Lines Matching +full:access +full:- +full:controllers
1 # SPDX-License-Identifier: GPL-2.0-only
13 dynamic device discovery; some are even write-only or read-only.
17 chips, analog to digital (and d-to-a) converters, and more.
24 work with most such devices and controllers.
44 If your system has an master-capable SPI controller (which
56 by providing a high-level interface to send memory-like commands.
112 tristate "Aspeed flash controllers in SPI mode"
145 supports spi-mem interface.
224 this code to manage the per-word or per-transfer accesses to the
254 Flash over 1/2/4-bit wide bus. Enable this option if you have a
255 device with a Cadence QSPI controller and want to access the
266 Flash over up to 8-bit wide bus. Enable this option if you have a
267 device with a Cadence XSPI controller and want to access the
274 This enables dedicated general purpose SPI/Microwire1-compatible
275 master mode interface (SSI1) for CLPS711X-based CPUs.
292 tristate "Texas Instruments DaVinci/DA8x/OMAP-L/AM1x SoC SPI controller"
296 SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules.
314 tristate "Memory-mapped io interface driver for DW SPI core"
318 tristate "Baikal-T1 SPI driver for DW SPI core"
322 Baikal-T1 SoC is equipped with three DW APB SSI-based MMIO SPI
323 controllers. Two of them are pretty much normal: with IRQ, DMA,
325 part of the Baikal-T1 System Boot Controller has got a very
327 chip-select and Tx/Rx FIFO with just 8 words depth available.
328 The later one is normally connected to an external SPI-nor flash
332 bool "Directly mapped Baikal-T1 Boot SPI flash support"
336 Baikal-T1 System Boot Controller. It is a 16MB MMIO region, which
337 can be used to access a peripheral memory device just by
341 time-critical tasks (like the SPI memory operations implemented
347 tristate "Diolan DLN-2 USB SPI adapter"
354 will be called spi-dln2.
367 The external bus unit (EBU) found on the FALC-ON SoC has SPI
368 emulation that is designed for serial flash access. This driver
377 controllers.
383 This enables Freescale i.MX LPSPI controllers in master mode.
394 supports the high-level SPI memory interface.
401 controllers.
411 will be called hisi-kunpeng-spi.
430 supports the high-level SPI memory interface.
433 tristate "GPIO-based bitbanging SPI Master"
437 This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
456 tristate "Freescale i.MX SPI controllers"
459 This enables support for the Freescale i.MX SPI controllers.
468 will be called spi-ingenic.
482 persistent settings. Controllers present in modern Intel hardware
489 will be called spi-intel-pci.
499 persistent settings. Most of these controllers work in
501 exposes the low level SPI-NOR opcodes to the software. Using
508 will be called spi-intel-platform.
511 tristate "J-Core SPI Master"
514 This enables support for the SPI master controller in the J-Core
553 tristate "ICP DAS LP-8841 SPI Controller for RTC"
557 DS-1302 real time clock.
560 LP-8x4x industrial computer.
563 tristate "Freescale MPC52xx SPI (non-PSC) controller support"
597 This enables using the Freescale SPI controllers in master mode.
615 This enables using the Freescale eSPI controllers in master mode.
628 will be called spi-ljca.
647 tristate "Microchip FPGA SPI controllers"
650 This enables the SPI driver for Microchip FPGA SPI controllers.
651 Say Y or M here if you want to use the "hard" controllers on
653 If built as a module, it will be called spi-microchip-core.
656 tristate "Microchip FPGA QSPI controllers"
659 This enables the QSPI driver for Microchip FPGA QSPI controllers.
660 Say Y or M here if you want to use the QSPI controllers on
662 If built as a module, it will be called spi-microchip-core-qspi.
694 This enables support for SPI-NAND mode on the MediaTek NAND
696 is implemented as a SPI-MEM controller with pipelined ECC
708 supports the spi-mem interface.
718 supports spi-mem interface.
786 called as spi-pci1xxxx.
848 is a specialized controller used to access SPI flash on some
861 tristate "Renesas RPC-IF SPI driver"
864 SPI driver for Renesas R-Car Gen3 or RZ/G2 RPC-IF.
891 for serial peripheral interface (SPI) mini-core. SPI in master
904 yes to this option, support will be included for the built-in SPI
908 will be called spi-geni-qcom.
971 for connecting an SPI Flash memory over up to 8-bit wide bus.
972 It supports indirect access mode only.
1006 supports spi-mem interface.
1009 tristate "STMicroelectronics SPI SSC-based driver"
1034 called as spi-sunplus-sp7021.
1045 that use the de-facto standard SPI protocol.
1047 It also supports the new dual-bit and quad-bit SPI protocol.
1121 UniPhier SoCs have SCSSI and MCSSI SPI controllers.
1129 tristate "Analog Devices AD-FMCOMMS1-EBZ SPI-I2C-bridge driver"
1132 Support for the SPI-I2C bridge found on the Analog Devices
1133 AD-FMCOMMS1-EBZ board.
1192 # Add new SPI master controllers in alphabetical order above this line
1204 select one or more specific mux-controller drivers.
1248 If your system has a slave-capable SPI controller, you can enable