Searched full:ddr3 (Results 1 – 25 of 72) sorted by relevance
123
| /linux-5.10/include/dt-bindings/clock/ |
| D | rk3399-ddr.h | 7 * DDR3 SDRAM Standard Speed Bins include tCK, tRCD, tRP, tRAS and tRC for
11 /* DDR3-800 (5-5-5) */
13 /* DDR3-800 (6-6-6) */
15 /* DDR3-1066 (6-6-6) */
17 /* DDR3-1066 (7-7-7) */
19 /* DDR3-1066 (8-8-8) */
21 /* DDR3-1333 (7-7-7) */
23 /* DDR3-1333 (8-8-8) */
25 /* DDR3-1333 (9-9-9) */
27 /* DDR3-1333 (10-10-10) */
[all …]
|
| /linux-5.10/Documentation/devicetree/bindings/devfreq/ |
| D | rk3399_dmc.txt | 27 it selects the DDR3 cl-trp-trcd type. It must be
28 set according to "Speed Bin" in DDR3 datasheet,
30 for the DDR3 being used.
62 - rockchip,dram_dll_dis_freq : Defines the DDR3 DLL bypass frequency in MHz.
64 DDR3 DLL will be bypassed. Note: if DLL was bypassed,
72 - rockchip,ddr3_odt_dis_freq : When the DRAM type is DDR3, this parameter defines
78 - rockchip,ddr3_drv : When the DRAM type is DDR3, this parameter defines
82 - rockchip,ddr3_odt : When the DRAM type is DDR3, this parameter defines
86 - rockchip,phy_ddr3_ca_drv : When the DRAM type is DDR3, this parameter defines
91 - rockchip,phy_ddr3_dq_drv : When the DRAM type is DDR3, this parameter defines
[all …]
|
| /linux-5.10/drivers/clk/axis/ |
| D | clk-artpec6.c | 67 case 0: /* DDR3-2133 mode */ in of_artpec6_clkctrl_setup()
71 case 1: /* DDR3-1866 mode */ in of_artpec6_clkctrl_setup()
75 case 2: /* DDR3-1600 mode */ in of_artpec6_clkctrl_setup()
79 case 3: /* DDR3-1333 mode */ in of_artpec6_clkctrl_setup()
|
| /linux-5.10/drivers/gpu/drm/nouveau/nvkm/subdev/fb/ |
| D | sddr3.c | 48 /* the below are mentioned in some, but not all, ddr3 docs */
56 /* the below are mentioned in some, but not all, ddr3 docs */
64 /* the below are mentioned in some, but not all, ddr3 docs */
|
| /linux-5.10/arch/sh/include/mach-common/mach/ |
| D | urquell.h | 11 * CS2 | DDR3
56 #define DDR3BUPCR_OFS 0x1050 /* DDR3 Backup control register */
|
| /linux-5.10/drivers/edac/ |
| D | pnd2_edac.h | 221 u32 bg0 : 5; /* if ddr3, ba2 = bg0 */
222 u32 bg1 : 5; /* if ddr3, ba3 = bg1 */
|
| D | ti_edac.c | 5 * Texas Instruments DDR3 ECC error correction and detection driver
341 MODULE_DESCRIPTION("EDAC Driver for Texas Instruments DDR3 MC");
|
| /linux-5.10/Documentation/devicetree/bindings/clock/ |
| D | ti-keystone-pllctrl.txt | 4 and a majority of the peripheral clocks (all but the ARM CorePacs, DDR3 and
|
| /linux-5.10/arch/arm64/boot/dts/marvell/ |
| D | armada-3720-db.dts | 4 * (DB-88F3720-DDR3)
20 model = "Marvell Armada 3720 Development Board DB-88F3720-DDR3";
|
| D | armada-3720-uDPU.dts | 4 * Based on Marvell Armada 3720 development board (DB-88F3720-DDR3)
|
| /linux-5.10/Documentation/devicetree/bindings/edac/ |
| D | aspeed-sdram-edac.txt | 3 The Aspeed AST2500 SoC supports DDR3 and DDR4 memory with and without ECC (error
|
| /linux-5.10/Documentation/devicetree/bindings/arm/bcm/ |
| D | brcm,hr2.yaml | 12 A9 ARM CPUs, DDR2/DDR3 memory, PCIe GEN-2, USB 2.0 and USB 3.0, serial and NAND
|
| D | brcm,nsp.yaml | 14 DDR3 memory, PCIE Gen-2, USB 2.0 and USB 3.0, serial and NAND flash,
|
| /linux-5.10/include/linux/ |
| D | edac.h | 174 * @MEM_DDR3: DDR3 RAM
175 * @MEM_RDDR3: Registered DDR3 RAM
176 * This is a variant of the DDR3 memories.
177 * @MEM_LRDDR3: Load-Reduced DDR3 memory.
|
| /linux-5.10/Documentation/devicetree/bindings/memory-controllers/ |
| D | renesas,dbsc.yaml | 15 different names, e.g. "DDR Bus Controller (DBSC)", "DDR3 Bus State Controller
|
| /linux-5.10/arch/powerpc/platforms/44x/ |
| D | fsp2.h | 127 /* DDR3/4 Memory Controller */
164 /* PLB-Attached DDR3/4 Core Wrapper */
|
| /linux-5.10/Documentation/driver-api/memory-devices/ |
| D | ti-emif.rst | 30 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols.
|
| /linux-5.10/drivers/i2c/ |
| D | i2c-smbus.c | 312 * - Only works for DDR2, DDR3 and DDR4 for now
366 case 0x18: /* DDR3 */ in i2c_register_spd()
|
| /linux-5.10/drivers/memory/ |
| D | ti-emif-sram-pm.S | 231 * Output impedence calib needed only for DDR3
252 * configuration of the EMIF PHY, only for DDR3.
|
| /linux-5.10/Documentation/devicetree/bindings/memory-controllers/ti/ |
| D | emif.txt | 5 DDR2/DDR3/LPDDR2 protocols. This binding describes a given instance
|
| /linux-5.10/Documentation/hwmon/ |
| D | pxe1610.rst | 51 Used for DDR3/DDR4 Memory power regulation for Intel VR13 and
|
| D | jc42.rst | 109 which are used on many DDR3 memory modules for mobile devices and servers. Some
|
| /linux-5.10/arch/arm/mach-bcm/ |
| D | Kconfig | 65 Ethernet PHYs, DDR3 memory, PCIE Gen-2, USB 2.0 and USB 3.0, serial and
|
| /linux-5.10/arch/powerpc/platforms/85xx/ |
| D | Kconfig | 115 (DDR3/3L, SATA II, and PCI Express).
|
| /linux-5.10/arch/sh/boards/ |
| D | board-urquell.c | 44 * 0x08000000 - 0x10000000 (CS2-CS3) DDR3
|
123