Lines Matching +full:mt7621 +full:- +full:gpio
1 # SPDX-License-Identifier: GPL-2.0-only
13 dynamic device discovery; some are even write-only or read-only.
17 chips, analog to digital (and d-to-a) converters, and more.
44 If your system has an master-capable SPI controller (which
56 by providing a high-level interface to send memory-like commands.
69 This enables support for SPI-NAND mode on the Airoha NAND
71 is implemented as a SPI-MEM controller.
107 This enables master mode support for the SPISG (SPI scatter-gather
119 to a single device like spi-nor (nvram), input device controller
178 supports spi-mem interface.
255 With a few GPIO pins, your system can bitbang the SPI protocol.
256 Select this to get SPI support through I/O pins (GPIO, parallel
258 this code to manage the per-word or per-transfer accesses to the
288 Flash over 1/2/4-bit wide bus. Enable this option if you have a
300 Flash over up to 8-bit wide bus. Enable this option if you have a
314 This enables dedicated general purpose SPI/Microwire1-compatible
315 master mode interface (SSI1) for CLPS711X-based CPUs.
333 tristate "Texas Instruments DaVinci/DA8x/OMAP-L/AM1x SoC SPI controller"
337 SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules.
355 tristate "Memory-mapped io interface driver for DW SPI core"
359 tristate "Baikal-T1 SPI driver for DW SPI core"
363 Baikal-T1 SoC is equipped with three DW APB SSI-based MMIO SPI
366 part of the Baikal-T1 System Boot Controller has got a very
368 chip-select and Tx/Rx FIFO with just 8 words depth available.
369 The later one is normally connected to an external SPI-nor flash
373 bool "Directly mapped Baikal-T1 Boot SPI flash support"
377 Baikal-T1 System Boot Controller. It is a 16MB MMIO region, which
382 time-critical tasks (like the SPI memory operations implemented
388 tristate "Diolan DLN-2 USB SPI adapter"
395 will be called spi-dln2.
408 The external bus unit (EBU) found on the FALC-ON SoC has SPI
435 supports the high-level SPI memory interface.
452 will be called hisi-kunpeng-spi.
471 supports the high-level SPI memory interface.
474 tristate "GPIO-based bitbanging SPI Master"
478 This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
481 except that the spi_board_info.controller_data holds the GPIO number
486 GPIO operations, you should be able to leverage that for better
509 will be called spi-ingenic.
530 will be called spi-intel-pci.
542 exposes the low level SPI-NOR opcodes to the software. Using
549 will be called spi-intel-platform.
552 tristate "J-Core SPI Master"
555 This enables support for the SPI master controller in the J-Core
568 will be called spi-kspi2.
606 tristate "ICP DAS LP-8841 SPI Controller for RTC"
610 DS-1302 real time clock.
613 LP-8x4x industrial computer.
616 tristate "Freescale MPC52xx SPI (non-PSC) controller support"
681 will be called spi-ljca.
706 If built as a module, it will be called spi-microchip-core.
715 If built as a module, it will be called spi-microchip-core-qspi.
727 tristate "MediaTek MT7621 SPI Controller"
730 This selects a driver for the MediaTek MT7621 SPI Controller.
747 This enables support for SPI-NAND mode on the MediaTek NAND
749 is implemented as a SPI-MEM controller with pipelined ECC
761 supports the spi-mem interface.
771 supports spi-mem interface.
839 called as spi-pci1xxxx.
883 tristate "Realtek SPI-NAND Flash Controller"
887 This enables support for the SPI-NAND Flash controller on
891 only supports the spi-mem interface.
924 tristate "Renesas RPC-IF SPI driver"
927 SPI driver for Renesas R-Car Gen3 or RZ/G2 RPC-IF.
971 for serial peripheral interface (SPI) mini-core. SPI in master
984 yes to this option, support will be included for the built-in SPI
988 will be called spi-geni-qcom.
1051 for connecting an SPI Flash memory over up to 8-bit wide bus.
1095 supports spi-mem interface.
1105 supports spi-mem interface.
1108 tristate "STMicroelectronics SPI SSC-based driver"
1133 called as spi-sunplus-sp7021.
1144 that use the de-facto standard SPI protocol.
1146 It also supports the new dual-bit and quad-bit SPI protocol.
1228 tristate "Analog Devices AD-FMCOMMS1-EBZ SPI-I2C-bridge driver"
1231 Support for the SPI-I2C bridge found on the Analog Devices
1232 AD-FMCOMMS1-EBZ board.
1305 select one or more specific mux-controller drivers.
1333 sysfs interface, with each line presented as a kind of GPIO
1349 If your system has a slave-capable SPI controller, you can enable
1376 tristate "SPI offload trigger using ADI sigma-delta utility"
1378 SPI offload trigger from ADI sigma-delta utility FPGA IP block.