86 	 * fully operational, but have the danger of duplicate addresses  in btintel_check_bdaddr()
589 			/* If image type is Operational firmware (0x03), then  in btintel_parse_version_tlv()
601 			/* If image type is Operational firmware (0x03), then  in btintel_parse_version_tlv()
1129 	 * mode or is running operational firmware. The value 0x06 identifies  in btintel_download_firmware()
1130 	 * the bootloader and the value 0x23 identifies the operational  in btintel_download_firmware()
1134 	 * to bootloader when operational so the new firmware can be loaded.  in btintel_download_firmware()
1168 	 * mode or is running operational firmware. The value 0x01 identifies  in btintel_download_fw_tlv()
1169 	 * the bootloader and the value 0x03 identifies the operational  in btintel_download_fw_tlv()
1173 	 * to bootloader when operational so the new firmware can be loaded.  in btintel_download_fw_tlv()
1915 	 * is done by the operational firmware sending bootup notification.  in btintel_boot()
1917 	 * Booting into operational firmware should not take longer than  in btintel_boot()
1972 	 * mode or is running operational firmware. The value 0x06 identifies  in btintel_download_fw()
1973 	 * the bootloader and the value 0x23 identifies the operational  in btintel_download_fw()
1976 	 * When the operational firmware is already present, then only  in btintel_download_fw()
2019 	 * also be no valid address for the operational firmware.  in btintel_download_fw()
2103 	/* Before switching the device into operational mode and with that  in btintel_download_fw()
2146 	/* controller is already having an operational firmware */  in btintel_bootloader_setup()
2162 		/* Once the device is running in operational mode, it needs to  in btintel_bootloader_setup()
2221 	 * mode or is running operational firmware. The value 0x03 identifies  in btintel_prepare_fw_download_tlv()
2222 	 * the bootloader and the value 0x23 identifies the operational  in btintel_prepare_fw_download_tlv()
2225 	 * When the operational firmware is already present, then only  in btintel_prepare_fw_download_tlv()
2295 	/* Before switching the device into operational mode and with that  in btintel_prepare_fw_download_tlv()
2602 	/* check if controller is already having an operational firmware */  in btintel_bootloader_setup_tlv()
2613 	/* Once the device is running in operational mode, it needs to  in btintel_bootloader_setup_tlv()
2814 	 * to bootloader mode and are not populated in operational mode  in btintel_setup_combined()
2844 		 * the operational firmware supports both old and TLV based  in btintel_setup_combined()
3012 				/* When switching to the operational firmware  in btintel_recv_event()