| /linux-6.8/Documentation/arch/arm/sa1100/ |
| D | serial_uart.rst | 13 > Okay. Note that device numbers 204 and 205 are used for "low density
25 > 205 char Low-density serial ports (alternate device)
37 mknod cusa0 c 205 5
38 mknod cusa1 c 205 6
39 mknod cusa2 c 205 7
|
| /linux-6.8/drivers/video/logo/ |
| D | logo_spe_clut224.ppm | 112 192 191 189 192 191 189 221 205 205 240 240 240 253 253 253 253 253 253
118 38 38 38 56 56 56 7 7 9 221 205 205 253 253 253 233 233 233
119 221 205 205 233 233 233 251 251 251 253 253 253 253 253 253 253 253 253
141 221 205 205 192 191 189 29 29 31 27 27 27 9 9 12 2 2 6
195 221 205 205 253 253 253 253 253 253 253 253 253 253 253 253 240 240 240
|
| /linux-6.8/drivers/net/wireless/broadcom/b43/ |
| D | phy_lcn.c | 438 { 3, { 1, 302, 1841, 129, 258, 129, 658, 1720, 205, 410, 205, in b43_phy_lcn_load_tx_iir_cck_filter()
440 { 20, { 1, 360, 1884, 242, 1734, 242, 752, 1720, 205, 1845, 205, in b43_phy_lcn_load_tx_iir_cck_filter()
442 { 21, { 1, 360, 1884, 149, 1874, 149, 752, 1720, 205, 1883, 205, in b43_phy_lcn_load_tx_iir_cck_filter()
444 { 22, { 1, 360, 1884, 98, 1948, 98, 752, 1720, 205, 1924, 205, in b43_phy_lcn_load_tx_iir_cck_filter()
446 { 23, { 1, 350, 1884, 116, 1966, 116, 752, 1720, 205, 2008, 205, in b43_phy_lcn_load_tx_iir_cck_filter()
458 { 30, { 1, 302, 1841, 61, 122, 61, 658, 1720, 205, 410, 205, in b43_phy_lcn_load_tx_iir_cck_filter()
|
| /linux-6.8/drivers/media/platform/ti/omap3isp/ |
| D | gamma_table.h | 37 203, 203, 204, 204, 204, 204, 205, 205, 205, 205, 206, 206, 206, 206, 207, 207,
|
| /linux-6.8/drivers/staging/media/atomisp/pci/isp/kernels/gc/gc_1.0/ |
| D | ia_css_gc_table.host.c | 41 202, 203, 203, 204, 204, 205, 205, 206,
|
| /linux-6.8/tools/testing/selftests/net/forwarding/ |
| D | router_mpath_nh.sh | 157 ip nexthop del id 205
184 ip nexthop add id 205 via fe80:3::13 dev $rp23
185 ip nexthop add id 206 group 204/205
|
| D | router_mpath_nh_res.sh | 155 ip nexthop del id 205
185 ip nexthop add id 205 via fe80:3::13 dev $rp23
186 ip nexthop add id 206 group 204/205 type resilient buckets 512 \
|
| /linux-6.8/Documentation/devicetree/bindings/pinctrl/ |
| D | mediatek,mt8188-pinctrl.yaml | 105 - enum: [200, 201, 202, 203, 204, 205, 206, 207]
131 - enum: [200, 201, 202, 203, 204, 205, 206, 207]
|
| D | mediatek,mt8195-pinctrl.yaml | 110 - enum: [200, 201, 202, 203, 204, 205, 206, 207]
158 - enum: [200, 201, 202, 203, 204, 205, 206, 207]
|
| /linux-6.8/include/dt-bindings/pinctrl/ |
| D | mt65xx.h | 24 #define MTK_PULL_SET_RSEL_101 205
|
| /linux-6.8/fs/afs/ |
| D | afs_cm.h | 16 CBInitCallBackState = 205, /* initialise callback state */
|
| /linux-6.8/Documentation/devicetree/bindings/thermal/ |
| D | st-thermal.txt | 30 interrupts = <GIC_SPI 205 IRQ_TYPE_EDGE_RISING>;
|
| /linux-6.8/include/dt-bindings/clock/ |
| D | rk3368-cru.h | 100 #define ACLK_ISP 205
349 #define SRST_CCI 205
|
| /linux-6.8/drivers/usb/storage/ |
| D | unusual_isd200.h | 41 "USB Cable 205",
|
| /linux-6.8/Documentation/devicetree/bindings/soc/mediatek/ |
| D | mediatek,mt7986-wo-ccif.yaml | 50 interrupts = <GIC_SPI 205 IRQ_TYPE_LEVEL_HIGH>;
|
| /linux-6.8/include/uapi/linux/ |
| D | pr.h | 66 #define IOC_PR_CLEAR _IOW('p', 205, struct pr_clear)
|
| /linux-6.8/arch/xtensa/kernel/syscalls/ |
| D | syscall.tbl | 223 # 205 was old nfsservctl
224 205 common nfsservctl sys_ni_syscall
|
| /linux-6.8/drivers/platform/x86/intel/wmi/ |
| D | thunderbolt.c | 20 #define INTEL_WMI_THUNDERBOLT_GUID "86CCFD48-205E-4A77-9C48-2021CBEDE341"
|
| /linux-6.8/drivers/pcmcia/ |
| D | xxs1500_ss.c | 38 * 205: buffer enable (low-act)
48 #define GPIO_OUTEN 205
|
| /linux-6.8/drivers/pinctrl/intel/ |
| D | pinctrl-icelake.c | 262 PINCTRL_PIN(205, "DDPA_CTRLCLK"),
624 PINCTRL_PIN(205, "SD3_CMD"),
655 ICL_GPP(0, 205, 212, INTEL_GPIO_BASE_ZERO), /* GPP_G */
662 ICL_N_COMMUNITY(3, 205, 212, icln_community5_gpps),
|
| /linux-6.8/arch/arm/boot/dts/mediatek/ |
| D | mt2701-pinfunc.h | 556 #define MT2701_PIN_205_PWM2__FUNC_GPIO205 (MTK_PIN_NO(205) | 0)
557 #define MT2701_PIN_205_PWM2__FUNC_PWM2 (MTK_PIN_NO(205) | 1)
558 #define MT2701_PIN_205_PWM2__FUNC_CLKM2 (MTK_PIN_NO(205) | 2)
559 #define MT2701_PIN_205_PWM2__FUNC_G1_TXD0 (MTK_PIN_NO(205) | 5)
560 #define MT2701_PIN_205_PWM2__FUNC_DBG_MON_B_20 (MTK_PIN_NO(205) | 7)
|
| /linux-6.8/drivers/staging/media/atomisp/pci/ |
| D | sh_css_params.c | 363 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4,
364 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4,
445 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4,
446 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4, 205 << 4,
|
| /linux-6.8/include/uapi/sound/intel/avs/ |
| D | tokens.h | 32 AVS_TKN_AFMT_CHANNEL_CFG_U32 = 205,
|
| /linux-6.8/Documentation/devicetree/bindings/net/ |
| D | samsung-sxgbe.txt | 45 <0 204 4>, <0 205 4>, <0 206 4>, <0 207 4>,
|
| /linux-6.8/include/dt-bindings/reset/ |
| D | amlogic,meson-axg-reset.h | 107 #define RESET_PERIPHS_SPI_0 205
|