Searched full:specifies (Results 426 – 450 of 1350) sorted by relevance
1...<<11121314151617181920>>...54
24 * However, if efi_fake_mem specifies EFI_MEMORY_SP for a given in efi_fake_memmap_early()
35 linux,keycodes: Specifies an array of numeric keycode values to
8 - #dma-cells : Must be <1>. The number cell specifies the channel ID.
20 - reg: Specifies offset and length of the register set for the device.
25 Specifies the value of threshold that the device is comparing
46 /* If the device tree specifies the memory range, use it */ in iss_4xx_fixups()
9 - reg : specifies physical base address and size of
42 value that specifies which per-region motion detection thresholds
345 * @sci_phy: This parameter specifies the phy for which to retrieve the365 * @out]: iphy This parameter specifies the phy for which to assign a port600 * @sci_phy: This parameter specifies the phy object for which link training602 * @max_link_rate: This parameter specifies the maximum link rate to be604 * @next_state: This parameter specifies the next state for the phy's starting1425 * @phy: This parameter specifies the sphy being controlled.1426 * @func: This parameter specifies the phy control function being invoked.
139 This specifies the source. It may be a block device (e.g. /dev/sda1) or416 fs_type specifies the filesystem type that will manage the context and438 an automount point or other derived superblock. fs_type specifies the487 param specifies the parameter key name and the value. The parameter is677 MACRO SPECIFIES
11 - interrupts: specifies the interrupt source of the parent interrupt
22 - reg: Specifies offset and length of the register set for the device.
15 - #reset-cells: Specifies the number of cells needed to encode reset
32 the Internet using TCP/IP as a reliable link layer. RFC1613 specifies the
20 specifies cursor size::
97 /* Specifies this amp is using an external boost supply */
23 - st,tx-retime-src: This specifies which clk is wired up to the mac for
22 Definition: specifies the CCI I2C interrupt. The format of the
23 the code (array row) and G specifies the group (column) 0-7.
24 - reg: Specifies the I2C slave address (defaults to 0x5a but can be modified)
29 This is a bitmask that specifies which DDR power
202 ``max_ptes_none`` specifies how many extra small pages (that are213 ``max_ptes_swap`` specifies how many pages can be brought in from223 ``max_ptes_shared`` specifies how many pages can be shared across multiple
167 Specifies that an AIF group will be used as a master173 Specifies that an AIF group will be used as a slave
43 * Example that specifies panel timing using minimum, typical,
30 - ecc-size: enables ECC support and specifies ECC buffer size in bytes