Lines Matching +full:temperature +full:- +full:lookup +full:- +full:table

1 # SPDX-License-Identifier: GPL-2.0-only
12 	  Each thermal zone contains its own temperature, trip points,
25 	  zones discovery, temperature readings and events such as
44 	int "Emergency poweroff delay in milli-seconds"
132 	  Select this if you want to control temperature based on
147 	bool "Fair-share thermal governor"
149 	  Enable this to manage platform thermals using fair-share governor.
163 	  Say 'Y' here if you want to use two point temperature regulation
229 	  directory to support temperature emulation. With emulation sysfs node,
230 	  user can manually input temperature and test the different trip
235 	  flooding this sysfs node with low temperature values.
243 	  memory-mapped reads to get the temperature.  Any HW/System that
244 	  allows temperature reading by a single memory-mapped reading, be it
260 	tristate "Temperature sensor driver for Freescale i.MX SoCs"
266 	  Support for Temperature Monitor (TEMPMON) found on Freescale i.MX SoCs.
272 	tristate "Temperature sensor driver for NXP i.MX SoCs with System Controller"
276 	  Support for Temperature Monitor (TEMPMON) found on NXP i.MX SoCs with
278 	  controller via MU (message unit) IPC to get temperature from thermal
283 	tristate "Temperature sensor driver for Freescale i.MX8MM SoC"
298 	  - AM654
300 	  This includes temperature reading functionality.
303 	tristate "Temperature sensor driver for Maxim MAX77620 PMIC"
307 	  Support for die junction temperature warning alarm for Maxim
309 	  interrupts when PMIC die temperature cross the threshold of
344 	  module will be called sun8i-thermal.
352 	  Rockchip thermal driver provides support for Temperature sensor
353 	  ADC (TS-ADC) found on Rockchip SoCs. It supports one critical
355 	  CPUs when the Temperature crosses the passive trip point.
358 	tristate "Renesas R-Car thermal driver"
362 	  Enable this to plug the R-Car thermal sensor driver into the Linux
366 	tristate "Renesas R-Car Gen3 and RZ/G2 thermal driver"
371 	  Enable this to plug the R-Car Gen3 or RZ/G2 thermal sensor driver into
384 	tristate "Temperature sensor on Marvell Kirkwood SoCs"
393 	tristate "Temperature sensor on Marvell Dove SoCs"
426 	  This will report PMIC junction over-temperature for one thermal trip
460 source "drivers/thermal/ti-soc-thermal/Kconfig"
479 	  This enabled a thermal sysfs driver for the temperature sensor
482 	  to this driver. This driver reports the temperature by reading ADC
483 	  channel and converts it to temperature based on lookup table.
495 	  Enable this to plug in UniPhier on-chip PVT thermal driver into the
496 	  thermal framework. The driver supports CPU thermal zone temperature
500 	tristate "Temperature sensor on Spreadtrum SoCs"
517 	tristate "Loongson-2 SoC series thermal driver"
521 	  Support for Thermal driver found on Loongson-2 SoC series platforms.
523 	  are used to obtain the temperature of the current node and set the
524 	  temperature range to trigger the interrupt. When the input temperature
525 	  is higher than the high temperature threshold or lower than the low
526 	  temperature threshold, the interrupt will occur.