Searched +full:0 +full:x00064000 (Results 1 – 10 of 10) sorted by relevance
/linux-5.10/arch/arm/boot/dts/ |
D | tegra124-nyan-blaze-emc.dtsi | 78 nvidia,emc-auto-cal-config = <0xa1430000>; 79 nvidia,emc-auto-cal-config2 = <0x00000000>; 80 nvidia,emc-auto-cal-config3 = <0x00000000>; 81 nvidia,emc-auto-cal-interval = <0x001fffff>; 82 nvidia,emc-bgbias-ctl0 = <0x00000008>; 83 nvidia,emc-cfg = <0x73240000>; 84 nvidia,emc-cfg-2 = <0x000008c5>; 85 nvidia,emc-ctt-term-ctrl = <0x00000802>; 86 nvidia,emc-mode-1 = <0x80100003>; 87 nvidia,emc-mode-2 = <0x80200008>; [all …]
|
D | tegra124-nyan-big-emc.dtsi | 229 nvidia,emc-auto-cal-config = <0xa1430000>; 230 nvidia,emc-auto-cal-config2 = <0x00000000>; 231 nvidia,emc-auto-cal-config3 = <0x00000000>; 232 nvidia,emc-auto-cal-interval = <0x001fffff>; 233 nvidia,emc-bgbias-ctl0 = <0x00000008>; 234 nvidia,emc-cfg = <0x73240000>; 235 nvidia,emc-cfg-2 = <0x000008c5>; 236 nvidia,emc-ctt-term-ctrl = <0x00000802>; 237 nvidia,emc-mode-1 = <0x80100003>; 238 nvidia,emc-mode-2 = <0x80200008>; [all …]
|
D | lpc3250-phy3250.dts | 18 reg = <0x80000000 0x4000000>; 25 gpios = <&gpio 5 1 0>; /* GPO_P3 1, GPIO 80, active high */ 30 gpios = <&gpio 5 14 0>; /* GPO_P3 14, GPIO 93, active high */ 51 gpio = <&gpio 5 4 0>; 61 gpio = <&gpio 5 0 0>; 71 gpio = <&gpio 5 5 0>; 84 arm,pl11x,tft-r0g0b0-pads = <0 8 16>; 94 reg = <0x18>; 95 power-gpio = <&gpio 3 10 0>; 96 reset-gpio = <&gpio 3 2 0>; [all …]
|
D | dra7-l4.dtsi | 1 &l4_cfg { /* 0x4a000000 */ 3 reg = <0x4a000000 0x800>, 4 <0x4a000800 0x800>, 5 <0x4a001000 0x1000>; 9 ranges = <0x00000000 0x4a000000 0x100000>, /* segment 0 */ 10 <0x00100000 0x4a100000 0x100000>, /* segment 1 */ 11 <0x00200000 0x4a200000 0x100000>; /* segment 2 */ 13 segment@0 { /* 0x4a000000 */ 17 ranges = <0x00000000 0x00000000 0x000800>, /* ap 0 */ 18 <0x00000800 0x00000800 0x000800>, /* ap 1 */ [all …]
|
D | omap5-l4.dtsi | 1 &l4_cfg { /* 0x4a000000 */ 3 reg = <0x4a000000 0x800>, 4 <0x4a000800 0x800>, 5 <0x4a001000 0x1000>; 9 ranges = <0x00000000 0x4a000000 0x080000>, /* segment 0 */ 10 <0x00080000 0x4a080000 0x080000>, /* segment 1 */ 11 <0x00100000 0x4a100000 0x080000>, /* segment 2 */ 12 <0x00180000 0x4a180000 0x080000>, /* segment 3 */ 13 <0x00200000 0x4a200000 0x080000>, /* segment 4 */ 14 <0x00280000 0x4a280000 0x080000>, /* segment 5 */ [all …]
|
D | omap4-l4.dtsi | 2 &l4_cfg { /* 0x4a000000 */ 4 reg = <0x4a000000 0x800>, 5 <0x4a000800 0x800>, 6 <0x4a001000 0x1000>; 10 ranges = <0x00000000 0x4a000000 0x080000>, /* segment 0 */ 11 <0x00080000 0x4a080000 0x080000>, /* segment 1 */ 12 <0x00100000 0x4a100000 0x080000>, /* segment 2 */ 13 <0x00180000 0x4a180000 0x080000>, /* segment 3 */ 14 <0x00200000 0x4a200000 0x080000>, /* segment 4 */ 15 <0x00280000 0x4a280000 0x080000>, /* segment 5 */ [all …]
|
/linux-5.10/Documentation/devicetree/bindings/memory-controllers/ |
D | nvidia,tegra124-emc.yaml | 38 "^emc-timings-[0-9]+$": 48 "^timing-[0-9]+$": 79 minimum: 0 142 minimum: 0 340 reg = <0x70019000 0x1000>; 352 reg = <0x7001b000 0x1000>; 358 emc-timings-0 { 361 timing-0 { 364 nvidia,emc-auto-cal-config = <0xa1430000>; 365 nvidia,emc-auto-cal-config2 = <0x00000000>; [all …]
|
/linux-5.10/Documentation/devicetree/bindings/mtd/ |
D | lpc32xx-mlc.txt | 28 reg = <0x200A8000 0x11000>; 29 interrupts = <11 0>; 44 reg = <0x00000000 0x00064000>;
|
D | lpc32xx-slc.txt | 29 reg = <0x20020000 0x1000>; 46 reg = <0x00000000 0x00064000>;
|
/linux-5.10/drivers/mtd/parsers/ |
D | sharpslpart.c | 43 #define BLOCK_IS_RESERVED 0xffff 49 #define SHARPSL_PARTINFO1_LADDR 0x00060000 50 #define SHARPSL_PARTINFO2_LADDR 0x00064000 52 #define BOOT_MAGIC 0x424f4f54 53 #define FSRO_MAGIC 0x4653524f 54 #define FSRW_MAGIC 0x46535257 72 u8 freebytes = 0; in sharpsl_nand_check_ooblayout() 73 int section = 0; in sharpsl_nand_check_ooblayout() 91 if (freebytes == 0xff) in sharpsl_nand_check_ooblayout() 92 return 0; in sharpsl_nand_check_ooblayout() [all …]
|