comedi/drivers/jr3_pci.h

70  * the full scales.
151  * coordinate transformation, or new sensor full scale is set by the
303 	 * hardware full scales to be adjusted to potentially allow
319 	 * command (10) set new full scales (pg. 38).
326 	 * Default_FS contains the full scale that is used if the user does
327 	 * not set a full scale.
341 	/* Min_full_scale is the recommend minimum full scale. */
345 	 * determine the appropriate value for setting the full scales. The
346 	 * software allows the user to set the sensor full scale to an
347 	 * arbitrary value. But setting the full scales has some hazards. If
348 	 * the full scale is set too low, the data will saturate
349 	 * prematurely, and dynamic range will be lost. If the full scale is
352 	 * maximum full scale is the maximum value at which no resolution is
353 	 * lost, and the minimum full scale is the value at which the data
359 	 * full scale selection will be a compromise between dynamic range
361 	 * of resolution which means that the recommend maximum full scale
364 	 * WARNING: Be sure that the full scale is no less than 0.4% of the
365 	 * recommended minimum full scale. Full scales below this value will
381 	 * Max_full_scale is the recommended maximum full scale.
398 	 * Full_scale is the sensor full scales which are currently in use.
400 	 * to the full scales. The engineering units used are indicated by
401 	 * the units value discussed on page 16. The full scales for Fx, Fy,
403 	 * command (10) set new full scales (pg. 38). The full scales for V1
404 	 * and V2 are set whenever the full scales are changed or when the
405 	 * axes used to calculate the vectors are changed. The full scale of
406 	 * V1 and V2 will always be equal to the largest full scale of the
479 	 * for minimums and maximums at full sensor bandwidth. This area is
485 	 * a coordinate transformation or a full scale change. Peak data is
501 	 * approximately 80% of the ADC's full scale, which is 26214, while
502 	 * sat_value defaults to the ADC's full scale:
517 	 * is 1, the rates are calculated at full sensor bandwidth. If
659 	 * units used in the sensor full scale. The meanings of particular