Searched full:cfam (Results 1 – 19 of 19) sorted by relevance
| /linux-5.10/Documentation/devicetree/bindings/fsi/ |
| D | ibm,fsi2spi.yaml | 13 This binding describes an FSI CFAM engine called the FSI2SPI. Therefore this
14 node will always be a child of an FSI CFAM node; see fsi.txt for details on
15 FSI slave and CFAM nodes. This FSI2SPI engine provides access to a number of
|
| D | fsi-master-aspeed.txt | 16 - cfam-reset-gpios: GPIO for CFAM reset
35 cfam-reset-gpios = <&gpio0 ASPEED_GPIO(Q, 0) GPIO_ACTIVE_LOW>;
|
| D | fsi.txt | 74 cfam@1,2 {
127 /* A FSI slave (aka. CFAM) at link 0, ID 0. */
128 cfam@0,0 {
|
| D | ibm,p9-occ.txt | 5 service processor. See fsi.txt for details on bindings for FSI slave and CFAM
|
| /linux-5.10/arch/arm/boot/dts/ |
| D | ibm-power9-dual.dtsi | 5 cfam@0,0 {
106 cfam@1,0 {
|
| D | aspeed-bmc-ibm-rainier.dts | 149 /*Q0-Q7*/ "cfam-reset","","","","","","","",
198 * CFAM Reset is supposed to be active low but pass1 hardware is wired
201 cfam-reset-gpios = <&gpio0 ASPEED_GPIO(Q, 0) GPIO_ACTIVE_HIGH>;
203 cfam@0,0 {
315 cfam@1,0 {
425 cfam@2,0 {
|
| D | aspeed-bmc-opp-tacoma.dts | 121 /*Q0-Q7*/ "cfam-reset","","","","","","","fsi-routing",
193 cfam-reset-gpios = <&gpio0 ASPEED_GPIO(Q, 0) GPIO_ACTIVE_LOW>;
195 cfam@0,0 {
296 cfam@1,0 {
|
| D | aspeed-bmc-opp-palmetto.dts | 354 cfam@0,0 {
|
| D | aspeed-bmc-opp-nicole.dts | 219 /*A0-A7*/ "","cfam-reset","","","","","fsi-mux","",
|
| D | aspeed-bmc-opp-romulus.dts | 235 /*A0-A7*/ "","cfam-reset","","","","","fsi-mux","",
|
| D | aspeed-bmc-opp-zaius.dts | 482 /*A0-A7*/ "","cfam-reset","","","","","","",
|
| D | aspeed-bmc-opp-witherspoon.dts | 202 /*A0-A7*/ "","cfam-reset","","","","","fsi-mux","",
|
| /linux-5.10/Documentation/devicetree/bindings/i2c/ |
| D | i2c-fsi.txt | 6 - reg = < address size >; : The FSI CFAM address and address
|
| /linux-5.10/Documentation/ABI/testing/ |
| D | sysfs-bus-fsi | 45 Provides a means of resetting the cfam that is attached to the
|
| /linux-5.10/drivers/fsi/ |
| D | fsi-core.c | 10 * - s/cfam/chip (cfam_id -> chip_id etc...)
904 return kasprintf(GFP_KERNEL, "fsi/cfam%d", slave->cdev_idx); in cfam_devnode()
906 return kasprintf(GFP_KERNEL, "cfam%d", slave->cdev_idx); in cfam_devnode()
911 .name = "cfam",
1009 dev_warn(&master->dev, "slave %02x:%02x invalid cfam id CRC!\n", in fsi_slave_init()
|
| D | fsi-master-aspeed.c | 449 gpio = devm_gpiod_get_optional(dev, "cfam-reset", GPIOD_OUT_LOW); in setup_cfam_reset()
550 dev_err(&pdev->dev, "CFAM reset GPIO setup failed\n"); in fsi_master_aspeed_probe()
|
| D | fsi-master.h | 85 #define FSI_POST_BREAK_CLOCKS 16000 /* Number clocks to set up cfam */
|
| D | fsi-sbefifo.c | 72 /* CFAM GP Mailbox SelfBoot Message register */
|
| /linux-5.10/drivers/spi/ |
| D | spi-fsi.c | 77 struct fsi_device *fsi; /* FSI2SPI CFAM engine device */
|