap3-n950", "ti,omap3630", "ti,omap36xx", "ti,omap3";
18 compatible = "gpio-keys";
23 linux,input-type = <EV_SW>;
25 wakeup-source;
26 pinctrl-names = "default";
[all …]
Domap3-n900.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
4 * Copyright (C) 2013-2014 Aaro Koskinen <aaro.koskinen@iki.fi>
7 /dts-v1/;
10 #include <dt-bindings/input/input.h>
13 * Default secure signed bootloader (Nokia X-Loader) does not enable L3 firewall
15 * blocks then kernel receive "Unhandled fault: external abort on non-linefetch"
16 * and crash. Until somebody fix omap-aes.c and omap_hwmod_3xxx_data.c code (no
32 compatible = "nokia,omap3-n900", "ti,omap3430", "ti,omap3";
45 cpu0-supply = <&vcc>;
50 compatible = "gpio-leds";
[all …]
/linux-5.10/arch/arm64/boot/dts/renesas/
Daistarvision-mipi-adapter-2.1.dtsi1 // SPDX-License-Identifier: GPL-2.0
10 compatible = "regulator-fixed";
11 regulator-name = "camera_vdddo";
12 regulator-min-microvolt = <1800000>;
13 regulator-max-microvolt = <1800000>;
14 regulator-always-on;
18 compatible = "regulator-fixed";
19 regulator-name = "camera_vdda";
20 regulator-min-microvolt = <2800000>;
21 regulator-max-microvolt = <2800000>;
[all …]
/linux-5.10/drivers/regulator/
Dab8500-ext.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (C) ST-Ericsson SA 2010
11 * ab8500-ext supports the following regulators:
12 * - VextSupply3
35 REGULATOR_SUPPLY("vcc", "gpio-keys.0"),
37 REGULATOR_SUPPLY("vcc", "2-0029"),
39 REGULATOR_SUPPLY("vdd", "2-0018"),
41 REGULATOR_SUPPLY("vdd", "2-0019"),
43 REGULATOR_SUPPLY("vdd", "2-001e"),
45 REGULATOR_SUPPLY("avdd", "3-005c"),
[all …]
/linux-5.10/drivers/media/i2c/
Dimx219.c1 // SPDX-License-Identifier: GPL-2.0
24 #include <media/v4l2-ctrls.h>
25 #include <media/v4l2-device.h>
26 #include <media/v4l2-event.h>
27 #include <media/v4l2-fwnode.h>
28 #include <media/v4l2-mediabus.h>
66 /* HBLANK control - read only */
141 /* V-timing */
414 "VANA", /* Analog (2.8V) supply */
415 "VDIG", /* Digital Core (1.8V) supply */
[all …]