Searched full:specifies (Results 451 – 475 of 1403) sorted by relevance
1...<<11121314151617181920>>...57
/linux-6.8/Documentation/devicetree/bindings/regulator/ |
D | gpio-regulator.yaml | 81 description: Specifies what is being regulated.
|
/linux-6.8/drivers/char/hw_random/ |
D | arm_smccc_trng.c | 8 * The ARM TRNG firmware interface specifies a protocol to read entropy
|
/linux-6.8/Documentation/devicetree/bindings/mfd/ |
D | rohm,bd9571mwv.yaml | 40 This is a bitmask that specifies which DDR power rails need to be kept
|
/linux-6.8/drivers/soc/fsl/qbman/ |
D | bman_priv.h | 67 * @bman_portal specifies which portal the API will use.
|
/linux-6.8/Documentation/devicetree/bindings/i2c/ |
D | i2c-mux-reg.txt | 14 - reg: this pair of <offset size> specifies the register to control the mux.
|
/linux-6.8/Documentation/devicetree/bindings/phy/ |
D | fsl,imx8-pcie-phy.yaml | 45 Specifies the mode of the refclk pad used. It can be UNUSED(PHY
|
/linux-6.8/Documentation/devicetree/bindings/net/ |
D | renesas,ethertsn.yaml | 64 Specifies a reference to a node representing a PHY device.
|
D | marvell-bt-8xxx.txt | 26 - interrupts : specifies the interrupt pin number to the cpu. For SDIO, the
|
/linux-6.8/Documentation/devicetree/bindings/interrupt-controller/ |
D | marvell,icu.txt | 28 - #interrupt-cells: Specifies the number of cells needed to encode an
|
D | qcom,mpm.yaml | 31 Specifies the base address and size of vMPM registers in RPM MSG RAM.
|
/linux-6.8/Documentation/devicetree/bindings/usb/ |
D | dwc3-xilinx.yaml | 31 description: specifies a phandle to PM domain provider node
|
/linux-6.8/include/media/ |
D | tveeprom.h | 11 * enum tveeprom_audio_processor - Specifies the type of audio processor
|
/linux-6.8/drivers/staging/media/atomisp/pci/isp/kernels/gc/gc_1.0/ |
D | ia_css_gc_types.h | 73 * This parameter specifies range of chroma output level.
|
/linux-6.8/Documentation/userspace-api/ |
D | futex2.rst | 46 ``nr_futexes`` specifies the size of the array. Numbers out of [1, 128]
|
/linux-6.8/drivers/hid/ |
D | hid-holtek-mouse.c | 19 * The report descriptor of some Holtek based gaming mice specifies an
|
/linux-6.8/Documentation/devicetree/bindings/power/reset/ |
D | qcom,pon.yaml | 29 Specifies the SPMI base address for the PON (power-on) peripheral. For
|
/linux-6.8/sound/soc/intel/avs/ |
D | topology.h | 109 /* Specifies path behaviour during PCM ->trigger(START) command. */
|
/linux-6.8/Documentation/virt/kvm/s390/ |
D | s390-pv-boot.rst | 46 The new PV load-device-specific-parameters field specifies all data
|
/linux-6.8/Documentation/devicetree/bindings/powerpc/fsl/ |
D | mpc5121-psc.txt | 48 - clocks : specifies the clock needed to operate the fifo controller
|
/linux-6.8/Documentation/devicetree/bindings/pinctrl/ |
D | intel,pinctrl-keembay.yaml | 35 Specifies the interrupt lines to be used by the controller.
|
/linux-6.8/Documentation/devicetree/bindings/hwmon/ |
D | npcm750-pwm-fan.txt | 14 - reg : specifies physical base address and size of the registers.
|
/linux-6.8/include/uapi/linux/ |
D | openvswitch.h | 596 * mask bits for wildcarded flow match. Mask bit value '1' specifies exact 597 * match with corresponding flow key bit, while mask bit value '0' specifies 761 * The algorithm type only specifies the fields in a flow 925 * single nested %OVS_KEY_ATTR_* attribute specifies a header to modify and its 928 * nested %OVS_KEY_ATTR_* attribute specifies a header to modify, its value,
|
/linux-6.8/drivers/s390/cio/ |
D | fcx.c | 201 * @use_tidal: zero of the data address specifies a contiguous block of data, 202 * non-zero if it specifies a list if tidaws.
|
/linux-6.8/drivers/platform/x86/intel/telemetry/ |
D | core.c | 220 * evtlog.telem_evt_id specifies the ids to read 237 * evtlog.telem_evt_id specifies the ids to read
|
/linux-6.8/Documentation/sound/designs/ |
D | oss-emulation.rst | 142 ``fragments`` specifies the number of fragments or zero if no specific 198 specifies to invoke the write transfer only when the whole fragment is
|
1...<<11121314151617181920>>...57