Lines Matching +full:protected +full:- +full:clocks

54 	DRM_FORCE_ON_DIGITAL, /* for DVI-I use digital connector */
58 * enum drm_connector_status - status for a &drm_connector
73 * nothing there. It is driver-dependent whether a connector with this
80 * flicker (like load-detection when the connector is in use), or when a
81 * hardware resource isn't available (like when load-detection needs a
91 * enum drm_connector_registration_state - userspace registration status for
124 * - An unregistered connector may only have its DPMS changed from
125 * On->Off. Once DPMS is changed to Off, it may not be switched back
127 * - Modesets are not allowed on unregistered connectors, unless they
131 * - Removing a CRTC from an unregistered connector is OK, but new
148 * enum drm_connector_tv_mode - Analog TV output mode
158 * @DRM_MODE_TV_MODE_NTSC: CCIR System M (aka 525-lines)
184 * @DRM_MODE_TV_MODE_PAL_M: CCIR System M (aka 525-lines)
226 * struct drm_scdc - Information about scdc capabilities of a HDMI 2.0 sink
247 * struct drm_hdmi_dsc_cap - DSC capabilities of HDMI sink
288 * struct drm_hdmi_info - runtime information about the connected HDMI sink
291 * This information is available in CEA-861-F extension blocks (like HF-VSDB).
300 * defined by the CEA-861-G spec is 219, so the size is 256 bits to map
308 * the CEA-861-G spec is 219, so the size is 256 bits to map up to 256
327 * enum drm_link_status - connector's link_status property value
343 * enum drm_panel_orientation - panel_orientation info for &drm_display_info
357 * the panel is mounted upside-down.
364 DRM_MODE_PANEL_ORIENTATION_UNKNOWN = -1,
372 * struct drm_monitor_range_info - Panel's Monitor range in EDID for
389 * struct drm_luminance_range_info - Panel's luminance range for
405 * enum drm_privacy_screen_status - privacy screen status
408 * screen present on some display panels, via the "privacy-screen sw-state"
409 * and "privacy-screen hw-state" properties. Note the _LOCKED enum values
410 * are only valid for the "privacy-screen hw-state" property.
413 * The privacy-screen on the panel is disabled
415 * The privacy-screen on the panel is enabled
417 * The privacy-screen on the panel is disabled and locked (cannot be changed)
419 * The privacy-screen on the panel is enabled and locked (cannot be changed)
429 * enum drm_colorspace - color space
439 * HDMI definitions come from the CTA-861-H spec
458 * ITU-R BT.709 colorimetry format
476 * ITU-R BT.2020 Y'c C'bc C'rc (constant luminance) colorimetry format
479 * ITU-R BT.2020 R' G' B' colorimetry format
482 * ITU-R BT.2020 Y' C'b C'r colorimetry format
495 * (scRGB (IEC 61966-2-2)) colorimetry format
498 * ITU-R BT.601 colorimetry format
531 * enum drm_bus_flags - bus_flags info for &drm_display_info
636 * Set if the Sharp-specific signals (SPL, CLS, PS, REV) must be used
642 * struct drm_display_info - runtime data about the connected sink
645 * fixed display sinks like built-in panels there's not much difference between
679 * @panel_orientation: Read only connector property for built-in panels,
720 * @dvi_dual: Dual-link DVI sink?
789 * @mso_stream_count: eDP Multi-SST Operation (MSO) stream count from
790 * the DisplayID VESA vendor block. 0 for conventional Single-Stream
796 * @mso_pixel_overlap: eDP MSO segment pixel overlap, 0-8 pixels.
823 * Vendor-Specific Data Block, for CEC usage.
835 * struct drm_connector_tv_margins - TV connector related margins
863 * struct drm_tv_connector_state - TV connector related states
891 * struct drm_connector_state - mutable connector state
933 * @commit: Tracks the pending commit to prevent use-after-free conditions.
975 * protected content. This is most commonly used for HDCP.
981 * upscaling, mostly used for built-in panels.
1001 * Holds the framebuffer and out-fence for a writeback connector. As
1037 * struct drm_connector_funcs - control connectors on a given device
1047 * Legacy entry point to set the per-connector DPMS state. Legacy DPMS
1137 * received for this output connector->edid must be NULL.
1156 * driver-private properties. For atomic drivers it is not used because
1202 * when a connector is being hot-unplugged for drivers that support
1221 * state structure to extend it with driver-private state should use
1254 * Decode a driver-private property value and store the decoded value
1255 * into the passed-in state structure. Since the atomic core decodes all
1260 * Such driver-private properties should really only be implemented for
1269 * driver-private atomic properties.
1286 * 0 if the property has been found, -EINVAL if the property isn't
1301 * Reads out the decoded driver-private property. This is used to
1308 * driver-private atomic properties.
1312 * 0 on success, -EINVAL if the property isn't implemented by the
1336 * This will get called when a hotplug-event for a drm-connector
1345 * Allows connectors to create connector-specific debugfs files.
1351 * struct drm_cmdline_mode - DRM Mode passed through the kernel command-line
1355 * express those parameters and will be filled by the command-line
1369 * Has a mode been read from the command-line?
1473 * drm-connector "panel orientation" property override value,
1497 * struct drm_connector - central DRM connector control structure
1524 * &drm_mode_config.connector_list. Protected by
1533 * Connector entry in the global connector-list, used by
1546 * @registered. Most of the connector state is still protected by
1553 * the mode_config.list for drivers not supporting hot-add/removing. Can
1597 * Protected by @mutex.
1604 * Protected by &drm_mode_config.mutex.
1611 * Protected by &drm_mode_config.mutex.
1618 * filtering is applied. Used by the probe helpers. Protected by
1625 * when a display is detected. For non hot-pluggable displays such as
1630 * Protected by &drm_mode_config.mutex.
1638 * @edid_blob_ptr: DRM property containing EDID if present. Protected by
1687 /** @privacy_screen_notifier: privacy-screen notifier_block */
1737 /** @helper_private: mid-layer private data */
1770 * Only really meaningful for non-atomic drivers. Atomic drivers should
1777 /** @eld: EDID-like data, if present */
1814 * in Displayport compliance testing - Displayport Link CTS Core 1.2
1833 * This is protected by &drm_mode_config.connection_mutex. Note that
1852 * genlocked clocks. For tiled panels which are genlocked, like
1853 * dual-link LVDS or dual-link DSI, the driver should try to not expose
1917 return connector->index; in drm_connector_index()
1922 return 1 << connector->index; in drm_connector_mask()
1926 * drm_connector_lookup - lookup connector object
1944 * drm_connector_get - acquire a connector reference
1951 drm_mode_object_get(&connector->base); in drm_connector_get()
1955 * drm_connector_put - release a connector reference
1963 drm_mode_object_put(&connector->base); in drm_connector_put()
1967 * drm_connector_is_unregistered - has the connector been unregistered from
1980 return READ_ONCE(connector->registration_state) == in drm_connector_is_unregistered()
2057 * struct drm_tile_group - Tile group metadata
2061 * @group_data: Sink-private data identifying this group
2081 * struct drm_connector_list_iter - connector_list iterator
2111 * drm_for_each_connector_iter - connector_list iterator macro
2123 * drm_connector_for_each_possible_encoder - iterate connector's possible encoders
2128 drm_for_each_encoder_mask(encoder, (connector)->dev, \
2129 (connector)->possible_encoders)