Searched full:specifies (Results 226 – 250 of 1443) sorted by relevance
12345678910>>...58
| /linux-6.15/include/media/ |
| D | rc-core.h | 102 * @driver_type: specifies if protocol decoding is done in hardware or software
235 * @rc_driver_type: specifies the type of the RC output to be allocated
244 * @rc_driver_type: specifies the type of the RC output to be allocated
|
| /linux-6.15/drivers/scsi/isci/ |
| D | remote_device.h | 150 * @remote_device: This parameter specifies the device to be stopped.
151 * @timeout: This parameter specifies the number of milliseconds in which the
166 * @remote_device: This parameter specifies the device to be reset.
|
| /linux-6.15/include/uapi/misc/ |
| D | xilinx_sdfec.h | 67 * This enum specifies which Turbo Decode algorithm is in use.
134 * @alg: Specifies which Turbo decode algorithm to use
135 * @scale: Specifies the extrinsic scaling to apply when the Max Scale algorithm
|
| /linux-6.15/Documentation/devicetree/bindings/interrupt-controller/ |
| D | opencores,or1k-pic.txt | 14 - #interrupt-cells : Specifies the number of cells needed to encode an
|
| D | jcore,aic.txt | 15 - #interrupt-cells: Specifies the number of cells needed to encode an
|
| D | ti,omap2-intc.txt | 11 - #interrupt-cells : Specifies the number of cells needed to encode an
|
| D | ti,omap-intc-irq.txt | 15 - #interrupt-cells : Specifies the number of cells needed to encode interrupt
|
| D | amazon,al-fic.txt | 8 - #interrupt-cells : must be 2. Specifies the number of cells needed to encode
|
| D | ti,cp-intc.txt | 12 - #interrupt-cells : Specifies the number of cells needed to encode an
|
| /linux-6.15/Documentation/devicetree/bindings/watchdog/ |
| D | men-a021-wdt.txt | 5 - gpios: Specifies the pins that control the Watchdog, order:
|
| /linux-6.15/Documentation/devicetree/bindings/net/ |
| D | lpc-eth.txt | 14 - mdio : specifies the mdio bus, used as a container for phy nodes according to
|
| /linux-6.15/Documentation/devicetree/bindings/extcon/ |
| D | extcon-rt8973a.txt | 13 - reg: Specifies the I2C slave address of the MUIC block. It should be 0x14
|
| /linux-6.15/Documentation/devicetree/bindings/ptp/ |
| D | ptp-ines.txt | 4 lives somewhere in the memory map and specifies the address of the
|
| /linux-6.15/Documentation/devicetree/bindings/rtc/ |
| D | cdns,rtc.txt | 8 - reg: Specifies base physical address and size of the register area.
|
| /linux-6.15/drivers/gpu/drm/nouveau/nvkm/falcon/ |
| D | cmdq.c | 118 /* specifies that we want to know the command status in the answer message */
120 /* specifies that we want an interrupt when the answer message is queued */
|
| /linux-6.15/include/linux/mmc/ |
| D | sd_uhs2.h | 45 * I/O Address specifies the address of register in UHS-II I/O space accessed by CCMD.
124 * I/O Address specifies the address of register in UHS-II I/O space accessed by CCMD.
|
| /linux-6.15/Documentation/devicetree/bindings/pinctrl/ |
| D | actions,s500-pinctrl.yaml | 40 Specifies the pin number and flags, as defined in
48 Specifies the pin number and flags, as defined in
|
| D | actions,s700-pinctrl.txt | 12 - gpio-ranges: Specifies the mapping between gpio controller and
17 - #interrupt-cells: Specifies the number of cells needed to encode an
|
| D | nvidia,tegra-pinmux-common.yaml | 106 through 3, where 0 specifies the least power and 3 specifies the most
|
| /linux-6.15/Documentation/ABI/testing/ |
| D | sysfs-class-led-trigger-netdev | 6 Specifies the network device name to monitor.
13 Specifies the duration of the LED blink in milliseconds.
|
| /linux-6.15/drivers/acpi/ |
| D | spcr.c | 181 * If the user specifies "traditional" earlycon, the qdf2400_e44 in acpi_parse_spcr()
185 * If the user specifies "SPCR" earlycon, then we need to update in acpi_parse_spcr()
|
| /linux-6.15/include/crypto/ |
| D | rng.h | 76 * @type: specifies the type of the cipher
77 * @mask: specifies the mask for the cipher
|
| /linux-6.15/Documentation/networking/ |
| D | xsk-tx-metadata.rst | 50 checksum. ``csum_start`` specifies byte offset of where the checksumming
51 should start and ``csum_offset`` specifies byte offset where the
|
| /linux-6.15/drivers/mtd/parsers/ |
| D | Kconfig | 181 The option specifies which Flash sectors holds the RedBoot
183 erase block number. A negative value specifies a number of
|
| /linux-6.15/Documentation/devicetree/bindings/gpio/ |
| D | nintendo,hollywood-gpio.txt | 9 - bit 0 specifies polarity (0 for normal, 1 for inverted).
|
12345678910>>...58