Documentation/networking/arcnet-hardware.rst

804    < |         SW1         | |     SW2     |                            |
830   SW1	1-6:	I/O Base Address Select
890 The first six switches in switch group SW1 are used to select one
933 Switches seven through ten of switch group SW1 are used to select the
1064   SW1: DIP-Switches for Station Address
1086 The station address is binary-coded with SW1.
1342    |                    |      90C65        ||       SW1       |  ____|
1420 The last three switches in switch block SW1 are used to select one
1443 Switches 1-5 of switch block SW1 select the Memory Base address.
1555   <        |     PROM      |         |         SW1         |    A | 2 | ID3
1574   SW1 1-6:    Base I/O Address Select
1629 The first six switches in switch block SW1 are used to select the I/O Base
1651 The switches 7-10 of switch block SW1 are used to select the Memory
1715    |   |   SW1    |                                         LED |__|
1840   | |SW1|                 o|o          |
1851   SW1 1-6     Base I/O Address Select
1892 The switches 1 to 6 of switch block SW1 are used to select one
1917 Jumpers 7-10 of switch block SW1 select the Memory Base address::
1973 	 | |             | SW1     | XTAL | ____________     | S |
1982 	 | |   SW1   | ON        |         |     |I     |        |
1996   SW1 1-5:    Base Memory Address Select
2033 The last three switches in switch block SW1 are used to select one
2057 Jumpers 3-5 of switch block SW1 select the Memory Base address.
2118   | |SW1 MEM+I/O|  |_________________________|                   LED1|__|)
2142   SW1 1-5     Base Memory Address Select
2179 The last three switches in switch block SW1 are used to select one
2203 Jumpers 3-5 of switch block SW1 select the Memory Base address.
2486    |           |o|o|o|o|o|o|o|o|  |      SW1      ||      SW2      ||
2511 The eight switches in group SW1 are used to set the node ID.
2662 8-Bit card, because there isn't any letter like "SW1" written to the
2748 The first three switches in switch group SW1 are used to select one
2769 Switches 6-8 of switch group SW1 select the Base of the 16K block.
2771 positions, determined by the offset, switches 4 and 5 of group SW1::
2845 	 | |             | SW1                         |     |    |   | ID6
2868   SW1 1-5:    Base Memory Address Select
2877 Although the jumpers SW1 and SW3 are marked SW, not JP, they are jumpers, not
2928 The last three switches in switch block SW1 are used to select one
2952 Jumpers 3-5 of jumper block SW1 select the Memory Base address.
3019    |  |      SW1       |     |      SL90C65 |    :     |-           |  |
3037   SW1	1-5:	IRQ Select
3048 SW1: Timeouts, Interrupt and ROM
3052 up (on) SW1...(switches 1-5)
3055 The switches on SW1 labeled EXT1 (switch 6) and EXT2 (switch 7)
3059    To enable the 8K Boot PROM position SW1 switch 8 on (UP) labeled ROM.